SearcharxivSearch

arXiv subjects

Guilhem Almuneau

Publications and source records attributed to Guilhem Almuneau.

4 recordsLinked to original sources

Electrically-pumped near-infrared VCSEL epitaxially-grown on Si

The monolithic integration of compact laser sources onto silicon remains a critical bottleneck for the scalable development of silicon photonics. In particular, the direct epitaxial growth of near-infrared vertical-cavity surface-emitting lasers (VCSELs) on silicon has long been hindered by the simultaneous requirements of low crystalline defect density in the active region and smooth interfaces in the distributed Bragg reflector (DBR) mirrors, both essential to achieving high cavity quality factors and low lasing thresholds. Here, we report the direct epitaxial integration of near-infrared VCSELs on silicon substrates using a two-step growth strategy specifically designed to suppress defect propagation while preserving mirror interface abruptness. This approach enables effective confinement of threading dislocations away from the active region and ensures high-reflectivity DBRs with excellent structural uniformity. Structural and optical characterizations reveal an epitaxial stack of high crystalline quality, leading to laser performance comparable to VCSELs commonly grown on GaAs substrates. We demonstrate, for the first time, directly grown VCSELs on silicon wafers exhibiting threshold currents of only a few milliamperes. These results establish a decisive proof of concept for the monolithic integration of good-performance VCSELs onto silicon platforms and open a viable pathway toward fully integrated, low-cost silicon-based photonic systems.

physics.optics

940-nm VCSELs grown by molecular beam epitaxy on Ge(001)

Vertical-cavity surface-emitting laser (VCSEL) structures emitting near 940 nm were grown by solid source molecular beam epitaxy (MBE) on Ge(001) substrates. The VCSEL MBE-growth was realized upon a virtual substrate composed of GaAs on Ge grown by melatorganic vapour phase epitaxy (MOVPE). In situ monitoring during MBE growth employed multispectral reflectometry and magnification-inferred curvature imaging for real-time growth analysis. Curvature measurements revealed progressive compressive stress, while optical reflectivity data confirmed uniform layer growth and accurate stopband formation. Fabricated devices with mesa diameters of 35-40 $μ$m, corresponding to oxide apertures of approximately 11-16 $μ$m, exhibited room-temperature lasing under continuous-wave bias with threshold currents below 3 mA. To the best of our knowledge, this is the first demonstration of monolithically integrated 940 nm VCSELs grown on Ge substrates by MBE. These results confirm the viability of MBE-grown VCSELs on Ge with in situ process control for scalable optoelectronic integration.

cond-mat.mtrl-sci

Optical refractive index measurements of AlGaAs at high temperature for fully automated molecular beam epitaxy growth of Bragg mirrors

In-situ measurement is a key feature to better understand and precisely control the growth of complex structures, such as vertical-cavity surface-emitting lasers. In this work, we are showing the precise measurement of optical indices of AlGaAs at 600 {\textdegree}C over a wide spectral range (450--1400 nm). To do so, in-situ spectral reflectance measurement is used, combined with ex-situ layer thickness and composition measurement by x-ray diffraction enabling for precise determination of the optical indices with an accuracy better than 1%. To validate our measurements, we realized the complete automation of the growth of a GaAs/AlAs 940 nm-DBR by molecular beam epitaxy, without the need to pre-calibrate cells fluxes. The fabricated DBR shows a deviation of 0.2 nm of the stop-band central-wavelength compared to the targeted one. This approach holds significant interest for the III--V semiconductor community and epitaxial growth techniques.

cond-mat.mtrl-sci

Numerical analysis of high-index nanocomposite encapsulant for light-emitting diodes

We used two-dimensional Finte-Difference-Time-Domain (FDTD) software to study the transition behavior of nano-particles from scatterers to an optically uniform medium. We measured the transmission efficiency of the dipole source, which is located in the high refractive index medium(index=2.00) and encapsulated by low index resin(index=1.41). In an effort to compose index-matched resin and to reduce internal reflection, high-index nano-particles are added to low-index resin in simulations of various sizes and densities. As the size of the nano-particles and the average spacing between particles are reduced to 0.02 lambda and 0.07 lambda respectively, the transmission efficiency improves two-fold compared to that without nanoparticles. The numerical results can be used to understand the optical behavior of nano-particles and to improve the extraction efficiency of high brightness light-emitting-diodes(LEDs), through the use of nano-composite encapsulant.

physics.optics