arXiv subjects

Guo-Jun Qiao

Publications and source records attributed to Guo-Jun Qiao.

5 recordsLinked to original sources

arXiv2019

5 GHz TMRT observations of 71 pulsars

We present integrated pulse profiles at 5~GHz for 71 pulsars, including eight millisecond pulsars (MSPs), obtained using the Shanghai Tian Ma Radio Telescope (TMRT). Mean flux densities and pulse widths are measured. For 19 normal pulsars and one MSP, these are the first detections at 5~GHz and for a further 19, including five MPSs, the profiles have a better signal-to-noise ratio than previous observations. Mean flux density spectra between 400~MHz and 9~GHz are presented for 27 pulsars and correlations of power-law spectral index are found with characteristic age, radio pseudo-luminosity and spin-down luminosity. Mode changing was detected in five pulsars. The separation between the main pulse and interpulse is shown to be frequency independent for six pulsars but a frequency dependence of the relative intensity of the main pulse and interpulse is found. The frequency dependence of component separations is investigated for 20 pulsars and three groups are found: in seven cases the separation between the outmost leading and trailing components decreases with frequency, roughly in agreement with radius-to-frequency mapping; in eleven cases the separation is nearly constant; in the remain two cases the separation between the outmost components increases with frequency. We obtain the correlations of pulse widths with pulsar period and estimate the core widths of 23 multi-component profiles and conal widths of 17 multi-component profiles at 5.0~GHz using Gaussian fitting and discuss the width-period relationship at 5~GHz compared with the results at at 1.0~GHz and 8.6~GHz.

astro-ph.HE↗

arXiv2017

TMRT observations of 26 pulsars at 8.6 GHz

Integrated pulse profiles at 8.6~GHz obtained with the Shanghai Tian Ma Radio Telescope (TMRT) are presented for a sample of 26 pulsars. Mean flux densities and pulse width parameters of these pulsars are estimated. For eleven pulsars these are the first high-frequency observations and for a further four, our observations have a better signal-to-noise ratio than previous observations. For one (PSR J0742-2822) the 8.6~GHz profiles differs from previously observed profiles. A comparison of 19 profiles with those at other frequencies shows that in nine cases the separation between the outmost leading and trailing components decreases with frequency, roughly in agreement with radius-to-frequency mapping, whereas in the other ten the separation is nearly constant. Different spectral indices of profile components lead to the variation of integrated pulse profile shapes with frequency. In seven pulsars with multi-component profiles, the spectral indices of the central components are steeper than those of the outer components. For the 12 pulsars with multi-component profiles in the high-frequency sample, we estimate the core width using gaussian fitting and discuss the width-period relationship.

astro-ph.HE↗

arXiv2016

Multi-frequency Radio Profiles of PSR B1133+16: radiation location and particle energy

The pulse profile of PSR B1133+16 is usually regarded as a conal-double structure. However, its multifrequency profiles cannot simply be fitted with two Gaussian functions, and a third component is always needed to fit the bridge region (between two peaks). This would introduce additional, redundant parameters. In this paper, through a comparison of five fitting functions (Gaussian, von Mises, hyperbolic secant, square hyperbolic secant, and Lorentz), it is found that the square hyperbolic secant function can best reproduce the profile, yielding an improved fit. Moreover, a symmetric 2D radiation beam function, instead of a simple 1D Gaussian function, is used to fit the profile. Each profile with either well-resolved or not-so-well-resolved peaks could be fitted adequately using this beam function, and the bridge emission between the two peaks does not need to be a new component. Adopting inclination and impact angles based on polarization measurements, the opening angle (θ_μ0) of the radiation beam in a certain frequency band is derived from beam-function fitting. The corresponding radiation altitudes are then calculated. Based on multi-frequency profiles, we also computed the Lorentz factors of the particles and their dispersion at those locations in both the curvature-radiation (CR) and inverse-Compton-scattering (ICS) models. We found that the Lorentz factors of the particles decrease rapidly as the radiation altitude increases. Besides, the radiation prefers to be generated in annular region rather than core region, and this needs further validation.

astro-ph.HE↗

arXiv2005

Monopole-charged pulsars and relevant issues

The aligned pulsars whose rotation axes and magnetic dipole axes are parallel should be positively charged. The total charge of pulsars is calculated after considering the electromagnetic field in and out the star under a specific condition. The statistical relation between the pulsar's rotation energy loss rate (or the period derivative) and the period may hint that the millisecond radio pulsars with small periods could be low-mass bare strange stars.

astro-ph↗

arXiv2005

The Current Flows in Pulsar Magnetospheres

The global structure of the current flows in pulsar magnetospheres is investigated, with rough calculations of the elements in the magnetospheric circuit. It is emphasized that the potential of critical field lines is the same as that of interstellar medium, and that the pulsars whose rotation axes and magnetic dipole axes are parallel should be positively charged, in order to close the pulsar's current flows. The statistical relation between the radio luminosity and pulsar's electric charge (or the spindown power) may hint that the millisecond pulsars could be low-mass bare strange stars.

astro-ph↗