arXiv subjects

H. G. Zaunick

Publications and source records attributed to H. G. Zaunick.

4 recordsLinked to original sources

arXiv2026

Tunable Light Scattering in Cast Organic Scintillators via BaSO$_4$ Nanoparticle Doping: A Short Summary

We summarize the fabrication and optical characterization of small-format (2 x 2 x 2 cm$^3$) cast organic scintillators based on Eljen EJ-290 resin, doped with barium sulfate (BaSO$_4$) powder at mass fractions from 0 % to 5 %. The goal is to tune the scattering length of the scintillator largely independently of its absorption and light output, so that scintillation light is localized on a controllable spatial scale matched to the fiber pitch of wavelength-shifting (WLS) fiber read-out. The scattering length is found to decrease from 6.05(8) cm at 1 % to 0.83(1) cm at 5 %, while the absolute light yield falls by only about 15 %. These results are a first proof of concept that the photon-transport scale in cast scintillators can be engineered on purpose, enabling position-sensitive scintillator tiles for fiber-readout sampling calorimeters and large-area muon trackers. Full details are given in the accompanying paper.

physics.ins-det↗

arXiv2023

Wavelength-shifter coated polystyrene as an easy-to-build and low-cost plastic scintillator detector

We studied the light yield of a pure polystyrene slide coated with wavelength-shifter molecules, coupled to a photomultiplier, using beta particles from a 90-Sr source, as a possible easy-to-build, low-cost plastic scintillator detector. Comparison measurements were performed with an uncoated polystyrene slide as well as with uncoated and coated PMMA slides, the latter which can only produce Cherenkov light when being traversed by charged particles. The results with the single (double) coated polystyrene slides show about 4.9 (6.3) times higher detected photon yield compared to the uncoated slide. For comparison, the light yield of a polystyrene-based extruded plastic scintillator material doped with PTP and POPOP was measured as well. The absolute detected light yield motivates future studies for developing easy-to-build, low-cost polystyrene-based plastic scintillator detectors.

physics.ins-det↗

arXiv2012

Technical Design Report for the: PANDA Straw Tube Tracker

This document describes the technical layout and the expected performance of the Straw Tube Tracker (STT), the main tracking detector of the PANDA target spectrometer. The STT encloses a Micro-Vertex-Detector (MVD) for the inner tracking and is followed in beam direction by a set of GEM-stations. The tasks of the STT are the measurement of the particle momentum from the reconstructed trajectory and the measurement of the specific energy-loss for a particle identification. Dedicated simulations with full analysis studies of certain proton-antiproton reactions, identified as being benchmark tests for the whole PANDA scientific program, have been performed to test the STT layout and performance. The results are presented, and the time lines to construct the STT are described.

physics.ins-det↗

arXiv2010

The PANDA GEM-based TPC Prototype

We report on the development of a GEM-based TPC prototype for the PANDA experiment. The design and requirements of this device will be illustrated, with particular emphasis on the properties of the recently tested GEM-detector, the characterization of the read-out electronics and the development of the tracking software that allows to evaluate the GEM-TPC data.

nucl-ex↗