SearcharxivSearch

arXiv subjects

Giacomo Volpe

Publications and source records attributed to Giacomo Volpe.

4 recordsLinked to original sources

Development of a Cherenkov-Based Time-of-Flight Detector Using Silicon Photomultipliers

The aim of this work is to develop high precision Time-of-Flight (TOF) devices based on high refractive index solid Cherenkov radiators read out by silicon photomultipliers (SiPMs). Cherenkov light is prompt and therefore ideal for reaching the intrinsic timing limits of TOF systems. By utilizing a thin, high-refractive-index radiator a nearly instantaneous signal is generated by particles exceeding the Cherenkov threshold. In order to achieve the ultimate time resolution, we carried out a rigorous optimization of the radiator material and geometry, alongside the efficiency of the optical coupling to the SiPM sensors. The key factors limiting the time resolution were characterized by comprehensive Monte Carlo simulations, subsequently validated against experimental beam test data. We assembled small-scale prototypes instrumented with various Hamamatsu SiPM arrays sensors with pitches ranging from 1.3 to 3 mm coupled with various window materials, such as fused silica and MgF2, featuring various thickness values. The prototypes were successfully tested in beam test campaigns at the CERN-PS T10 beam line. The data were collected with a complete chain of front-end and readout electronics based on either the Petiroc 2A or the Radioroc 2 interfaced to a picoTDC to measure charges and times. By comparing the time measurements with two SiPM arrays we were able to measure a time resolution better than 33.2 ps at the full system level with a charged particle detection efficiency of 100%. Our results demonstrate the expected performance benchmarks for the charged particle detection efficiency and time resolution and highlight the potential of the developed Cherenkov-based TOF detectors for next-generation particle identification systems.

physics.ins-det

Supersensitive multipurpose/multifunctional avalanche gaseous detectors for environmental, hazard, intrusion systems (SMART)

The aim of this work is to develop a prototype of integrated detector system to monitor environmental hazard: appearance of flames, smoke, sparks or dangerous gases (flammable, toxic, radioactive). We built and successfully tested prototypes of all components of the system. Our sensors are based on established CERN technologies and have superior characteristics, featuring between 10 to 1000 times higher sensitivity than the best commercial sensors. The final version of our device would consist of multifunctional sensors assembled in a single unit; each sensor will perform a specific task and deliver information to a common computing centre via cellular or satellite phone protocols.

physics.ins-det

Systematic studies and optimization of super sensitivity gaseous detectors of sparks, open flames and smoke

A review of the current progress in developments and tests of supersensitive gaseous detectors of open flame, sparks and smoke is given. A focus on the latest developments is on flat panel type sensors. This design, after further modification, will allow building not only a high efficiency detector but also offers UV imaging capability for flame visualization and several other applications. These studies were done in the framework of ATTRACT-SMART project.

physics.ins-det

Results from cosmics and first LHC beam with the ALICE HMPID detector

The ALICE HMPID (High Momentum Particle IDentification) detector has been designed to identify charged pions and kaons in the range 1 < p < 3 GeV/c and protons in the range 1.5 < p < 5 GeV/c. It consists of seven identical proximity focusing RICH (Ring Imaging Cherenkov) counters, covering in total 11 m2, which exploit large area MWPC equipped with CsI photocathodes for Cherenkov light imaging emitted in a liquid C6F14 radiator. The ALICE detector has been widely commissioned using cosmics and LHC beam from December 2007 until October 2008. During the cosmics data taking the HMPID detector collected a large set of data, using mainly the trigger provided by the TOF detector. We present here preliminary results of detector alignment using TPC tracking. The HMPID could be operated in a stable way, at a safe HV setting, also during LHC beam injection and circulation tests, when a very large occupancy (up to 50%) was achieved. Resulting gain mapping and overall detector performance will also be discussed.

physics.ins-det