arXiv subjects

H. Ogino

Publications and source records attributed to H. Ogino.

9 recordsLinked to original sources

arXiv2019

Coupled Magnetic and Superconducting Transitions in Sr$_{2}$VO$_{3}$FeAs Under Pressure

We report muon spin rotation ($μ$SR) and magnetization measurements on superconducting Sr$_{2}$VO$_{3}$FeAs under pressure. At ambient pressure, Sr$_{2}$VO$_{3}$FeAs undergoes an antiferromagnetic transition of the V moments at $T_{N}$ and becomes superconducting at $T_{c}<T_{N}$. As a function of pressure, $T_{N}$ initially decreases while $T_{c}$ increases. Surprisingly, once $T_{N}\approx T_{c}$ at 0.6~GPa, $T_{N}$ reverses its trend and increases together with $T_{c}$ suggesting that the static V magnetism is a prerequisite for superconductivity. We explain this cooperative coupling by a possible localization of the V 3$d$ states below the magnetic transition which enables the nesting of the Fermi surface necessary for superconductivity.

cond-mat.supr-con↗

arXiv2013

Transition Temperature and Upper Critical Field in SmFeAsO1-xFx Synthesized at Low Heating Temperatures

Low-temperature synthesis is a promising and potentially effective method for improving superconducting properties. We report on the fabrication of polycrystalline samples of SmFeAsO1-xFx with nominal x content varying in a wide range of x = 0-0.35 synthesized at 900 deg C. This synthesis temperature is around 300 deg C lower than the conventional synthesis temperature. The variation in the lattice parameters and transition temperature (Tc) of various F-doped samples indicates that reduction of the unit cell volume (V) seems to be the main reason for the rise of Tc up to 57.8 K. Magnetoresistance measurements showed that the upper critical field slope (dHc2/dT) increased with increasing F concentration up to x = 0.2, where it reached a maximum value of -8 T/K corresponding to a coherence length of 10 angstrom. At still higher F doping levels, dHc2/dT and the low field Jc decreased; above 0.5 T, however, Jc had almost the same value. Compared with previous reports, the present synthesis route with low synthesis temperatures and commonly available FeF2 as the source of F is more effective at introducing F into the SmFeAsO system and thereby resulting in improved superconducting properties for the system. In addition, this new sample preparation method also reduces unnecessary problems such as the evaporation of F and reaction between the crucible and superconductor during the solid-state reaction.

cond-mat.supr-con↗

arXiv2012

NMR Investigation of the iron-based superconductors Ca4(Mg,Ti)3Fe2As2O8-y and Ca5(Sc,Ti)4Fe2As2O11-y

$^{75}$As and $^{45}$Sc NMR measurements unravel the electronic state for Fe-based superconductors with perovskite-type blocking layers Ca$_4$(Mg,Ti)$_3$Fe$_2$As$_2$O$_{8-y}$ ($T_c^{onset}=47$ K) and Ca$_5$(Sc,Ti)$_4$Fe$_2$As$_2$O$_{11-y}$ ($T_c^{onset}=41$ K). In Ca$_5$(Sc,Ti)$_4$Fe$_2$As$_2$O$_{11-y}$, the nuclear spin relaxation rate $1/T_1$ shows pseudogap behavior below $\sim80$ K, suggesting that the electronic state is similar to that of LaFeAs(O,F) system with moderate electron doping. The presence of the pseudogap behavior gives an interpretation that the hole-like band (so-called $γ$ pocket) is located just below the Fermi level from the analogy to LaFeAs(O,F) system and the disappearance of the $γ$ pocket yields the suppression of the low-energy spin fluctuations. On the other hand, in Ca$_4$(Mg,Ti)$_3$Fe$_2$As$_2$O$_{8-y}$ satisfying the structural optimal condition for higher $T_c$ among the perovskite systems, the extrinsic contribution, which presumably originates in the Ti moment, is observed in $1/T_1T$; however, the moderate temperature dependence of $1/T_1T$ appears by its suppression under high magnetic field. In both systems, the high $T_c$ of $\sim40$ K is realized in the absence of the strong development of the low-energy spin fluctuations. The present results reveal that the structural optimization does not induce the strong development of the low-energy spin fluctuations. If we consider that superconductivity is mediated by spin fluctuations, the structural optimization is conjectured to provide a benefit to the development of the high-energy spin fluctuations irrespective to the low-energy part.

cond-mat.supr-con↗

arXiv2012

Towards the Realization of Higher Connectivity in MgB2 Conductors: In-situ or Sintered Ex-situ?

The two most common types of MgB2 conductor fabrication technique - in-situ and ex-situ - show increasing conflicts concerning the connectivity, an effective current-carrying cross-sectional area. An in-situ reaction yields a strong intergrain coupling with a low packing factor, while an ex-situ process using pre-reacted MgB2 yields tightly packed grains, however, their coupling is much weaker. We studied the normal-state resistivity and microstructure of ex-situ MgB2 bulks synthesized with varied heating conditions under ambient pressure. The samples heated at moderately high temperatures of ~900°C for a long period showed an increased packing factor, a larger intergrain contact area and a significantly decreased resistivity, all of which indicate the solid-state self-sintering of MgB2. Consequently the connectivity of the sintered ex-situ samples exceeded the typical connectivity range 5-15% of the in-situ samples. Our results show self-sintering develops the superior connectivity potential of ex-situ MgB2, though its intergrain coupling is not yet fulfilled, to provide a strong possibility of twice or even much higher connectivity in optimally sintered ex-situ MgB2 than in in-situ MgB2.

cond-mat.supr-con↗

arXiv2011

Successive transition from superconducting to antiferromagnetic phase in (Ca_6(Al, Ti)_4O_y)Fe_2As_2 studied via ^{75}As and ^{27}Al NMR

An unusual successive phase transition from superconducting (SC) to antiferromagnetic (AF) phases was discovered via ^{75}As and ^{27}Al nuclear magnetic resonance (NMR) in (Fe_2As_2)(Ca_6(Al, Ti)_4O_y) with four (Al, Ti)O layers intercalated between FeAs planes. Although the spatially-uniform AF ordering is clearly visible from ^{27}Al spectra, the ordered moments are very small and the low-frequency fluctuation is much suppressed, contrary to existing pnictides with localized magnetic elements. Furthermore, the temperature (T) dependence of the fluctuation at both nuclei is very similar throughout the entire temperature range. These facts suggest that some hybridization between Ti and Fe orbitals induces a uniform electronic state within FeAs and (Al, Ti)O layers accompanied by the SC and AF transitions. The iron-based pnictide with Ti-doped blocking layers is the first high-T_c compound having metallic blocking layers.

cond-mat.supr-con↗

arXiv2010

Structural Features of Layered Iron Pnictide Oxides (Fe2As2)(Sr4M2O6)

Structural features of newly found perovskite-based iron pnictide oxide system have been systematically studied. Compared to REFePnO system, perovskite-based system tend to have lower Pn-Fe-Pn angle and higher pnictogen height owing to low electronegativity of alkaline earth metal and small repulsive force between pnictogen and oxygen atoms. As-Fe-As angles of (Fe2As2)(Sr4Cr2O6), (Fe2As2)(Sr4V2O6) and (Fe2Pn2)(Sr4MgTiO6) are close to ideal tetrahedron and those pnictogen heights of about 1.40 A are close to NdFeAsO with optimized carrier concentration. These structural features of this system may leads to realization of high Tc superconductivity.

cond-mat.supr-con↗

arXiv2009

Evidence for Nodal superconductivity in Sr$_{2}$ScFePO$_{3}$

Point contact Andreev reflection spectra have been taken as a function of temperature and magnetic field on the polycrystalline form of the newly discovered iron-based superconductor Sr2ScFePO3. A zero bias conductance peak which disappears at the superconducting transition temperature, dominates all of the spectra. Data taken in high magnetic fields show that this feature survives until 7T at 2K and a flattening of the feature is observed in some contacts. Here we inspect whether these observations can be interpreted within a d-wave, or nodal order parameter framework which would be consistent with the recent theoretical model where the height of the P in the Fe-P-Fe plane is key to the symmetry of the superconductivity. However, in polycrystalline samples care must be taken when examining Andreev spectra to eliminate or take into account artefacts associated with the possible effects of Josephson junctions and random alignment of grains.

cond-mat.supr-con↗

arXiv2009

Contrasting Pressure Effects in Sr2VFeAsO3 and Sr2ScFePO3

We report the resistivity measurements under pressure of two Fe-based superconductors with a thick perovskite oxide layer, Sr2VFeAsO3 and Sr2ScFePO3. The superconducting transition temperature Tc of Sr2VFeAsO3 markedly increases with increasing pressure. Its onset value, which was Tc{onset}=36.4 K at ambient pressure, increases to Tc{onset}=46.0 K at ~4 GPa, ensuring the potential of the "21113" system as a high-Tc material. However, the superconductivity of Sr2ScFePO3 is strongly suppressed under pressure. The Tc{onset} of ~16 K decreases to ~5 K at ~4 GPa, and the zero-resistance state is almost lost. We discuss the factor that induces this contrasting pressure effect.

cond-mat.supr-con↗

arXiv2009

Superconductivity at 17 K in (Fe2P2)(Sr4Sc2O6): a new superconducting layered pnictide oxide with a thick perovskite oxide layer

A new layered oxypnictide (Fe2P2)(Sr4Sc2O6) have been synthesized by solid-state reaction. This material has an alternating layer stacking structure of anti-fluorite Fe2P2 and perovskite-based Sr4Sc2O6 oxide layers. Space group of the material is P4/nmm and lattice constants a and c are 4.016 A and 15.543 A, respectively. The interlayer Fe-Fe distance corresponding to the c-axis length is the longest ever reported in the iron-based oxypnictide systems. In both magnetization and resistivity measurements, the present compound exhibited superconductivity below 17 K, which is much higher than that of LaFePO and the highest in arsenic-free iron-based oxypnictide systems under ambient pressure.

cond-mat.supr-con↗