arXiv subjects

Georgia M. Nixon

Publications and source records attributed to Georgia M. Nixon.

7 recordsLinked to original sources

arXiv2026

Error correction on an array of superconducting qubits with defective components

A solid-state quantum-computing architecture will require the fabrication of arrays of many coupled qubits. It is inevitable that this process will produce qubits and couplers with varying performance, with some components underperforming due to imperfect fabrication. Quantum error-correction requires high-performing components and hence these defects must be dealt with, either by adapting the code to exclude the defects, or by informing the decoder to accommodate defects in post-processing. Here we implement and compare strategies to operate distance-5 surface codes on a quantum processor consisting of a square-lattice array of 120 superconducting qubits. We demonstrate a dramatic reduction in the probability of a logical error in a memory experiment by excluding underperforming components, compared with both a standard approach of ignoring defects, and a defect-aware decoding approach. We observe up to 2.8X improvement in logical errors per round when excluding defects compared with the standard defect-ignorant approach (1.62% compared to 4.49%). In contrast, defect-aware decoding gives only modest gains. Defects are also expected to be particularly harmful for measurement-based logical operations. Using a stability experiment we show that excluding defects resurrects measurement-based logic gate performance, observing a 6.3% per-round suppression of failure rate when excluding defects, compared to zero suppression otherwise. Furthermore, we show a further substantial decrease in logical errors when using leakage post-selection in combination with our defect exclusion strategies, resulting in a distance-5 code outperforming the best distance-3 in one basis. Our experiments therefore give a proof-of-principle demonstration of the essential utility of defect exclusion methods in the scale-up of solid-state quantum computing approaches.

quant-ph↗

arXiv2026

Vine Codes: Low-Overhead Quantum LDPC Codes on a Planar Square Grid

The surface code is a promising route towards large-scale quantum computing, requiring only nearest-neighbour gates amenable to superconducting hardware. However, surface codes incur large qubit overheads. Novel quantum low-density parity check (qLDPC) codes promise to reduce overheads but require long-range connections that are difficult to achieve on superconducting platforms. Here, we introduce "Vine Codes" - qLDPC codes that are implementable on a planar square grid through nearest-neighbour, two-qubit gates native to superconducting platforms (iSWAP and CZ). Our approach generalises "Directional Codes" recently introduced by Gehér et. al. (2025) which are constrained to a torus. In contrast, vine codes have open boundary conditions constructed with the aid of routing qubits. We perform extensive numeric searches and find promising candidate vine codes, e.g. [[121,4,6]], [[221,6,7]], and [[234,9,6]] codes. We verify the circuit distances and show that data and measure qubits required can be reduced by up to ~28% relative to the surface code at a circuit distance of 7. Even including routing qubits, vine codes require fewer total qubits than the surface code (e.g. ~18% reduction at circuit distance 10) and benefits are expected to increase at higher distances. We perform circuit-level noise simulations to demonstrate that under a realistic noise model and at a near-term noise rate of $10^{-3}$, vine codes can perform better than the surface code while using fewer qubits. We give an exhaustive list of all unique vine codes up to stabiliser-weight 9. We additionally introduce "Flip-Vine Codes" which possess single-qubit transversal Clifford gates useful for fault-tolerant logic and magic state cultivation. We furthermore construct examples of generalised open boundaries for vine codes that go beyond the familiar X/Z boundaries of the surface and tile codes.

quant-ph↗

arXiv2026

Scalable quantum error correction tailored for a heavy-hex qubit array

To produce an operable quantum computer that is made with imperfect hardware, we must design and test scalable quantum error correcting codes that are suited for the devices we can build and, in unison, develop decoding strategies that accommodate device-specific noise characteristics. Here, we introduce the \emph{dynamic compass code}, a subsystem code with a novel syndrome extraction cycle, that has a competitive threshold while making efficient use of qubits arranged on a heavy-hex lattice. We use a superconducting qubit array to implement a distance-5 instance of this code, and demonstrate how detailed noise characterisation can boost decoder performance to yield significant improvements in logical error rates. We perform averaged circuit eigenvalue sampling (ACES) to acquire detailed context-dependent error information on all elements of the syndrome extraction process. Furthermore, we leverage soft information produced from measurement devices to augment the decoder with measurement error information and detect leakage errors for exclusion through post-selection. Our noise-informed approach yields up to 38.3\% improvement in the logical error rate of a distance-5 implementation of the dynamic compass code in experiment.

quant-ph↗

arXiv2026

Low-valency scalable quantum error correction with a dynamic compass code

The ongoing development of hardware that is capable of reliably executing general quantum algorithms requires quantum error-correcting codes that are both practical for realisation and rapidly reduce logical error rates as they are scaled up. Here we introduce the dynamic compass code, a code that can be implemented with a modest footprint on the heavy-hex lattice while also demonstrating a threshold. The dynamic code is obtained by choosing a novel measurement schedule for the syndrome extraction circuit of the heavy-hex subsystem code. We numerically evaluate its performance and observe that different choices of schedule can provide a trade-off in protection against logical errors in the $X$ vs $Z$ basis. We also demonstrate that this new measurement schedule provides the code with a threshold for stability experiments. We finally show how the dynamic compass code could be used for fault-tolerant logic by illustrating lattice surgery between code patches.

quant-ph↗

arXiv2025

Characterising the failure mechanisms of error-corrected quantum logic gates

Mid-circuit measurements used in quantum error correction are essential in quantum computer architecture, as they read out syndrome data and drive logic gates. Here, we use a heavy-hex code prepared on a superconducting qubit array to investigate how different noise sources impact error-corrected logic. First, we identify that idling errors occurring during readout periods are highly detrimental to a quantum memory. We demonstrate significant improvements to the memory by designing and implementing a low-depth syndrome extraction circuit. Second, we perform a stability experiment to investigate the type of failures that can occur during logic gates due to readout assignment errors. We find that the error rate of the stability experiment improves with additional stabilizer readout cycles, revealing a trade-off as additional stability comes at the expense of time over which the memory can decay. We corroborate our results using holistic device benchmarking and by comparison to numerical simulations. Finally, by varying different parameters in our simulations we identify the key noise sources that impact the fidelity of fault-tolerant logic gates, with measurement noise playing a dominant role in logical gate performance.

quant-ph↗

arXiv2024

Individually tunable tunnelling coefficients in optical lattices using local periodic driving

Ultracold atoms in optical lattices have emerged as powerful quantum simulators of translationally invariant systems with many applications in e.g.\ strongly-correlated and topological systems. However, the ability to locally tune all Hamiltonian parameters remains an outstanding goal that would enable the simulation of a wider range of quantum phenomena. Motivated by recent advances in quantum gas microscopes and optical tweezers, we here show theoretically how local control over individual tunnelling links in an optical lattice can be achieved by incorporating local time-periodic potentials. We propose to periodically modulate the on-site energy of individual lattice sites and employ Floquet theory to demonstrate how this provides full individual control over the tunnelling amplitudes in one dimension. We provide various example configurations realising interesting topological models such as extended Su-Schrieffer-Heeger models that would be challenging to realise by other means. Extending to two dimensions, we demonstrate that local periodic driving in a Lieb lattice engineers a 2D network with fully controllable tunnelling magnitudes. In a three-site plaquette, we show full simultaneous control over the relative tunnelling amplitudes and the gauge-invariant flux piercing the plaquette, providing a clear stepping stone to building a fully programmable 2D tight-binding model. We also explicitly demonstrate how utilise our technique to generate a magnetic field gradient in 2D. This local modulation scheme is applicable to many different lattice geometries.

cond-mat.quant-gas↗

arXiv2021

Correcting spanning errors with a fractal code

The strongly correlated systems we use to realise quantum error-correcting codes may give rise to high-weight, problematic errors. Encouragingly, we can expect local quantum error-correcting codes with no string-like logical operators $-$ such as the cubic code $-$ to be robust to highly correlated, one-dimensional errors that span their lattice. The challenge remains to design decoding algorithms that utilise the high distance of these codes. Here, we begin the development of such algorithms by proposing an efficient decoder for the `Fibonacci code'; a two-dimensional classical code that mimics the fractal nature of the cubic code. Our iterative decoder finds a correction through repeated use of minimum-weight perfect matching by exploiting symmetries of the code. We perform numerical experiments that show our decoder is robust to one-dimensional, correlated errors. First, using a bit-flip noise model at low error rates, we find that our decoder demonstrates a logical failure rate that scales super exponentially in the linear size of the lattice. In contrast, a decoder that could not tolerate spanning errors would not achieve this rapid decay in failure rate with increasing system size. We also find a finite threshold using a spanning noise model that introduces string-like errors that stretch along full rows and columns of the lattice. These results provide direct evidence that our decoder is robust to one-dimensional, correlated errors that span the lattice.

quant-ph↗