Beam Spill Structure Measurements at CEE Using the T0 Detector
The Cooling Storage Ring External-target Experiment (CEE) at the Heavy Ion Research Facility in Lanzhou uses a slow-extracted heavy-ion beam whose temporal profile directly affects detector occupancy. The existing CEE T0 detector, originally designed to provide the event start time, is extended in this work to measure the spill structure immediately upstream of the fixed target. The detector consists of a 0.8-mm-thick EJ-200 plastic scintillator read out by 16 silicon photomultipliers at each end. The SiPM signals are conditioned and discriminated by the NINO front-end electronics, and the resulting timing signals are recorded using an FPGA-based time-to-digital converter. In laboratory tests, with the laser trigger set to its maximum available repetition frequency of 100~MHz, the recorded T0 hit-rate distribution was concentrated around 100~MHz. During the June 2024 beam test with 350-MeV/u Kr ions, the accelerator team varied several operating settings, including RF-KO, sextupole, and feedback settings, while T0 independently recorded the corresponding spill profiles. An empirical representation was used to extract the rise, plateau, and fall durations from the stored profiles. The plateau duration was used as the primary comparison metric while accelerator stability and RF-system load were also considered. The measurements clearly distinguished the spill-profile responses associated with different accelerator settings. The spill obtained with the selected settings exhibited a more nearly rectangular envelope than the initial profile, although residual fluctuations and a terminal spike remained. These results demonstrate that the existing CEE T0 detector can provide independent beam-structure information during accelerator tuning.