Hans Martin Sauer | Searcharxiv

arXiv2023

Imaging and simulation-based analysis of evaporation flows over wetting edges

We monitor the evaporation of a volatile liquid (ethanol) from an inkjet-printed liquid film, consisting of a mixture of ethanol and ethylene glycol. Interferometric video imaging technology is used for recording 2D vapor concentration profiles over the evaporating film. The vapor flow is reconstructed using numerical simulations. In this way, we reconstruct the complete flow velocity profile, and distinguish diffusive and convective gas transport flows, with quantitative tracking of the transport balances. The convective flows are driven by the buoyancy of the solvent vapor in the ambient air. In particular, we reconstruct the evaporation process from the interface of the two-component liquid. We monitor the evaporation flows, implement Raoult's and Henry's laws of vapor pressure reduction, as well as evaporation resistivity. We observe the edge-enhancement of evaporation flows at the wetting rims of the liquid film, and decompose the vapor flows in the diffusive and the convective contribution. We demonstrate how Langmuir's evaporation resistivity can be identified using vapor pressure profiles in the gas phase data and mass transfer balances.

physics.flu-dyn↗

arXiv2019

Forced dynamic dewetting of structured surfaces: Influence of surfactants

We analyse the dewetting of printing plates for gravure printing with well-defined gravure cells. The printing plates were mounted on a rotating horizontal cylinder that is half immersed in an aqueous solution of the anionic surfactant sodium 1-decanesulfonate. The gravure plates and the presence of surfactants serve as one example of a real-world dewetting situation. When rotating the cylinder, a liquid meniscus was partially drawn out of the liquid forming a dynamic contact angle at the contact line. The dynamic contact angle is decreased on a structured surface as compared to a smooth one. This is due to contact line pinning at the borders of the gravure cells. Additionally, surfactants tend to decrease the dynamic receding contact angle. We consider the interplay between these two effects. We compare the height differences of the meniscus on the structured and unstructured area as function of dewetting speeds. The height difference increases with increasing dewetting speed. With increasing size of the gravure cells this height difference and the induced changes in the dynamic contact angle increased. By adding surfactant, the height difference and the changes in the contact angle for the same surface decreased. We further note that although the liquid dewets the printing plates some liquid is always left in the gravure cell. At high enough surfactant concentrations or high enough dewetting speed, the dynamic contact angles in the structured surface approach those in flat surfaces. We conclude that surfactant reduces the influence of surface structure on dynamic dewetting.

cond-mat.soft↗