arXiv subjects

Harald Oezelt

Publications and source records attributed to Harald Oezelt.

25 records · Page 2Linked to original sources

arXiv2017

Transition Jitter in Heat Assisted Magnetic Recording by Micromagnetic Simulation

In this paper we apply an extended Landau-Lifschitz equation, as introduced by Baňas et al. for the simulation of heat-assisted magnetic recording. This equation has similarities with the Landau-Lifshitz-Bloch equation. The Baňas equation is supposed to be used in a continuum setting with sub-grain discretization by the finite-element method. Thus, local geometric features and nonuniform magnetic states during switching are taken into account. We implement the Baňas model and test its capability for predicting the recording performance in a realistic recording scenario. By performing recording simulations on 100 media slabs with randomized granular structure and consecutive read back calculation, the write position shift and transition jitter for bit lengths of 10nm, 12nm, and 20nm are calculated.

physics.comp-ph↗

arXiv2017

Micromagnetic Simulations for Coercivity Improvement through Nano-Structuring of Rare-Earth Free L1$_0$-FeNi Magnets

In this work we investigate the potential of tetragonal L1$_0$ ordered FeNi as candidate phase for rare earth free permanent magnets taking into account anisotropy values from recently synthesized, partially ordered FeNi thin films. In particular, we estimate the maximum energy product ($BH$)$_\mathrm{max}$ of L1$_0$-FeNi nanostructures using micromagnetic simulations. The maximum energy product is limited due to the small coercive field of partially ordered L1$_0$-FeNi. Nano-structured magnets consisting of 128 equi-axed, platelet-like and columnar-shaped grains show a theoretical maximum energy product of 228 kJ/m$^3$, 208 kJ/m$^3$, 252 kJ/m$^3$, respectively.

physics.comp-ph↗

arXiv2016

Switching field distribution of exchange coupled ferri-/ferromagnetic composite bit patterned media

We investigate the switching field distribution and the resulting bit error rate of exchange coupled ferri-/ferromagnetic bilayer island arrays by micromagnetic simulations. Using islands with varying microstructure and anisotropic properties, the intrinsic switching field distribution is computed. The dipolar contribution to the switching field distribution is obtained separately by using a model of a triangular patterned island array resembling $1.4\,\mathrm{Tb/in}^2$ bit patterned media. Both contributions are computed for different thickness of the soft exchange coupled ferrimagnet and also for ferromagnetic single phase FePt islands. A bit patterned media with a bilayer structure of FeGd($5\,\mathrm{nm}$)/FePt($5\,\mathrm{nm}$) shows a bit error rate of $10^{-4}$ with a write field of $1.16\,\mathrm{T}$.

physics.comp-ph↗

arXiv2016

Micromagnetic simulation of exchange coupled ferri-/ferromagnetic composite in bit patterned media

Ferri-/ferromagnetic exchange coupled composites are promising candidates for bit patterned media because of the ability to control the magnetic properties of the ferrimagnet by its composition. A micromagnetic model for the bilayer system is presented where we also incorporate the microstructural features of both layers. Micromagnetic finite element simulations are performed to investigate the magnetization reversal behaviour of such media. By adding the exchange coupled ferrimagnet to the ferromagnet, the switching field could be reduced by up to $40\,\%$ and also the switching field distribution is narrowed. To reach these significant improvements, an interface exchange coupling strength of $2\,\mathrm{mJ/m^2}$ is required.

physics.comp-ph↗

arXiv2016

Thermal activation in permanent magnets

The coercive field of permanent magnets decays with temperature. At non-zero temperature the system can overcome a finite energy barrier through thermal fluctuations. Using finite element micromagnetic simulations, we quantify this effect, which reduces coercivity in addition to the decrease of the coercive field associated with the temperature dependence of the anisotropy field, and validate the method through comparison with existing experimental data.

cond-mat.mtrl-sci↗

arXiv2016

Influence of defect thickness on the angular dependence of coercivity in rare-earth permanent magnets

The coercive field and angular dependence of the coercive field of single-grain Nd$_{2}$Fe$_{14}$B permanent magnets are computed using finite element micromagnetics. It is shown that the thickness of surface defects plays a critical role in determining the reversal process. For small defect thicknesses reversal is heavily driven by nucleation, whereas with increasing defect thickness domain wall de-pinning becomes more important. This change results in an observable shift between two well-known behavioral models. A similar trend is observed in experimental measurements of bulk samples, where a Nd-Cu infiltration process has been used to enhance coercivity by modifying the grain boundaries. When account is taken of the imperfect grain alignment of real magnets, the single-grain computed results appears to closely match experimental behaviour.

cond-mat.mtrl-sci↗

arXiv2011

A tunable cancer cell filter using magnetic beads: cellular and fluid dynamic simulations

In the field of biomedicine magnetic beads are used for drug delivery and to treat hyperthermia. Here we propose to use self-organized bead structures to isolate circulating tumor cells using lab-on-chip technologies. Typically blood flows past microposts functionalized with antibodies for circulating tumor cells. Creating these microposts with interacting magnetic beads makes it possible to tune the geometry in size, position and shape. We develop a simulation tool that combines micromagnetics, discrete particle dynamics and fluid dynamics, in order to design micropost arrays made of interacting beads. For the simulation of blood flow we use the Lattice-Boltzmann method with immersed elastic blood cell models. Parallelization distributes large fluid and particle dynamic simulations over available resources to reduce overall calculation time.

physics.flu-dyn↗