SearcharxivSearch

arXiv subjects

H. Naganuma

Publications and source records attributed to H. Naganuma.

5 recordsLinked to original sources

Characterization of Spin-Transfer-Torque effect induced magnetization dynamics driven by short current pulses

We present a time-resolved study of the magnetization dynamics in a microstructured Cr$|$Heusler$|$Pt waveguide driven by the Spin-Hall-Effect and the Spin-Transfer-Torque effect via short current pulses. In particular, we focus on the determination of the threshold current at which the spin-wave damping is compensated. We have developed a novel method based on the temporal evolution of the magnon density at the beginning of an applied current pulse at which the magnon density deviates from the thermal level. Since this method does not depend on the signal-to-noise ratio, it allows for a robust and reliable determination of the threshold current which is important for the characterization of any future application based on the Spin-Transfer-Torque effect.

cond-mat.mes-hall

Spin-Wave versus Joule Heating in Spin-Hall-Effect/Spin-Transfer-Torque Driven Cr/Heusler/Pt Waveguides

We present a time-resolved study of the DC-current driven magnetization dynamics in a microstructured Cr/Heusler/Pt waveguide by means of Brillouin light scattering. A reduction of the effective spin-wave damping via the spin-transfer-torque effect leads to a strong increase in the magnon density. This is accompanied by a decrease of the spin-wave frequencies. By evaluating the time scales of these effects, the origin of this frequency shift can be identified. However, recently, we found that the experimental setup partially influences the decay of the spin-wave intensity after the current pulse is switched off. Thus, further investigations on the presented effect are needed to allow for a more detailed analysis. For this reason, we need to withdraw the manuscript at this point and might publish an updated version later.

cond-mat.mes-hall

Tuning up or down the critical thickness in LaAlO3/SrTiO3 through in situ deposition of metal overlayers

The quasi 2D electron system (q2DES) that forms at the interface between LaAlO3 and SrTiO3 has attracted much attention from the oxide electronics community. One of its hallmark features is the existence of a critical LaAlO3 thickness of 4 unit-cells (uc) for interfacial conductivity to emerge. In this paper, the chemical, electronic, and transport properties of LaAlO3/SrTiO3 samples capped with different metals grown in a system combining pulsed laser deposition, sputtering, and in situ X-ray photoemission spectroscopy are investigated. The results show that for metals with low work function a q2DES forms at 1-2 uc of LaAlO3 and is accompanied by a partial oxidation of the metal, a phenomenon that affects the q2DES properties and triggers the formation of defects. In contrast, for noble metals, the critical thickness is increased above 4 uc. The results are discussed in terms of a hybrid mechanism that incorporates electrostatic and chemical effects.

cond-mat.mtrl-sci

Highly efficient and tuneable spin-to-charge conversion through Rashba coupling at oxide interfaces

The spin-orbit interaction couples the electrons' motion to their spin. Accordingly, passing a current in a material with strong spin-orbit coupling generates a transverse spin current (spin Hall effect, SHE) and vice-versa (inverse spin Hall effect, ISHE). The emergence of SHE and ISHE as charge-to-spin interconversion mechanisms offers a variety of novel spintronics functionalities and devices, some of which do not require any ferromagnetic material. However, the interconversion efficiency of SHE and ISHE (spin Hall angle) is a bulk property that rarely exceeds ten percent, and does not take advantage of interfacial and low-dimensional effects otherwise ubiquitous in spintronics hetero- and mesostructures. Here, we make use of an interface-driven spin-orbit coupling mechanism - the Rashba effect - in the oxide two-dimensional electron system (2DES) LaAlO3/SrTiO3 to achieve spin-to-charge conversion with unprecedented efficiency. Through spin-pumping, we inject a spin current from a NiFe film into the oxide 2DES and detect the resulting charge current, which can be strongly modulated by a gate voltage. We discuss the amplitude of the effect and its gate dependence on the basis of the electronic structure of the 2DES.

cond-mat.mtrl-sci

Nonlinear emission of spin-wave caustics from an edge mode of a micro-structured Co2Mn0.6Fe0.4Si waveguide

Magnetic Heusler materials with very low Gilbert damping are expected to show novel magnonic transport phenomena. We report nonlinear generation of higher harmonics leading to the emission of caustic spin-wave beams in a low-damping, micro-structured Co2Mn0.6Fe0.4Si Heusler waveguide. The source for the higher harmonic generation is a localized edge mode formed by the strongly inhomogeneous field distribution at the edges of the spin-wave waveguide. The radiation characteristics of the propagating caustic waves observed at twice and three times the excitation frequency are described by an analytical calculation based on the anisotropic dispersion of spin waves in a magnetic thin film.

cond-mat.mes-hall