arXiv subjects

Guillaume F. Nataf

Publications and source records attributed to Guillaume F. Nataf.

12 recordsLinked to original sources

arXiv2026

Tunable electrocaloric effect in lead scandium tantalate through calcium doping

State-of-the-art electrocaloric cooling prototypes rely on the conventional electrocaloric effect of ferroelectric lead scandium tantalate (PbSc0.5Ta0.5O3, PST), which peaks near room temperature. Here, we demonstrate that A-site calcium doping in highly ordered PST modifies its phase transitions and enables precise tuning of the electrocaloric response. The transition temperature shifts down to 258 K and up to 319 K, depending on Ca concentration. Calorimetry under electric field, electrical polarization loops, and piezoresponse force microscopy reveal the emergence of an intermediate antiferroelectric phase stabilized for Ca $\geq$ 2\%. These results are supported by first-principles calculations. We observe a conventional electrocaloric effect for Ca $\leq$ 2\% and an inverse electrocaloric effect at higher doping ($\geq$ 2\%). Under an applied field of 110 kV cm$^{-1}$, Ca-doped PST exhibits an adiabatic temperature change of 2 K over a range from 263 K to 353 K. Such Ca-doped PST compounds could be used to expand the temperature range of PST below the freezing point of water. Our results offer a pathway to cascaded electrocaloric cooling devices with extended operating spans.

cond-mat.mtrl-sci↗

arXiv2025

Domain-wall driven suppression of thermal conductivity in a ferroelectric polycrystal

A common strategy for reducing thermal conductivity of polycrystalline systems is to increase the number of grain boundaries. Indeed, grain boundaries enhance the probability of phonon scattering events, which has been applied to control the thermal transport in a wide range of materials, including hard metals, diamond, oxides and 2D systems such as graphene. Here, we report the opposite behavior in improper ferroelectric ErMnO3 polycrystals, where the thermal conductivity decreases with increasing grain size. We attribute this unusual relationship between heat transport and microstructure to phonon scattering at ferroelectric domain walls. The domain walls are more densely packed in larger grains, leading to an inversion of the classical grain-boundary-dominated transport behavior. Our findings open additional avenues for microstructural engineering of materials for thermoelectric and thermal management applications, enabling simultaneous control over mechanical, electronic, and thermal properties.

cond-mat.mtrl-sci↗

arXiv2024

Enhancement of piezoelectric properties in a narrow cerium doping range of $\text{Ba}_{1-x}\text{Ca}_{x}\text{Ti}_{1-y}\text{Zr}_{y}\text{O}_{3}$ evidenced by high throughput experiment

Lead-free materials based on the $\text{(Ba,Ca)(Zr,Ti)O}_{3}$ (BCZT) system exhibit excellent electromechanical properties that can be strongly modified by small amounts of dopants. Here, we use a high throughput strategy to unravel the influence of aliovalent doping with Ce on dielectric and piezoelectric properties of BCTZ. We synthesize and characterize a single BCTZ thin film with a composition gradient from undoped to 0.2 mol % cerium doping. The cerium doping increases the piezoelectric coefficient from $42.3\pm 2.9 \text{pm V}^{-1}$ (undoped) to $63\pm 2.4 \text{pm V}^{-1}$ for 0.06 Ce-mol\%, and then decreases to $38.4 \pm 1.3 \text{pm V}^{-1}$ for the maximum amount of cerium (0.2 mol %). An investigation of sub-coercive field non-linearities reveal that these variations are not only induced by changes in dynamics and densities of domain walls. The results highlight the advantage of high throughput techniques to identify ideal compositions for applications, without synthesizing a high number of samples with unavoidable sample-to-sample variations.

cond-mat.mtrl-sci↗

arXiv2024

Lead-free room-temperature ferroelectric thermal conductivity switch using anisotropies in thermal conductivities

Materials with on-demand control of thermal conductivity are the prerequisites to build thermal conductivity switches, where the thermal conductivity can be turned ON and OFF. However, the ideal switch, while required to develop novel approaches to solid-state refrigeration, energy harvesting, and even phononic circuits, is still missing. It should consist of an active material only, be environment friendly, and operate near room temperature with a reversible, fast, and large switching ratio. Here, we first predict by ab initio electronic structure calculations that ferroelectric domains in barium titanate exhibit anisotropic thermal conductivities. We confirm this prediction by combining frequency-domain thermoreflectance and scanning thermal microscopy measurements on a single crystal of barium titanate. We then use this gained knowledge to propose a lead-free thermal conductivity switch without inactive material, operating reversibly with an electric field. At room temperature, we find a switching ratio of 1.6 $\pm$ 0.3, exceeding the performances of state-of-the-art materials suggested for thermal conductivity switches.

cond-mat.mtrl-sci↗

arXiv2024

Using oxides to compute with heat

One of the most innovative possibilities offered by oxides is the use of heat currents for computational purposes. Towards this goal, phase-change oxides, including ferroelectrics, ferromagnets and related materials, could reproduce sources, logic units and memories used in current and future computing schemes.

physics.app-ph↗

arXiv2024

Subcoercive-field dielectric response of $0.5(\text{Ba}_{0.7}\text{Ca}_{0.3}\text{TiO}_{3})-0.5(\text{BaZr}_{0.2}\text{Ti}_{0.8}\text{O}_{3})$ thin film: peculiar third harmonic signature of phase transitions and residual ferroelectricity

Sub-coercive field non-linearities in $0.5(\text{Ba}_{0.7}\text{Ca}_{0.3}\text{TiO}_{3})-0.5(\text{BaZr}_{0.2}\text{Ti}_{0.8}\text{O}_{3})$ (BCTZ 50/50) thin film elaborated using pulsed laser deposition are studied using permittivity and phase angle of the third harmonic measurements as function of the AC measuring field $E_{\mathit{AC}}$ and temperature. The global phase transition temperature $T_{\mathit{max}}$ for which the permittivity is maximum, decreases from 330 K to 260 K when $E_{\mathit{AC}}$ increases. Rayleigh analysis of the AC field dependence of the relative permittivity shows a regular decrease of the domain wall motion contributions as temperature increases up to $T_{\mathit{max}}$ and an even more pronounced decrease above $T_{\mathit{max}}$. This measurement reveals that the ferroelectric behavior subsists 70 K above the global phase transition. The phase angle of the third harmonic at temperatures below 275 K, is characteristic of a conventional ferroelectric and from 275 K to $T_{\mathit{max}}=$ 330 K of a relaxor. Above $T_{\mathit{max}}$, the thin film exhibits a peculiar phase angle of the third harmonic, which consists of ${-180}°\rightarrow {-225}°\rightarrow {+45}° \rightarrow {0}°$ instead of the ${-180}°\rightarrow {-90}° \rightarrow {0}°$ found for relaxor. This peculiar behavior is observed only on heating, and is tentatively attributed to changes in the correlations between polar nanoregions.

cond-mat.mtrl-sci↗

arXiv2023

Influence of cation vacancy concentrations on ultra-low thermal conductivity in $(1-x)$BiVO$_4$-$x$Bi$_{2/3}$MoO$_4$ scheelite solid solutions

Bismuth vanadate - bismuth molybdate solid-solution was prepared to elaborate ceramics with different amounts of cation vacancies. Dense ceramics with similar microstructures were obtained and the evolution of their melting point, specific heat, thermal diffusivity, and conductivity as a function of the amount of vacancy was evaluated. At room temperature, the thermal conductivity decreases from 1.74 W m$^{-1}$ K$^{-1}$ for BiVO$_{4}$ (x=0) to 1.12 W m$^{-1}$ K$^{-1}$ for Bi$_{0.867}$$\square$$_{0.133}$Mo$_{0.4}$V$_{0.6}$O$_{4}$ (x=0.4). Moreover, we show that a very small amount of vacancy (1.7%, x=0.05) is enough to provide a large decrease in thermal conductivity by more than 15%, in agreement with a mass fluctuation scattering model. However, the temperature of the melting point also decreases with increasing amount of vacancy. Our results suggest adding only a very small amount of vacancy as the best strategy to obtain superior materials for thermal barriers and thermoelectric devices, with ultra-low thermal conductivity and high-temperature stability.

cond-mat.mtrl-sci↗

arXiv2023

Ultra-low lattice thermal conductivity in tungsten-based scheelite ceramics

$BaWO_{4}$, $Ce_{2/3}\square_{1/3}WO_{4}$ and $La_{2/3}\square_{1/3}WO_{4}$ polycrystalline ceramics were synthesized by conventional solid-state reaction route. The effect of cation-deficiency on the crystallographic structure, microstructure and thermal properties of these scheelite-type compounds were investigated. X-ray diffraction was used to identify the single-phase scheelite structure of the studied ceramics. Scanning Electron Microscopy technique has revealed a homogenous and dense microstructure with a few micro-cracks. The thermal conductivity of $BaWO_{4}$ scheelite decreases from $1.3\pm0.2$ to $1.0\pm0.1 W m^{-1} K^{-1}$ in the range 373 K - 673 K. The cation-deficient scheelites $Ce_{2/3}\square_{1/3}WO_{4}$ and $La_{2/3}\square_{1/3}WO_{4}$ ceramics display an ultra-low thermal conductivity of $0.3\pm0.04 W m^{-1} K^{-1}$ and $0.2\pm0.03 W m^{-1} K^{-1}$ at 673 K, respectively. These materials exhibit among the lowest known values of thermal conductivity in crystalline oxides, in this temperature range. Therefore, they appear as very attractive for thermal barrier coating and thermoelectric applications.

cond-mat.mtrl-sci↗

arXiv2020

Suppression of acoustic emission during superelastic tensile cycling of polycrystalline Ni$_{50.4}$Ti$_{49.6}$

We investigate acoustic emission (AE) that arises during the martensitic transition in a polycrystalline specimen of the prototypical superelastic/elastocaloric alloy Ni$_{50.4}$Ti$_{49.6}$ (at. %) driven using tensile strain. We use two independent AE sensors in order to locate AE events, and focus on contributions to the AE that arise away from the grips of the mechanical testing machine. Significant AE activity is present during the first mechanical loading primarily due to nucleation and growth of wide Lüders-like bands during the forward martensitic transition (imaged using visible light and infrared (IR) radiation) that lead to persistent changes in intergranular interactions. AE activity is suppressed during the subsequent reverse martensitic transition on unloading, and in successive loading/unloading cycles, for which the Lüders-like bands narrow and modify intergranular interactions to much less extent. After the first loading, we find that the AE activity associated with the martensitic transition is weak, and we suggest that this is because the elastic anisotropy and strain incompatibility in Ni-Ti are low. We also find that the AE activity becomes weaker on mechanically cycling due to increased retained martensite.

cond-mat.mtrl-sci↗

arXiv2018

Raman signatures of ferroic domain walls captured by principal component analysis

Ferroic domain walls are currently investigated by several state-of-the art techniques in order to get a better understanding of their distinct, functional properties. Here, Principal Component Analysis (PCA) of Raman maps is used to study ferroelectric domain walls (DWs) in LiNbO3 and ferroelastic DWs in NdGaO3. It is shown that PCA allows to quickly and reliably identify small Raman peak variations at ferroelectric DWs and that the value of a peak shift can be deduced - accurately and without a-priori - from a first order Taylor expansion of the spectra. The ability of PCA to separate the contribution of ferroelastic domains and DWs to Raman spectra is emphasized. More generally, our results provide a novel route for the statistical analysis of any property mapped across a DW.

cond-mat.mtrl-sci↗

arXiv2018

Experimental evidence of accelerated seismic release without critical failure in acoustic emissions of compressed nanoporous materials

The total energy of acoustic emission (AE) events in externally stressed materials diverges when approaching macroscopic failure. Numerical and conceptual models explain this accelerated seismic release (ASR) as the approach to a critical point that coincides with ultimate failure. Here, we report ASR during soft uniaxial compression of three silica-based (SiO$_2$) nanoporous materials. Instead of a singular critical point, the distribution of AE energies is stationary and variations in the activity rate are sufficient to explain the presence of multiple periods of ASR leading to distinct brittle failure events. We propose that critical failure is suppressed in the AE statistics by dissipation and transient hardening. Some of the critical exponents estimated from the experiments are compatible with mean field models, while others are still open to interpretation in terms of the solution of frictional and fracture avalanche models.

cond-mat.mtrl-sci↗

arXiv2018

Evolution of defect signatures at ferroelectric domain walls in Mg-doped LiNbO3

The domain structure of uniaxial ferroelectric lithium niobate single crystals is investigated using Raman spectroscopy mapping. The influence of doping with magnesium and poling at room temperature is studied by analysing frequency shifts at domain walls and their variations with dopant concentration and annealing conditions. It is shown that defects are stabilized at domain walls and that changes in the defect structures with Mg concentration can be probed by the shift of Raman modes. We show that the signatures of polar defects in the bulk and at the domain walls differ.

cond-mat.mtrl-sci↗