arXiv subjects

Guoying Zhang

Publications and source records attributed to Guoying Zhang.

8 recordsLinked to original sources

arXiv2026

Intelligent Reflecting Surface Deployment for Low-Altitude Coverage: Illumination Geometry, Directional Characteristics, and Optimization

Terrestrial base stations (BSs) are typically configured with fixed downtilt to serve ground users, resulting in weak illumination of low-altitude airspace even under line-of-sight (LoS) propagation. In this paper, we establish a channel model that incorporates BS and intelligent reflecting surface (IRS) radiation patterns for three-dimensional (3D) low-altitude coverage while preserving the existing BS configuration. We formulate a budget-constrained IRS deployment problem that jointly determines candidate-site selection, IRS orientations, and phase shifts to maximize the worst-case signal-to-noise ratio (SNR) over the 3D low-altitude airspace. The selected sites and optimized IRS parameters remain fixed after deployment, yielding a quasi-static IRS configuration. We characterize the illumination geometry between the fixed-downtilt BS and rooftop candidates by deriving the nonnegative installation-height range satisfying the BS main-lobe condition. The separation between the mapped main-lobe height boundaries grows linearly with horizontal BS-to-site distance and decreases inversely with the number of BS antennas. We further derive an analytical lower bound on the regional worst-case normalized array gain achievable through IRS phase design over served directions with different direction spans. The resulting sufficient direction span decreases inversely with the square root of the number of IRS elements when the same worst-case normalized gain guarantee is maintained. We develop a mixed-integer alternating optimization (AO) algorithm to solve the resulting problem. Simulation results validate the analytical characterizations and show that the proposed scheme achieves higher worst-case SNR than benchmarks across different deployment budgets.

cs.IT↗

arXiv2026

Multi-User MIMO with Rotatable Antennas and IRS: Joint Antenna Boresight and IRS Orientation Design

In this paper, we investigate an intelligent reflecting surface (IRS)-assisted multi-user system, where the base station (BS) employs rotatable antennas (RAs) and the IRS can adjust the panel orientation.To alleviate the severe multiplicative path loss of the cascaded channel, the IRS is deployed near the BS, while the user-BS and user-IRS links remain in the far field. We formulate a sum-rate maximization problem by jointly optimizing the receive beamforming, IRS phase shifts, BS antenna boresights, and IRS panel orientation. To tackle the resulting highly coupled and non-convex problem, we first study a single-user case to reveal the structure of the dual-rotation gain, which is shown to be multiplicatively separable in the far field but coupled in the near field. For the general multi-user case, we develop an alternating optimization algorithm, where the receive beamforming is updated in closed form, the IRS phase shifts are optimized by an FP-assisted Riemannian conjugate gradient method, and the BS antenna boresights and IRS panel orientation are updated via projected gradient methods. Simulation results demonstrate the significant sum-rate gains achieved by the proposed coordinated rotation design over fixed-orientation and single-rotation benchmark schemes, and provide useful insights into near-field dual-rotation design.

cs.IT↗

arXiv2026

URMF: Uncertainty-aware Robust Multimodal Fusion for Multimodal Sarcasm Detection

Multimodal sarcasm detection (MSD) aims to identify sarcastic intent from semantic incongruity between text and image. Although recent methods have improved MSD through cross-modal interaction and incongruity reasoning, most still treat modalities as equally reliable. In real social media posts, however, text and images often differ in noise level and relevance, making deterministic fusion susceptible to noisy evidence and weakened incongruity cues. To address this issue, we propose Uncertainty-aware Robust Multimodal Fusion (URMF), a unified framework for robust MSD. URMF first injects visual evidence into textual representations through multi-head cross-attention, and then applies self-attention in the fused semantic space to enhance incongruity reasoning. It models textual, visual, and interaction-aware representations as learnable Gaussian posteriors to estimate modality-specific uncertainty. Based on the estimated uncertainty, URMF dynamically adjusts modality contributions during fusion to suppress unreliable evidence. We further optimize the model with a unified objective that combines information bottleneck regularization, modality prior regularization, cross-modal distribution alignment, and uncertainty-driven contrastive learning. Experiments on the public MSD and MMSD2 benchmarks show that URMF outperforms representative unimodal, multimodal, and MLLM-based baselines. The results demonstrate that explicit uncertainty modeling can improve both accuracy and robustness in multimodal sarcasm detection.

cs.CV↗

arXiv2026

Joint Antenna Rotation and IRS Beamforming for Multi-User Uplink Communications

Rotatable antenna (RA) enhances wireless coverage through directional gain steering, yet suffers from performance degradation under physical blockages. Intelligent reflecting surface (IRS) establishes reflective paths to bypass obstacles, but suffers from angular mismatch when deployed in the side-lobe region of base station (BS) antennas. To address this issue, we propose a new RA-enabled IRS-assisted multi-user uplink system, in which the BS antennas are capable of flexibly adjusting their 3D orientations to align their boresights with the IRS. We formulate a sum rate maximization problem by jointly optimizing the antenna 3D rotations, receive beamforming and IRS phase shifts. To tackle this non-convex problem, we propose an efficient alternating optimization (AO) algorithm. Specifically, we iteratively update the antenna rotations via projected gradient ascent (PGA), compute the receive beamforming via a closed-form solution, and optimize the IRS phase shifts via fractional programming (FP). Numerical results demonstrate that the proposed system yields significant performance gains over conventional fixed-antenna systems, especially under large angular misalignments.

cs.IT↗

arXiv2026

Wireless Communication with Cross-Linked Rotatable Antenna Array: Architecture Design and Rotation Optimization

Rotatable antenna (RA) technology can harness additional spatial degrees of freedom by enabling the dynamic three-dimensional orientation control of each antenna. Unfortunately, the hardware cost and control complexity of traditional RA systems is proportional to the number of RAs. To address the issue, we consider a cross-linked (CL) RA structure, which enables the coordinated rotation of multiple antennas, thereby offering a cost-effective solution. To evaluate the performance of the CL-RA array, we investigate a CL-RA-aided uplink system. Specifically, we first establish system models for both antenna element-level and antenna panel-level rotation. Then, we formulate a sum rate maximization problem by jointly optimizing the receive beamforming at the base station and the rotation angles. For the antenna element-level rotation, we derive the optimal solution of the CL-RA array under the single-user case. Subsequently, for two rotation schemes, we propose an alternating optimization algorithm to solve the formulated problem in the multi-user case, where the receive beamforming and the antenna rotation angles are obtained by applying the minimum mean square error method and feasible direction method, respectively. In addition, considering the hardware limitations, we apply the genetic algorithm to address the discrete rotation angles selection problem. Simulation results show that by carefully designing the row-column partition scheme, the performance of the CL-RA architecture is quite close to that of the flexible antenna orientation scheme. Moreover, the CL antenna element-level scheme surpasses the CL antenna panel-level scheme by 25% and delivers a 128% performance improvement over conventional fixed-direction antennas.

cs.IT↗

arXiv2025

Entanglement manifestation of knot topology in a non-Hermitian lattice

Although the homotopy-knot theory has been utilized to implement effective topological classification for non-Hermitian systems, the physical implications underlying distinct knot topologies remain ambiguous and are rarely addressed. In this work, we propose a one-dimensional non-Hermitian four-band lattice model and map out its phase diagram according to the distinct knot structures residing in the moment space. The topological phase diagram is ascertained through a spectral winding number. Furthermore, we derive the exact analytic formula for the phase boundaries that delineate different knot topologies. To explore the concrete physical implications of distinct knot topologies, we investigate the many-body ground state entanglement entropy for free fermions loaded on such non-Hermitian lattice in real space. It turns out that different knot topologies imply different magnitudes of entanglement. Moreover, we show that the central charge c extracted from systematic finite-size scaling of entanglement entropy provides effective description of the phase diagram of the knot topology. Finally, we further confirm the phase boundaries for the topological phase transitions alternatively by numerical calculations of the many-body ground state fidelity susceptibility. Our results showcase the connection between knot topology and entanglement of non-Hermitian systems and may facilitate further exploration of the profound and practical physical implications of knot topology.

quant-ph↗

arXiv2024

V2I-Calib: A Novel Calibration Approach for Collaborative Vehicle and Infrastructure LiDAR Systems

Cooperative LiDAR systems integrating vehicles and road infrastructure, termed V2I calibration, exhibit substantial potential, yet their deployment encounters numerous challenges. A pivotal aspect of ensuring data accuracy and consistency across such systems involves the calibration of LiDAR units across heterogeneous vehicular and infrastructural endpoints. This necessitates the development of calibration methods that are both real-time and robust, particularly those that can ensure robust performance in urban canyon scenarios without relying on initial positioning values. Accordingly, this paper introduces a novel approach to V2I calibration, leveraging spatial association information among perceived objects. Central to this method is the innovative Overall Intersection over Union (oIoU) metric, which quantifies the correlation between targets identified by vehicle and infrastructure systems, thereby facilitating the real-time monitoring of calibration results. Our approach involves identifying common targets within the perception results of vehicle and infrastructure LiDAR systems through the construction of an affinity matrix. These common targets then form the basis for the calculation and optimization of extrinsic parameters. Comparative and ablation studies conducted using the DAIR-V2X dataset substantiate the superiority of our approach. For further insights and resources, our project repository is accessible at https://github.com/MassimoQu/v2i-calib.

cs.CV↗

arXiv2024

Efficient Multi-scale Network with Learnable Discrete Wavelet Transform for Blind Motion Deblurring

Coarse-to-fine schemes are widely used in traditional single-image motion deblur; however, in the context of deep learning, existing multi-scale algorithms not only require the use of complex modules for feature fusion of low-scale RGB images and deep semantics, but also manually generate low-resolution pairs of images that do not have sufficient confidence. In this work, we propose a multi-scale network based on single-input and multiple-outputs(SIMO) for motion deblurring. This simplifies the complexity of algorithms based on a coarse-to-fine scheme. To alleviate restoration defects impacting detail information brought about by using a multi-scale architecture, we combine the characteristics of real-world blurring trajectories with a learnable wavelet transform module to focus on the directional continuity and frequency features of the step-by-step transitions between blurred images to sharp images. In conclusion, we propose a multi-scale network with a learnable discrete wavelet transform (MLWNet), which exhibits state-of-the-art performance on multiple real-world deblurred datasets, in terms of both subjective and objective quality as well as computational efficiency.

cs.CV↗