arXiv subjects
Publications and source records attributed to Haoshuo Chen.
We propose a digital interference mitigation scheme to reduce the impact of mode coupling in space division multiplexing self-homodyne coherent detection and experimentally verify its effectiveness in 240-Gbps mode-multiplexed transmission over 3-mode multimode fiber.
Lossless linear wave propagation is symmetric in time, a principle which can be used to create time reversed waves. Such waves are special 'pre-scattered' spatiotemporal fields, which propagate through a complex medium as if observing a scattering process in reverse, entering the medium as a complicated spatiotemporal field and arriving after propagation as a desired target field, such as a spatiotemporal focus. Time reversed waves have previously been demonstrated for relatively low frequency phenomena such as acoustics, water waves and microwaves. Many attempts have been made to extend these techniques into optics. However, the much higher frequencies of optics make for very different requirements. A fully time reversed wave is a volumetric field with arbitrary amplitude, phase and polarisation at every point in space and time. The creation of such fields has not previously been possible in optics. We demonstrate time reversed optical waves with a device capable of independently controlling all of light's classical degrees of freedom simultaneously. Such a class of ultrafast wavefront shaper is capable of generating a sequence of arbitrary 2D spatial/polarisation wavefronts at a bandwidth limited rate of 4.4 THz. This ability to manipulate the full field of an optical beam could be used to control both linear and nonlinear optical phenomena.
Digital holography measures the complex optical field and transfer matrix of a device, polarization-diversity is often achieved through spatial multiplexing. We introduce angular multiplexing, to increase flexibility in the optical setup. Comparatively, similar values for cross-talk and mode-dependent loss are measured for a photonic lantern.
We propose a wavelength-mode sorter realized by multi-plane light conversion (MPLC). For the first time, to our best knowledge, wavelengths and spatial modes can be sorted simultaneously. We first demonstrate pure wavelength sorting by a series of phase masks, which could find applications in high-power wavelength beam combining (WBC) or coarse wavelength-division multiplexing (CWDM), for example. We then present a design of a 4-wavelength, 3-mode sorter using only 5 phase masks. Insertion loss (IL) and mode dependent loss (MDL) as low as 1.27 dB and 2.45 dB can be achieved, respectively.
We designed, fabricated and tested an optical hybrid that supports an octave of bandwidth (900-1800 nm) and below 4-dB insertion loss using multiplane light conversion. Measured phase errors are below 3-degree across a measurement bandwidth of 390 nm.
Temporal waveform manipulation is a fundamental functionality in optics and crucial for applications like optical communications, microwave photonics and quantum optics. Traditional IQ- or phase-amplitude modulators shape light by carving energy from the input lightwave and are thus fundamentally lossy, and cannot apply independent modulation to multiple input wavelengths simultaneously. Taking inspiration from the space-time duality, we produce arbitrary unitary spectro-temporal transformations on multiple temporal input vectors with a modulation structure comprising of only lossless phase modulation and dispersive allpass filtering. The bandwidth of the output waveforms is not restricted by the driving electronics and independent transformations can be performed simultaneously on multiple orthogonal inputs such as spectrally separated frequency tones. This overcomes the main limitations of traditional electro-optic modulators and offers fundamental new insight into temporal wave manipulation.
Conventional optical coherent receivers capture the full electrical field, including amplitude and phase, of a signal waveform by measuring its interference against a stable continuous-wave local oscillator (LO). In optical coherent communications, powerful digital signal processing (DSP) techniques operating on the full electrical field can effectively undo transmission impairments such as chromatic dispersion (CD), and polarization mode dispersion (PMD). Simpler direct detection techniques do not have access to the full electrical field and therefore lack the ability to compensate for these impairments. We present a full-field measurement technique using only direct detection that does not require any beating with a strong carrier LO. Rather, phase retrieval algorithms based on alternating projections that makes use of dispersive elements are discussed, allowing to recover the optical phase from intensity-only measurements. In this demonstration, the phase retrieval algorithm is a modified Gerchberg Saxton (GS) algorithm that achieves a simulated optical signal-to-noise ratio (OSNR) penalty of less than 4dB compared to theory at a bit-error rate of 2 times 10-2. Based on the proposed phase retrieval scheme, we experimentally demonstrate signal detection and subsequent standard 2x2 multiple-input-multiple-output (MIMO) equalization of a polarization-multiplexed 30-Gbaud QPSK transmitted over a 520-km standard single-mode fiber (SMF) span.
We realize mode-multiplexed full-field reconstruction over six spatial and polarization modes after 30-km multimode fiber transmission using intensity-only measurements without any optical carrier or local oscillator at the receiver or transmitter. The receiver's capabilities to cope with modal dispersion and mode dependent loss are experimentally demonstrated.
We demonstrate the first transmission of a new twelve-dimensional modulation format over a three-core coupled-core multicore fiber. The format occupies a single time slot spread across all three linearly-coupled spatial modes and shows improved MI and GMI after transmission compared to PDM-QPSK.
We realize dual-polarization full-field recovery using intensity only measurements and phase retrieval techniques based on dispersive elements. 30-Gbaud QPSK waveforms are transmitted over 520-km standard single-mode fiber and equalized from the receiver outputs using 2X2 MIMO.
Light's spatial properties represent an infinite state space, making it attractive for applications requiring high dimensionality, such as quantum mechanics and classical telecommunications, but also inherently spatial applications such as imaging and sensing. However, there is no demultiplexing device in the spatial domain comparable to a grating or calcite for the wavelength and polarisation domains respectively. Specifically, a simple device capable of splitting a finite beam into a large number of discrete spatially separated spots each containing a single orthogonal spatial component. We demonstrate a device capable of decomposing a beam into a Cartesian grid of identical Gaussian spots each containing a single Laguerre-Gaussian component. This is the first device capable of decomposing the azimuthal and radial components simultaneously, and is based on a single spatial light modulator and mirror. We demonstrate over 210 spatial components, meaning it is also the highest dimensionality mode multiplexer of any kind.
We use white Gaussian noise as a test signal for single-mode and multimode transmission links and estimate the link capacity based on a calculation of mutual information. We also extract the complex amplitude channel estimations and mode-dependent loss with high accuracy.