arXiv subjects

Harish Viswanathan

Publications and source records attributed to Harish Viswanathan.

25 records · Page 2Linked to original sources

arXiv2018

Outage of Periodic Downlink Wireless Networks with Hard Deadlines

We consider a downlink periodic wireless communications system where multiple access points (APs) cooperatively transmit packets to a number of devices, e.g. actuators in an industrial control system. Each period consists of two phases: an uplink training phase and a downlink data transmission phase. Each actuator must successfully receive its unique packet within a single transmission phase, else an outage is declared. Such an outage can be caused by two events: a transmission error due to transmission at a rate that the channel cannot actually support or time overflow, where the downlink data phase is too short given the channel conditions to successfully communicate all the packets. We determine closed-form expressions for the probability of time overflow when there are just two field devices, as well as the probability of transmission error for an arbitrary number of devices. Also, we provide upper and lower bounds on the time overflow probability for an arbitrary number of devices. We propose a novel variable-rate transmission method that eliminates time overflow. Detailed system-level simulations are used to identify system design guidelines, such as the optimal amount of uplink training time, as well as for benchmarking the proposed system design versus non-cooperative cellular, cooperative fixed-rate, and cooperative relaying.

cs.IT↗

arXiv2017

Analysis of Feedback Error in Automatic Repeat reQuest

The future wireless networks envision ultra-reliable communication with efficient use of the limited wireless channel resources. Closed-loop repetition protocols where retransmission of a packet is enabled using a feedback channel has been adopted since early days of wireless telecommunication. Protocols such as automatic repeat request (ARQ) are used in today's wireless technologies as a mean to provide the link with reduced rate of packet outage and increased average throughput. The performance of such protocols is strongly dependent to the feedback channel reliability. This paper studies the problem of feedback error and proposes a new method of acknowledging packet delivery for retransmission protocols in unreliable feedback channel conditions. The proposed method is based on backwards composite acknowledgment from multiple packets in a retransmission protocol and provides the scheduler of the wireless channel with additional parameters to configure ultra-reliable communication for a user depending on channel quality. Numerical analysis are presented which show orders of magnitude increase in reliability of the proposed method as compared to ARQ at the cost of a small increase in average experienced delay.

cs.IT↗

arXiv2015

Wide-area Wireless Communication Challenges for the Internet of Things

Aided by the ubiquitous wireless connectivity, declining communication costs, and the emergence of cloud platforms, the deployment of Internet of Things (IoT) devices and services is accelerating. Most major mobile network operators view machine-to-machine (M2M) communication networks for supporting IoT as a significant source of new revenue. In this paper, we motivate the need for wide-area M2M wireless networks, especially for short data packet communication to support a very large number of IoT devices. We first present a brief overview of current and emerging technologies for supporting wide area M2M, and then using communication theory principles, discuss the fundamental challenges and potential solutions for these networks, highlighting tradeoffs and strategies for random and scheduled access. We conclude with recommendations for how future 5G networks should be designed for efficient wide-area M2M communications.

cs.IT↗

arXiv2013

Fundamentals of Throughput Maximization with Random Arrivals for M2M Communications

For wireless systems in which randomly arriving devices attempt to transmit a fixed payload to a central receiver, we develop a framework to characterize the system throughput as a function of arrival rate and per-user data rate. The framework considers both coordinated transmission (where devices are scheduled) and uncoordinated transmission (where devices communicate on a random access channel and a provision is made for retransmissions). Our main contribution is a novel characterization of the optimal throughput for the case of uncoordinated transmission and a strategy for achieving this throughput that relies on overlapping transmissions and joint decoding. Simulations for a noise-limited cellular network show that the optimal strategy provides a factor of four improvement in throughput compared to slotted aloha. We apply our framework to evaluate more general system-level designs that account for overhead signaling. We demonstrate that, for small payload sizes relevant for machine-to-machine (M2M) communications (200 bits or less), a one-stage strategy, where identity and data are transmitted optimally over the random access channel, can support at least twice the number of devices compared to a conventional strategy, where identity is established over an initial random-access stage and data transmission is scheduled.

cs.IT↗

arXiv2013

Dynamic Spectrum Refarming with Overlay for Legacy Devices

The explosive growth in data traffic is resulting in a spectrum crunch forcing many wireless network operators to look towards refarming their 2G spectrum and deploy more spectrally efficient Long Term Evolution (LTE) technology. However, mobile network operators face a challenge when it comes to spectrum refarming because 2G technologies such as Global System for Mobile (GSM) is still widely used for low bandwidth machine-to-machine (M2M) devices. M2M devices typically have long life cycles, e.g. smart meters, and it is expensive to migrate these devices to newer technology since a truck roll will typically be required to the site where a device is deployed. Furthermore, with cost of 2G modules several times less than that of LTE, even newly deployed M2M devices tend to adopt 2G technology. Nevertheless, operators are keen to either force their 2G M2M customers to migrate so that they can refarm the spectrum or set aside a portion of the 2G spectrum for continuing operating 2G and only refarm the rest for LTE. In this paper we propose a novel solution to provide GSM connectivity within an LTE carrier through an efficient overlay by reserving a few physical resource blocks for GSM. With this approach, operators can refarm their 2G spectrum to LTE efficiently while still providing some GSM connectivity to their low data rate M2M customers. Furthermore, spectrum can be dynamically shared between LTE and GSM. An approach similar to that proposed in this paper can also be applied for other narrow band technology overlays over LTE.

cs.NI↗

arXiv2013

Dynamic Spectrum Refarming of GSM Spectrum for LTE Small Cells

In this paper we propose a novel solution called dynamic spectrum refarming (DSR) for deploying LTE small cells using the same spectrum as existing GSM networks. The basic idea of DSR is that LTE small cells are deployed in the GSM spectrum but suppress transmission of all signals including the reference signals in some specific physical resource blocks corresponding to a portion of the GSM carriers to ensure full GSM coverage. Our study shows that the proposed solution can provide LTE mobile terminals with high speed data services when they are in the coverage of the LTE small cells while minimally affecting the service provided to GSM terminals located within the LTE small cell coverage area. Thus, the proposal allows the normal operation of the existing GSM networks even with LTE small cells deployed in that spectrum. Though the focus of this paper is about GSM spectrum refarming, an analogous approach can be applied to reuse code division multiple access (CDMA) spectrum for LTE small cells.

cs.IT↗

arXiv2013

Power-Efficient System Design for Cellular-Based Machine-to-Machine Communications

The growing popularity of Machine-to-Machine (M2M) communications in cellular networks is driving the need to optimize networks based on the characteristics of M2M, which are significantly different from the requirements that current networks are designed to meet. First, M2M requires large number of short sessions as opposed to small number of long lived sessions required by the human generated traffic. Second, M2M constitutes a number of battery operated devices that are static in locations such as basements and tunnels, and need to transmit at elevated powers compared to the traditional devices. Third, replacing or recharging batteries of such devices may not be feasible. All these differences highlight the importance of a systematic framework to study the power and energy optimal system design in the regime of interest for M2M, which is the main focus of this paper. For a variety of coordinated and uncoordinated transmission strategies, we derive results for the optimal transmit power, energy per bit, and the maximum load supported by the base station, leading to the following design guidelines: (i) frequency division multiple access (FDMA), including equal bandwidth allocation, is sum-power optimal in the asymptotically low spectral efficiency regime, (ii) while FDMA is the best practical strategy overall, uncoordinated code division multiple access (CDMA) is almost as good when the base station is lightly loaded, (iii) the value of optimization within FDMA is in general not significant in the regime of interest for M2M.

cs.IT↗