arXiv subjects

H. Wenzel

Publications and source records attributed to H. Wenzel.

5 recordsLinked to original sources

arXiv2025

Laser intracavity absorption magnetometry for optical quantum sensing

Intracavity absorption spectroscopy (ICAS) is a well-established technique for detecting weak absorption signals with ultrahigh sensitivity. Here, we extend this concept to magnetometry using nitrogen-vacancy (NV) centers in diamond. We introduce laser intracavity absorption magnetometry (LICAM), a concept that is in principle applicable to a broader class of optical quantum sensors, including optically pumped magnetometers. Using an electrically driven, edge-emitting diode laser that operates self-sustainably, we show that LICAM enables highly sensitive magnetometers operating under ambient conditions. Near the lasing threshold, we achieve a 475-fold enhancement in optical contrast and a 180-fold improvement in magnetic sensitivity compared with a conventional single-pass geometry. The experimental results are accurately described by a rate-equation model for single-mode diode lasers. From our measurements, we determine a projected shot-noise-limited sensitivity in the $\mathrm{pT}\,\mathrm{Hz}^{-1/2}$ range and simulate that, with realistic device improvements, shot-noise limited sensitivities down to the $\mathrm{fT}\,\mathrm{Hz}^{-1/2}$ scale are attainable.

quant-ph↗

arXiv2021

Measurement of the ($\pi^-$, Ar) total hadronic cross section at the LArIAT experiment

We present the first measurement of the negative pion total hadronic cross section on argon, which we performed at the Liquid Argon In A Testbeam (LArIAT) experiment. All hadronic reaction channels, as well as hadronic elastic interactions with scattering angle greater than 5~degrees are included. The pions have a kinetic energies in the range 100-700~MeV and are produced by a beam of charged particles impinging on a solid target at the Fermilab Test Beam Facility. LArIAT employs a 0.24~ton active mass Liquid Argon Time Projection Chamber (LArTPC) to measure the pion hadronic interactions. For this measurement, LArIAT has developed the ``thin slice method", a new technique to measure cross sections with LArTPCs. While generally higher than the prediction, our measurement of the ($\pi^-$,Ar) total hadronic cross section is in agreement with the prediction of the Geant4 model when considering a model uncertainty of $\sim$5.1\%.

hep-ex↗

arXiv2019

The Liquid Argon In A Testbeam (LArIAT) Experiment

The LArIAT liquid argon time projection chamber, placed in a tertiary beam of charged particles at the Fermilab Test Beam Facility, has collected large samples of pions, muons, electrons, protons, and kaons in the momentum range 300-1400 MeV/c. This paper describes the main aspects of the detector and beamline, and also reports on calibrations performed for the detector and beamline components.

physics.ins-det↗

arXiv2012

Quartz Cherenkov Counters for Fast Timing: QUARTIC

We have developed particle detectors based on fused silica (quartz) Cherenkov radiators read out with micro-channel plate photomultipliers (MCP-PMTs) or silicon photomultipliers (SiPMs) for high precision timing (Sigma(t) about 10-15 ps). One application is to measure the times of small angle protons from exclusive reactions, e.g. p + p - p + H + p, at the Large Hadron Collider, LHC. They may also be used to measure directional particle fluxes close to external or stored beams. The detectors have small areas (square cm), but need to be active very close (a few mm) to the intense LHC beam, and so must be radiation hard and nearly edgeless. We present results of tests of detectors with quartz bars inclined at the Cherenkov angle, and with bars in the form of an "L" (with a 90 degree corner). We also describe a possible design for a fast timing hodoscope with elements of a few square mm.

physics.ins-det↗

arXiv2010

Finite Element Simulation of the Optical Modes of Semiconductor Lasers

In the present article we investigate optical near fields in semiconductor lasers. We perform finite element simulations for two different laser types, namely a super large optical waveguide (SLOW) laser, which is an edge emitter, and a vertical cavity surface emitting laser (VCSEL). We give the mathematical formulation of the different eigenvalue problems that arise for our examples and explain their numerical solution with the finite element method. Thereby, we also comment on the usage of transparent boundary conditions, which have to be applied to respect the exterior environment, e.g., the very large substrate and surrounding air. For the SLOW laser we compare the computed near fields to experimental data for different design parameters of the device. For the VCSEL example a comparison to simplified 1D mode calculations is carried out.

physics.optics↗