arXiv subjects

Harri Lipsanen

Publications and source records attributed to Harri Lipsanen.

12 recordsLinked to original sources

arXiv2025

Graphene-Gold THz Metasurfaces with Tailored Resonant Structure for Enhanced Nonlinear Response

Graphene's exceptional nonlinear optical properties combined with resonant photonic structures offer a promising pathway for efficient nonlinear applications at terahertz (THz) frequencies. In this work, we propose and demonstrate a fabrication-friendly hybrid nonlinear metasurface composed of gold patches integrated with uniform graphene, circumventing the need for complex graphene patterning. The structure supports strong localized resonances that enhance nonlinear interactions. By exploiting resonant enhancement at both the fundamental and third harmonic frequencies, we predict via simulations third-harmonic generation efficiencies as high as -15 dB (3.2%) under continuous-wave excitation at modest intensities (0.1 MW/cm$^2$). The metasurface is fabricated via electron-beam lithography and experimentally characterized using THz time-domain spectroscopy. Under pulsed excitation, we experimentally observe pronounced nonlinear frequency shifts up to 0.5~THz (12.5% fractional change), driven by self-phase modulation, consistent with simulation results. These findings highlight the potential of tailored graphene-based metasurfaces for efficient nonlinear THz photonic devices.

physics.optics↗

arXiv2024

Broadband miniaturized spectrometers with a van der Waals tunnel diode

Miniaturized spectrometers are of immense interest for various on-chip and implantable photonic and optoelectronic applications. State-of-the-art conventional spectrometer designs rely heavily on bulky dispersive components (such as gratings, photodetector arrays, and interferometric optics) to capture different input spectral components that increase their integration complexity. Here, we report a high-performance broadband spectrometer based on a simple and compact van der Waals heterostructure diode, leveraging a careful selection of active van der Waals materials -- molybdenum disulfide and black phosphorus, their electrically tunable photoresponse, and advanced computational algorithms for spectral reconstruction. We achieve remarkably high peak wavelength accuracy of ~2 nanometers, and broad operation bandwidth spanning from ~500 to 1600 nanometers in a device with a ~30x20 μm2 footprint. This diode-based spectrometer scheme with broadband operation offers an attractive pathway for various applications, such as sensing, surveillance and spectral imaging.

physics.optics↗

arXiv2022

Probing Electronic States in Monolayer Semiconductors through Static and Transient Third-Harmonic Spectroscopy

Electronic states and their dynamics are of critical importance for electronic and optoelectronic applications. Here, we probe various relevant electronic states in monolayer MoS2, such as multiple excitonic Rydberg states and free-particle energy bands, with a high relative contrast of up to >200 via broadband (from ~1.79 to 3.10 eV) static third-harmonic spectroscopy, which is further supported by theoretical calculations. Moreover, we introduce transient third-harmonic spectroscopy to demonstrate that third-harmonic generation can be all-optically modulated with a modulation depth exceeding ~94% at ~2.18 eV, providing direct evidence of dominant carrier relaxation processes, associated with carrier-exciton and carrier-phonon interactions. Our results indicate that static and transient third-harmonic spectroscopies are not only promising techniques for the characterization of monolayer semiconductors and their heterostructures, but also a potential platform for disruptive photonic and optoelectronic applications, including all-optical modulation and imaging.

physics.optics↗

arXiv2019

Enhanced Tunnelling in a Hybrid of Single-Walled Carbon Nanotubes and Graphene

Transparent and conductive films (TCFs) are of great technological importance. The high transmittance, electrical conductivity and mechanical strength make single-walled carbon nanotubes (SWCNTs) a good candidate for their raw material. Despite the ballistic transport in individual SWCNTs, however, the electrical conductivity of their networks is limited by low efficiency of charge tunneling between the tube elements. Here, we demonstrate that the nanotube network sheet resistance at high optical transmittance is decreased by more than 50% when fabricated on graphene and thus provides a comparable improvement as widely adopted gold chloride ($\mathrm{AuCl_3}$) doping. However, while Raman spectroscopy reveals substantial changes in spectral features of doped nanotubes, no similar effect is observed in presence of graphene. Instead, temperature dependent transport measurements indicate that graphene substrate reduces the tunneling barrier heights while its parallel conductivity contribution is almost negligible. Finally, we show that combining the graphene substrate and $\mathrm{AuCl_3}$ doping, the SWCNT thin films can exhibit sheet resistance as low as 36 $Ω$/sq. at 90% transmittance.

physics.app-ph↗

arXiv2018

Optical harmonic generation in monolayer group-VI transition metal dichalcogenides

Monolayer transition metal dichalcogenides (TMDs) exhibit high nonlinear optical (NLO) susceptibilities. Experiments on MoS$_2$ have indeed revealed very large second-order ($χ^{(2)}$) and third-order ($χ^{(3)}$) optical susceptibilities. However, third harmonic generation results of other layered TMDs has not been reported. Furthermore, the reported $χ^{(2)}$ and $χ^{(3)}$ of MoS$_2$ vary by several orders of magnitude, and a reliable quantitative comparison of optical nonlinearities across different TMDs has remained elusive. Here, we investigate second- and third-harmonic generation, and three-photon photoluminescence in TMDs. Specifically, we present an experimental study of $χ^{(2)}$, and $χ^{(3)}$ of four common TMD materials (\ce{MoS2}, \ce{MoSe2}, \ce{WS2} and \ce{WSe2}) by placing different TMD flakes in close proximity to each other on a common substrate, allowing their NLO properties to be accurately obtained from a single measurement. $χ^{(2)}$ and $χ^{(3)}$ of the four monolayer TMDs have been compared, indicating that they exhibit distinct NLO responses. We further present theoretical simulations of these susceptibilities in qualitative agreement with the measurements. Our comparative studies of the NLO responses of different two-dimensional layered materials allow us to select the best candidates for atomic-scale nonlinear photonic applications, such as frequency conversion and all-optical signal processing.

physics.optics↗

arXiv2018

Low-power continuous-wave second harmonic generation in semiconductor nanowires

Semiconductor nanowires (NWs) are promising for realizing various on-chip nonlinear optical devices, due to their nanoscale lateral confinement and strong light-matter interaction. However, high-intensity pulsed pump lasers are typically needed to exploit their optical nonlinearity because light couples poorly with nanometric-size wires. Here, we demonstrate microwatts continuous-wave light pumped second harmonic generation (SHG) in AlGaAs NWs by integrating them with silicon planar photonic crystal cavities. Light-NW coupling is enhanced effectively by the extremely localized cavity mode at the subwavelength scale. Strong SHG is obtained even with a continuous-wave laser excitation with a pump power down to ~3 uW, and the cavity-enhancement factor is estimated around 150. Additionally, in the integrated device, the NW's SHG is more than two-order of magnitude stronger than third harmonic generations in the silicon slab, though the NW only couple s with less than 1% of the cavity mode. This significantly reduced power-requirement of NW's nonlinear frequency conversion would promote NW-based building blocks for nonlinear optics, specially in chip-integrated coherent light sources, entangled photon-pairs and signal processing devices.

physics.optics↗

arXiv2017

Scaling of graphene field-effect transistors supported on hexagonal boron nitride: radio-frequency stability as a limiting factor

The quality of graphene in nanodevices has increased hugely thanks to the use of hexagonal boron nitride as a supporting layer. This paper studies to which extent hBN together with channel length scaling can be exploited in graphene field effect transistors (GFETs) to get a competitive radio frequency (RF) performance. Carrier mobility and saturation velocity were obtained from an ensemble Monte Carlo simulator that accounted for the relevant scattering mechanisms (intrinsic phonons, scattering with impurities and defects, etc.). This information is fed into a self consistent simulator, which solves the drift diffusion equation coupled with the two dimensional Poisson's equation to take full account of short channel effects. Simulated GFET characteristics were benchmarked against experimental data from our fabricated devices. Our simulations show that scalability is supposed to bring to RF performance an improvement that is, however, highly limited by instability. Despite the possibility of a lower performance, a careful choice of the bias point can avoid instability. Nevertheless, maximum oscillation frequencies are still achievable in the THz region for channel lengths of a few hundreds of nanometers.

physics.app-ph↗

arXiv2016

Direct Observation of Acoustic Phonon Confinement in Free-Standing Semiconductor Nanowires

Similar to electron waves, the phonon states in semiconductors can undergo changes induced by external boundaries. Modification of acoustic phonon spectrum in structures with periodically modulated elastic constant or mass density - referred to as phononic crystals - has been proven experimentally and utilized in practical applications. A possibility of modifying acoustic phonon spectrum in individual nanostructures via spatial confinement would bring tremendous benefits for controlling phonon-electron interaction and thermal conduction at nanoscale. However, despite strong scientific and practical importance, conclusive experimental evidence of acoustic phonon confinement in individual free-standing nanostructures, e.g. nanowires, is still missing. The length scale, at which phonon dispersion undergoes changes and a possibility of the phonon group velocity reduction, are debated. Here, we utilize specially designed high-quality GaAs nanowires (NWs) with different diameters, D, and large inter-nanowire distances to directly demonstrate acoustic phonon confinement. The measurements conducted with Brillouin - Mandelstam spectroscopy reveal confined phonon polarization branches with frequencies from 4 GHz to 40 GHz in NWs with D as large as ~128 nm, i.e. at length scale, which exceeds the "grey" phonon mean-free path in GaAs by an almost an order of magnitude. The phonon dispersion modification and phonon energy scaling with D in individual nanowires are in excellent agreement with theory. The obtained results can lead to more efficient nanoscale control of acoustic phonons, with benefits for nanoelectronics, thermoelectric energy conversion, thermal management, and novel spintronic technologies.

cond-mat.mes-hall↗

arXiv2015

A physics based model of gate tunable metal-graphene contact resistance benchmarked against experimental data

The metal-graphene contact resistance is a technological bottleneck for the realization of viable graphene based electronics. We report a useful model to find the gate tunable components of this resistance determined by the sequential tunneling of carriers between the 3D-metal and 2D-graphene underneath followed by Klein tunneling to the graphene in the channel. This model quantifies the intrinsic factors that control that resistance, including the effect of unintended chemical doping. Our results agree with experimental results for several metals.

cond-mat.mes-hall↗

arXiv2015

Broadband laser polarization control with aligned carbon nanotubes

We introduce a simple approach to fabricate aligned carbon nanotube (ACNT) device for broadband polarization control in fiber laser systems. The ACNT device was fabricated by pulling from as-fabricated vertically-aligned carbon nanotube arrays. Their anisotropic property is confirmed with optical and scanning electron microscopy, and with polarized Raman and absorption spectroscopy. The device was then integrated into fiber laser systems (at two technologically important wavelengths of 1 and 1.5 um) for polarization control. We obtained a linearly-polarized light output with the maximum extinction ratio of ~12 dB. The output polarization direction could be fully controlled by the ACNT alignment direction in both lasers. To the best of our knowledge, this is the first time that ACNT device is applied to polarization control in laser systems. Our results exhibit that the ACNT device is a simple, low-cost, and broadband polarizer to control laser polarization dynamics, for various photonic applications (such as material processing, polarization diversity detection in communications), where the linear polarization control is necessary.

physics.optics↗

arXiv2015

Ultrafast pulse generation with black phosphorus

Black phosphorus has been recently rediscovered as a new and interesting two-dimensional material due to its unique electronic and optical properties. Here, we study the linear and nonlinear optical properties of black phosphorus thin films, indicating that both linear and nonlinear optical properties are anisotropic and can be tuned by the film thickness. Then we employ the nonlinear optical property of black phosphorus for ultrafast (pulse duration down to ~786 fs in mode-locking) and large-energy (pulse energy up to >18 nJ in Q-switching) pulse generation in fiber lasers at the near-infrared telecommunication band ~1.5 μm. Our results underscore relatively large optical nonlinearity in black phosphorus and its prospective for ultrafast pulse generation, paving the way to black phosphorus based nonlinear and ultrafast photonics applications (e.g., ultrafast all-optical switches/modulators, frequency converters etc.).

physics.optics↗

arXiv2010

Recent progress towards acoustically mediated carrier injection into individual nanostructures for single photon generation

We report on recent progress towards single photon sources based on quantum dot and quantum post nanostructures which are manipulated using surface acoustic waves. For this concept acoustic charge conveyance in a quantum well is used to spatially separate electron and hole pairs and transport these in the plane of the quantum well. When conveyed to the location of a quantum dot or quantum post these carriers are sequentially captured into the confined levels. Their radiative decays gives rise to the emission of a train of single photons. Three different approaches using (i) strain- induced and (ii) self-assembled quantum dots, and (iii) self-assembled quantum posts are discussed and their application potential is discussed. First devices and initial experiments towards the realization of such an acoustically driven single photon source are presented and remote acoustically triggered injection into few individual emitters is demonstrated.

quant-ph↗