SearcharxivSearch

arXiv subjects

Giacomo Talmelli

Publications and source records attributed to Giacomo Talmelli.

10 recordsLinked to original sources

Frequency-Division Multiplexing in Magnonic Waveguides

Frequency-division multiplexing is a key functionality for wave-based information processing, enabling multiple information channels to coexist within the same physical medium. Here, we experimentally investigate spin-wave multiplexing in a CoFeB waveguide using all-electrical excitation and detection. Two independently generated microwave signals are simultaneously coupled into the same spin-wave waveguide through inductive antennas and characterized using broadband vector network analyzer measurements. The transmission spectra obtained under single-channel and multiplexed operation exhibit excellent agreement, demonstrating that spin waves with different frequencies and wavelengths propagate simultaneously without measurable interaction in the linear regime. The observation is confirmed using both dual-sweep and sweep-plus-single-tone excitation schemes. A theoretical analysis based on linear superposition and phase-sensitive detection explains the absence of observable inter-channel interference for independent microwave sources. Micromagnetic simulations further confirm that the amplitudes and wavevectors of the individual spin-wave modes remain unchanged during co-propagation, demonstrating the absence of interaction over the entire propagation distance. The results provide direct experimental evidence that independent spin-wave channels can coexist in a single waveguide and support the implementation of frequency-division multiplexing in future magnonic computing and microwave signal-processing architectures.

cond-mat.mes-hall

Correlation between structural and magnetic properties of epitaxial YIG films by pulsed laser deposition

In this study, we investigate the relationships between film growth conditions, crystalline microstructure, and magnetic properties of epitaxial Yttrium Iron Garnet (Y$_3$Fe$_5$O$_{12}$, YIG) thin films, deposited on Gallium Gadolinium Garnet (Ga$_3$Gd$_5$O$_{12}$, GGG). A direct correlation was observed between the residual epitaxial strain, bulk magnetic properties like saturation magnetization and magnetic damping), and the performance of spin-wave transmission devices based on these films. This correlation offers a pathway for a simplified, rapid assessment of YIG film quality, avoiding the need for complex time-consuming characterization techniques. In addition, we report a comprehensive investigation into the influence of pulsed-laser deposition parameters, including deposition temperature, pressure, laser fluence, frequency, and annealing conditions. Through systematic deposition optimization, state-of-the-art YIG films exhibiting ultralow magnetic damping could be obtained, which is critical for high-performance spintronic applications.

cond-mat.mtrl-sci

Microwave Properties of Ba-Substituted Pb(Zr$_{0.52}$Ti$_{0.48}$)O$_3$ after Chemical-Mechanical Polishing

We have studied the effect of chemical-mechanical polishing (CMP) on the ferroelectric, piezoelectric, and microwave dielectric properties of Ba-substituted PZT (BPZT), deposited by pulsed laser deposition. CMP allowed for the reduction of the root mean square surface roughness of 600 nm thick BPZT films from 12.1nm to 0.79 nm. Ammonium peroxide (SC-1) cleaning was effective to remove Si CMP residuals. Measurements of the ferroelectric hysteresis after CMP indicated that the ferroelectric properties of BPZT were only weakly affected by CMP, while the piezoelectric d33 coefficient and the microwave permittivity were reduced slightly by 10%. This can be attributed to the formation of a thin dead layer at the BPZT surface. Moreover, the intrinsic dielectric permittivity at microwave frequencies between 1 and 25 GHz was not influenced by CMP, whereas the dead layer series capacitance decreased by 10%. The results indicate that the CMP process can be used to smoothen the BPZT surface without affecting the film properties strongly.

physics.app-ph

Lumped circuit model for inductive antenna spin-wave transducers

We derive a lumped circuit model for inductive antenna spin-wave transducers in the vicinity of a ferromagnetic medium. The model considers the antenna's Ohmic resistance, its inductance, as well as the additional inductance due to the excitation of ferromagnetic resonance or spin waves in the ferromagnetic medium. As an example, the additional inductance is discussed for a wire antenna on top of a ferromagnetic waveguide, a structure that is characteristic for many magnonic devices and experiments. The model is used to assess the scaling properties and the energy efficiency of inductive antennas. Issues related to scaling antenna transducers to the nanoscale and possible solutions are also addressed.

cond-mat.mes-hall

Experimental Realization of a Passive GHz Frequency-Division Demultiplexer for Magnonic Logic Networks

The emerging field of magnonics employs spin waves and their quanta, magnons, to implement wave-based computing on the micro- and nanoscale. Multi-frequency magnon networks would allow for parallel data processing within single logic elements whereas this is not the case with conventional transistor-based electronic logic. However, a lack of experimentally proven solutions to efficiently combine and separate magnons of different frequencies has impeded the intensive use of this concept. In this Letter, the experimental realization of a spin-wave demultiplexer enabling frequency-dependent separation of magnonic signals in the GHz range is demonstrated. The device is based on two-dimensional magnon transport in the form of spin-wave beams in unpatterned magnetic films. The intrinsic frequency-dependence of the beam direction is exploited to realize a passive functioning obviating an external control and additional power consumption. This approach paves the way to magnonic multiplexing circuits enabling simultaneous information transport and processing.

cond-mat.mes-hall

Reconfigurable sub-micron spin-wave majority gate with electrical transducers

Spin waves are excitations in ferromagnetic media that have been proposed as information carriers in hybrid spintronic devices with much lower operation power than conventional charge-based electronics. Their wave nature can be exploited in majority gates by using interference for computation. However, a scalable spin-wave majority gate that can be co-integrated alongside conventional electronics is still lacking. Here, we demonstrate a sub-micron inline spin-wave majority gate with fan-out. Time-resolved imaging of the magnetization dynamics by scanning transmission x-ray microscopy illustrates the device operation. All-electrical spin-wave spectroscopy further demonstrates majority gates with sub-micron dimensions, reconfigurable input and output ports, and frequency-division multiplexing. Challenges for hybrid spintronic computing systems based on spin-wave majority gates are discussed.

physics.app-ph

First experimental demonstration of a scalable linear majority gate based on spin waves

We report on the first experimental demonstration of majority logic operation using spin waves in a scaled device with an in-line input and output layout. The device operation is based on the interference of spin waves generated and detected by inductive antennas in an all-electrical microwave circuit. We demonstrate the full truth table of a majority logic function with the ability to distinguish between strong and weak majority, as well as an inverted majority function by adjusting the operation frequency. Circuit performance projections predict low energy consumption of spin wave based compared to CMOS for large arithmetic circuits.

cond-mat.mes-hall

Electrical spin-wave spectroscopy in nanoscale waveguides with nonuniform magnetization

Spin waves modes in magnetic waveguides with width down to 320 nm have been studied by electrical propagating spin-wave spectroscopy and micromagnetic simulations for both longitudinal and transverse magnetic bias fields. For longitudinal bias fields, a 1.3 GHz wide spin-wave band was observed in agreement with analytical dispersion relations for uniform magnetization. However, transverse bias field led to several distinct bands, corresponding to different quantized width modes, with both negative and positive slopes. Micromagnetic simulations showed that, in this geometry, the magnetization was nonuniform and tilted due to the strong shape anisotropy of the waveguides. Simulations of the quantized spin-wave modes in such nonuniformly magnetized waveguides resulted in spin wave dispersion relations in good agreement with the experiments.

cond-mat.mes-hall

Magnonic band structure in vertical meander-shaped CoFeB thin films

The dispersion of spin waves in vertical meander-shaped CoFeB thin films consisting of segments located at 90° angles with respect to each other is investigated by Brillouin light scattering spectroscopy. We reveal the periodic character of several dispersive branches as well as alternating frequency ranges where spin waves are allowed or forbidden to propagate. Noteworthy is the presence of the frequency band gaps between each couple of successive modes only for wave numbers k=n$π$/a, where n is an even integer number and a is the size of the meander unit cell, whereas the spectra show propagating modes in the orthogonal film segments for the other wavenumbers. The micromagnetic simulations and analytical calculations allow us to understand and explain the results in terms of the mode spatial localization and symmetry. The obtained results demonstrate the wave propagation in three dimensions opening the path for multi-level magnonic architectures for signal processing.

physics.app-ph

Spin wave emission by spin-orbit torque antennas

We study the generation of propagating spin waves in Ta/CoFeB waveguides by spin-orbit torque antennas and compare them to conventional inductive antennas. The spin-orbit torque was generated by a transverse microwave current across the magnetic waveguide. The detected spin wave signals for an in-plane magnetization across the waveguide (Damon-Eshbach configuration) exhibited the expected phase rotation and amplitude decay upon propagation when the current spreading was taken into account. Wavevectors up to about 6 rad/$μ$m could be excited by the spin-orbit torque antennas despite the current spreading, presumably due to the non-uniformity of the microwave current. The relative magnitude of generated anti-damping spin-Hall and Oersted fields was calculated within an analytic model and it was found that they contribute approximately equally to the total effective field generated by the spin-orbit torque antenna. Due to the ellipticity of the precession in the ultrathin waveguide and the different orientation of the anti-damping spin-Hall and Oersted fields, the torque was however still dominated by the Oersted field. The prospects for obtaining a pure spin-orbit torque response are discussed, as are the energy efficiency and the scaling properties of spin-orbit torque antennas.

cond-mat.mes-hall