arXiv subjects

H. -G. Meyer

Publications and source records attributed to H. -G. Meyer.

At least 19 recordsLinked to original sources

arXiv2017

A new family of field-stable and highly sensitive SQUID current sensors based on sub-micrometer cross-type Josephson junctions

We report on the development of a new family of SQUID current sensors based on sub-micron cross-type Josephson tunnel junctions. Their low total junction capacitance permit high usable voltage swings of more than 100 μV and exceptional low noise of the SQUIDs at 4.2 K. Integrated rf-filter as well as high tolerable background fields during cool-down of up to 9.6 mT enable their highly reliable and easy use. With input coil inductances ranging from 10 nH to 2.8 μH and current sensitivities and coupled energy resolution down to 65 fA/Hz^{1/2} and below 10 h, respectively, they are a versatile tool for numerous applications.

cond-mat.supr-con↗

arXiv2017

Nearly quantum limited nanoSQUIDs based on cross-type Nb/AlOx/Nb junctions

We report on the development of nearly quantum limited SQUIDs with miniature pickup loop dimensions. The implemented high quality and low capacitance cross-type Nb/AlOx/Nb Josephson junctions offer large $I_CR_N$-products and therefore enable an exceptional low noise level of the SQUIDs. Devices with loop dimensions of 1 μm exhibit white flux noise levels as low as $45 nΦ_0/Hz^{1/2}$ corresponding to an energy resolution ε of about 1 h at 4.2 K, with h being Plancks constant. Moreover, the large usable voltage swings of the devices of about 300 μV allow highly sensitive and easy single-stage operation while exploring nearly the intrinsic noise of the SQUIDs, beneficial e.g. for sensor arrays in SQUID microscopy.

cond-mat.supr-con↗

arXiv2017

Thin-film based ultralow noise SQUID magnetometer

We report on the development of an ultralow noise thin-film based SQUID magnetometer. A niobium thin-film pickup coil is connected to the input coil of a SQUID current sensor. The low capacitance of the used sub-micrometer cross-type Josephson junctions enable superior noise performance of the device. Application scenarios e.g. in geophysics and ultra-low field magnetic resonance imaging are discussed.

physics.ins-det↗

arXiv2015

Investigation of all niobium Nano-SQUIDs based on sub-micrometer cross-type Josephson junctions

We report on the development of highly sensitive SQUIDs featuring sub-micrometer loop dimensions. The integration of high quality and low capacitance SIS Nb/AlOx/Nb cross-type Josephson tunnel junctions results in white flux noise levels as low as 66 n$Φ_0$/Hz$^{ 1/2} $, well below state-of-the-art values of their Nb-based counterparts based on constriction type junctions. Estimation of the spin sensitivity of the best SQUIDs yield $S_μ^{ 1/2} < 7 μ_B$/Hz$^{ 1/2} $ in the white noise region, suitable for the investigation of small spin systems. We discuss fabrication challenges, show results on the electrical characterization of devices with various pickup loops, and describe options for further improvement, which may push the sensitivity of such devices even to single spin resolution.

cond-mat.supr-con↗

arXiv2013

Parametric amplification by coupled flux qubits

We report the parametric amplification of a microwave signal in a Kerr medium formed from superconducting qubits. Two mutually coupled flux qubits, embedded in the current antinode of a superconducting coplanar waveguide resonator, are used as a nonlinear element. Shared Josephson junctions provide the qubit-resonator coupling, resulting in a device with a measured gain of about 20 dB. We argue, that this arrangement represents a unit cell which can be straightforwardly extended to a quasi one-dimensional quantum metamaterial with a large tunable Kerr nonlinearity.

cond-mat.supr-con↗

arXiv2012

Dressed-state amplification by a superconducting qubit

We demonstrate amplification of a microwave signal by a strongly driven two-level system in a coplanar waveguide resonator. The effect known from optics as dressed-state lasing is observed with a single quantum system formed by a persistent current (flux) qubit. The transmission through the resonator is enhanced when the Rabi frequency of the driven qubit is tuned into resonance with one of the resonator modes. Amplification as well as linewidth narrowing of a weak probe signal has been observed. The laser emission at the resonator's fundamental mode has been studied by measuring the emission spectrum. We analyzed our system and found an excellent agreement between the experimental results and the theoretical predictions obtained in the dressed-state model.

cond-mat.supr-con↗

arXiv2010

Weak continuous monitoring of a flux qubit using coplanar waveguide resonator

We study a flux qubit in a coplanar waveguide resonator by measuring transmission through the system. In our system with the flux qubit decoupled galvanically from the resonator, the intermediate coupling regime is achieved. In this regime dispersive readout is possible with weak backaction on the qubit. The detailed theoretical analysis and simulations give a good agreement with the experimental data and allow to make the qubit characterization.

cond-mat.supr-con↗

arXiv2009

Multiphoton excitations and inverse population in two-flux-qubit system

We study spectroscopy of artificial solid-state four-level quantum system. This system is formed by two coupled superconducting flux qubits. When multiple driving frequency of the applied microwaves matches the energy difference between any two levels, the transition to the upper level is induced. We demonstrate two types of the multi-photon transitions: direct transitions between two levels and ladder-type transitions via an intermediate level. For the latter transitions, in particular, the inverse population of the excited state with respect to the ground one is realized. These processes can be useful for the control of the level population for the multilevel scalable quantum systems.

cond-mat.supr-con↗

arXiv2009

Losses in coplanar waveguide resonators at millikelvin temperatures

We study the loss rate for a set of lambda/2 coplanar waveguide resonators at millikelvin temperatures (20 mK - 900mK) and different applied powers (3E-19 W - 1E-12 W). The loss rate becomes power independent below a critical power. For a fixed power, the loss rate increases significantly with decreasing temperature. We show that this behavior can be caused by two-level systems in the surrounding dielectric materials. Interestingly, the influence of the two-level systems is of the same order of magnitude for the different material combinations. That leads to the assumption that the nature of these two-level systems is material independent.

cond-mat.supr-con↗

arXiv2009

Voltage-current and voltage-flux characteristics of asymmetric high TC DC SQUIDs

We report measurements of transfer functions and flux shifts of 20 on-chip high T$_C$ DC SQUIDs half of which were made purposely geometrically asymmetric. All of these SQUIDs were fabricated using standard high T$_C$ thin film technology and they were single layer ones, having 140 nm thickness of YBa$_2$Cu$_3$O$_{7-x}$ film deposited by laser ablation onto MgO bicrystal substrates with 24$^0$ misorientation angle. For every SQUID the parameters of its intrinsic asymmetry, i. e., the density of critical current and resistivity of every junction, were measured directly and independently. We showed that the main reason for the on-chip spreading of SQUIDs' voltage-current and voltage-flux characteristics was the intrinsic asymmetry. We found that for SQUIDs with a relative large inductance ($L>120 $ pH) both the voltage modulation and the transfer function were not very sensitive to the junctions asymmetry, whereas SQUIDs with smaller inductance ($L\simeq 65-75 $ pH) were more sensitive. The results obtained in the paper are important for the implementation in the sensitive instruments based on high T$_C$ SQUID arrays and gratings.

cond-mat.supr-con↗

arXiv2008

Resonant excitations of single and two-qubit systems coupled to a tank circuit

The interaction of flux qubits with a low frequency tank circuit is studied. It is shown that changes in the state of the interacting qubits influence the effective impedance of the circuit, which is the essence of the so-called impedance measurement technique. The multiphoton resonant excitations in both single flux qubits and pairs of coupled flux qubits are investigated. In particular, we compare our theoretical results with recent spectroscopy measurements, Landau-Zener interferometry, and multiphoton fringes.

cond-mat.supr-con↗

arXiv2008

Consistency of ground state and spectroscopic measurements on flux qubits

We compare the results of ground state and spectroscopic measurements carried out on superconducting flux qubits which are effective two-level quantum systems. For a single qubit and for two coupled qubits we show excellent agreement between the parameters of the pseudospin Hamiltonian found using both methods. We argue, that by making use of the ground state measurements the Hamiltonian of N coupled flux qubits can be reconstructed as well at temperatures smaller than the energy level separation. Such a reconstruction of a many-qubit Hamiltonian can be useful for future quantum information processing devices.

cond-mat.supr-con↗

arXiv2008

Sisyphus cooling and amplification by a superconducting qubit

Laser cooling of the atomic motion paved the way for remarkable achievements in the fields of quantum optics and atomic physics, including Bose-Einstein condensation and the trapping of atoms in optical lattices. More recently superconducting qubits were shown to act as artificial two-level atoms, displaying Rabi oscillations, Ramsey fringes, and further quantum effects. Coupling such qubits to resonators brought the superconducting circuits into the realm of quantum electrodynamics (circuit QED). It opened the perspective to use superconducting qubits as micro-coolers or to create a population inversion in the qubit to induce lasing behavior of the resonator. Furthering these analogies between quantum optical and superconducting systems we demonstrate here Sisyphus cooling of a low frequency LC oscillator coupled to a near-resonantly driven superconducting qubit. In the quantum optics setup the mechanical degrees of freedom of an atom are cooled by laser driving the atom's electronic degrees of freedom. Here the roles of the two degrees of freedom are played by the LC circuit and the qubit's levels, respectively. We also demonstrate the counterpart of the Sisyphus cooling, namely Sisyphus amplification. Parallel to the experimental demonstration we analyze the system theoretically and find quantitative agreement, which supports the interpretation and allows us to estimate system parameters.

cond-mat.supr-con↗

arXiv2007

Controllable coupling of superconducting flux qubits

We have realized controllable coupling between two three-junction flux qubits by inserting an additional coupler loop between them, containing three Josephson junctions. Two of these are shared with the qubit loops, providing strong qubit--coupler interaction. The third junction gives the coupler a nontrivial current--flux relation; its derivative (i.e., the susceptibility) determines the coupling strength J, which thus is tunable in situ via the coupler's flux bias. In the qubit regime, J was varied from ~45 (antiferromagnetic) to ~ -55 mK (ferromagnetic); in particular, J vanishes for an intermediate coupler bias. Measurements on a second sample illuminate the relation between two-qubit tunable coupling and three-qubit behavior.

cond-mat.supr-con↗

arXiv2007

Realization of a classical counterpart of a scalable design for adiabatic quantum computation

We implement a classical counterpart of a scalable design for adiabatic quantum computation. The key element of this design is a coupler providing controllable coupling between two bistable elements (in our case superconducting rings with a single Josephson junction playing the role of a classical counterpart of superconducting flux qubits) The coupler is also a superconducting ring with a single Josephson junction that operates in the non-hysteretic mode. The flux coupling between two bistable rings can be controlled by changing the magnetic flux through the coupler. Thereby, the coupling can be tuned from ferromagnetic trough zero to to anti-ferromagnetic.

cond-mat.supr-con↗

arXiv2007

Adiabatic quantum computation with flux qubits, first experimental results

Controllable adiabatic evolution of a multi-qubit system can be used for adiabatic quantum computation (AQC). This evolution ends at a configuration where the Hamiltonian of the system encodes the solution of the problem to be solved. As a first steps towards realization of AQC we have investigated two, three and four flux qubit systems. These systems were characterized by making use of a radio-frequency method. We designed two-qubit systems with coupling energies up to several kelvins. For the three-flux-qubit systems we determined the complete ground-state flux diagram in the three dimensional flux space around the qubits common degeneracy point. We show that the system`s Hamiltonian can be completely reconstructed from our measurements. Our concept for the implementation of AQC, by making use of flux qubits, is discussed.

cond-mat.supr-con↗

arXiv2006

Measurement of the ground-state flux diagram of three coupled qubits as a first step towards the demonstration of adiabatic quantum computation

The ground state susceptibility of a system consisting of three flux-qubits was measured in the complete three dimensional flux space around the common degeneracy point of the qubits. The system's Hamiltonian could be completely reconstructed from measurements made far away from the common degeneracy point. The subsequent measurements made around this point show complete agreement with the theoretical predictions which follow from this Hamiltonian. The ground state anti-crossings of the system could be read-out directly from these measurements. This allows one to determine the ground-state flux diagram, which provides the solution for the non-polynomial optimization problem MAXCUT encoded in the Hamiltonian of the three-flux-qubit system. Our results show that adiabatic quantum computation can be demonstrated with this system provided that the energy gap and/or the speed of the read-out is increased.

cond-mat.supr-con↗

arXiv2006

Four-qubit device with mixed couplings

We present the first experimental results on a device with more than two superconducting qubits. The circuit consists of four three-junction flux qubits, with simultaneous ferro- and antiferromagnetic coupling implemented using shared Josephson junctions. Its response, which is dominated by the ground state, is characterized using low-frequency impedance measurement with a superconducting tank circuit coupled to the qubits. The results are found to be in excellent agreement with the quantum-mechanical predictions.

cond-mat.supr-con↗