SearcharxivSearch

arXiv subjects

Geonhee Oh

Publications and source records attributed to Geonhee Oh.

2 recordsLinked to original sources

Establishing the $^{40}$Ca$(p,p \alpha)$ reaction at 392 MeV under quasi-free scattering conditions

The $(p,p \alpha)$ reaction offers a direct means to probe preformed $\alpha$-cluster structures in nuclei under quasi-free scattering conditions. Previous studies around 100 MeV provided valuable insights into $\alpha$ clustering, but quantitative comparison with microscopic cluster wave functions remained limited due to strong distortion effects. At higher energies, the reaction mechanism becomes simpler and the distorted-wave impulse approximation (DWIA) provides a more reliable framework for quantitative analysis. In the present work, the $^{40}$Ca$(p,p\alpha)$ reaction was measured at an incident energy of 392 MeV using the high-resolution Grand Raiden and LAS spectrometers at RCNP. Despite the small cross section in this energy region, the achieved resolution allowed clear separation of the ground and excited states of the residual $^{36}$Ar nucleus, and corresponding momentum distributions were extracted. DWIA calculations using a Woods-Saxon $\alpha + ^{36}$Ar bound-state wave function yielded an experimental spectroscopic factor of $ S_{\mathrm{FAC}}^{\mathrm{WS}} = 0.51 \pm 0.05 $, consistent with the previous result at 101.5 MeV $(0.52 \pm 0.23 )$. This agreement demonstrates that the reaction mechanism is well described across a wide energy range. The present study establishes the feasibility of high-precision $(p,p\alpha)$ measurements at several hundred MeV and highlights their potential as a quantitative probe of $\alpha$ clustering in medium-mass nuclei, forming the basis for systematic studies in both stable and unstable systems.

nucl-ex

The Analog Front-end for the LGAD Based Precision Timing Application in CMS ETL

The analog front-end for the Low Gain Avalanche Detector (LGAD) based precision timing application in the CMS Endcap Timing Layer (ETL) has been prototyped in a 65 nm CMOS mini-ASIC named ETROC0. Serving as the very first prototype of ETL readout chip (ETROC), ETROC0 aims to study and demonstrate the performance of the analog frontend, with the goal to achieve 40 to 50 ps time resolution per hit with LGAD (therefore reach about 30ps per track with two detector-layer hits per track). ETROC0 consists of preamplifier and discriminator stages, which amplifies the LGAD signal and generates digital pulses containing time of arrival and time over threshold information. This paper will focus on the design considerations that lead to the ETROC front-end architecture choice, the key design features of the building blocks, the methodology of using the LGAD simulation data to evaluate and optimize the front-end design. The ETROC0 prototype chips have been extensively tested using charge injection and the measured performance agrees well with simulation. The initial beam test results are also presented, with time resolution of around 33 ps observed from the preamplifier waveform analysis and around 41 ps from the discriminator pulses analysis. A subset of ETROC0 chips have also been tested to a total ionizing dose of 100 MRad with X-ray and no performance degradation been observed.

physics.ins-det