Searcharxiv⌕ Search

arXiv subjects

H. J. Hyun

Publications and source records attributed to H. J. Hyun.

81 records · Page 5Linked to original sources

Measurement of CP violating asymmetries in B^0 -> K^+K^- K^0_S decays with a time-dependent Dalitz approach

We report a measurement of $CP$ violating asymmetries in $B^0(\overline{B}^0) \to K^+ K^- K^0_S$ decays with a time-dependent Dalitz approach. This analysis is based on a data sample of $657\times 10^6$ $B\overline{B}$ pairs accumulated at the $Υ(4S)$ resonance with the Belle detector at the KEKB asymmetric-energy $e^+e^-$ collider. As the result of an unbinned maximum likelihood fit to the selected candidates, the mixing-induced and direct $CP$ violation parameters, $ϕ^{\rm eff}_1$ and ${\cal A}_{CP}$ are obtained for $B^0 \to ϕ(1020) K^0_S$, $B^0 \to f_0(980) K^0_S$ and other $B^0 \to K^+ K^- K^0_S$ decays. We find four solutions that describe the data. There are \{eqnarray*} ϕ_1^{\rm eff}(B^0\to ϕ(1020) K^0_S) & = & (32.2 \pm 9.0 \pm 2.6 \pm 1.4)^{\circ}; ϕ_1^{\rm eff}(B^0\to ϕ(1020) K^0_S) & = & (26.2 \pm 8.8 \pm 2.7 \pm 1.2)^{\circ};\\ ϕ_1^{\rm eff}(B^0\to ϕ(1020) K^0_S) & = & (27.3 \pm 8.6 \pm 2.8 \pm 1.3)^{\circ}\; {\rm and}\\ ϕ_1^{\rm eff}(B^0\to ϕ(1020) K^0_S) & = & (24.3 \pm 8.0 \pm 2.9 \pm 5.2)^{\circ}.{eqnarray*}\ The values for the $CP$ violating phase in $B^0\to ϕ(1020) K^0_S$ are similar but other properties of the Dalitz plot are quite different for the four solutions. These four solutions have consistent $ϕ^{\rm eff}_1$ values for all three $B$ meson decay channels and none of them deviates significantly from the values measured in $B \to (c\bar{c}) K^0$ decays with the currently available statistics. In addition, we find no significant direct $CP$ violation.

hep-ex↗

First Measurement of Inclusive B -> X_s eta Decays

We report a first measurement of inclusive B -> X_s eta decays, where X_s is a charmless state with unit strangeness. The measurement is based on a pseudo-inclusive reconstruction technique and uses a sample of 657 x 10^6 BB-bar pairs accumulated with the Belle detector at the KEKB e^+e^- collider. For M_{X_s} < 2.6 GeV/c^2, we measure a branching fraction of (26.1 +/- 3.0 (stat) +1.9 -2.1 (syst) +4.0 -7.1 (model)) x 10^-5 and a direct CP asymmetry of A_{CP} = -0.13 +/- 0.04 +0.02 -0.03. Over half of the signal occurs in the range M_{X_s} > 1.8 GeV/c^2.

hep-ex↗

Search for a Low Mass Particle Decaying into mu^+ mu^- in B0-> K*0 X and B0-> rho0 X at Belle

We search for dimuon decays of a low mass particle in the decays B0->K*0 X and B0->rho X using a data sample of 657x10^6 B Bbar events collected with the Belle detector at the KEKB asymmetric-energy e^+ e^- collider. We find no evidence for such a particle in the mass range from 212 MeV/c2 to 300 MeV/c2, and set upper limits on its branching fractions. In particular, we search for a particle with a mass of 214.3 MeV/c2 reported by the HyperCP experiment, and obtain upper limits on the products B(B0->K*0 X)xB(X->mu^+ mu^-) < 2.26 (2.27)x10^-8 and B(B0->rho0 X)xB(X->mu^+ mu^-) < 1.73 (1.73)x10^-8 at 90% C.L. for a scalar (vector) X particle.

hep-ex↗

Energy cross-calibration from the first CREAM flight: transition radiation detector versus calorimeter

The Cosmic Ray Energetics And Mass (CREAM) balloon experiment had two successful flights in 2004/05 and 2005/06. It was designed to perform energy measurements from a few GeV up to 1000 TeV, taking advantage of different detection techniques. The first instrument, CREAM-1, combined a transition radiation detector with a calorimeter to provide independent energy measurements of cosmicraynuclei. Each detector was calibrated with particle beams in a limited range of energies. In order to assess the absolute energy scale of the instrument and to investigate the systematic effects of each technique, a cross-calibration was performed by comparing the two independent energy estimates on selected samples of oxygen and carbon nuclei.

astro-ph.IM↗

Performance of the CREAM calorimeter in accelerator beam test

The CREAM calorimeter, designed to measure the spectra of cosmic-ray nuclei from under 1 TeV to 1000 TeV, is a 20 radiation length (X0) deep sampling calorimeter. The calorimeter is comprised of 20 layers of tungsten interleaved with 20 layers of scintillating fiber ribbons, and is preceded by a pair of graphite interaction targets providing about 0.42 proton interaction lengths (λint). The calorimeter was placed in one of CERN's SPS accelerator beams for calibration and testing. Beams of 150 GeV electrons were used for calibration, and a variety of electron, proton, and nuclear fragment beams were used to test the simulation model of the detector. In this paper we discuss the performance of the calorimeter in the electron beam and compare electron beam data with simulation results.

astro-ph.HE↗

Measurements of cosmic-ray secondary nuclei at high energies with the first flight of the CREAM balloon-borne experiment

We present new measurements of heavy cosmic-ray nuclei at high energies per- formed during the first flight of the balloon-borne cosmic-ray experiment CREAM (Cosmic-Ray Energetics And Mass). This instrument uses multiple charge detectors and a transition radiation detector to provide the first high accuracy measurements of the relative abundances of elements from boron to oxygen up to energies around 1 TeV/n. The data agree with previous measurements at lower energies and show a relatively steep decline (~E$^-0.6$ to E$^-0.5$) at high energies. They further show the source abundance of nitrogen relative to oxygen is ~10% in the TeV/n region.

astro-ph↗

Fabrication of Analog Electronics for Serial Readout of Silicon Strip Sensors

A set of analog electronics boards for serial readout of silicon strip sensors was fabricated. A commercially available amplifier is mounted on a homemade hybrid board in order to receive analog signals from silicon strip sensors. Also, another homemade circuit board is fabricated in order to translate amplifier control signals into a suitable format and to provide bias voltage to the amplifier as well as to the silicon sensors. We discuss technical details of the fabrication process and performance of the circuit boards we developed.

physics.ins-det↗