arXiv subjects

Henry LeDuc

Publications and source records attributed to Henry LeDuc.

5 recordsLinked to original sources

arXiv2026

In Situ Interferometric Spatial Mapping Of A Microwave Kinetic Inductance Detector Array

We present a method of spatially mapping microwave kinetic inductance detector (MKID) arrays, in a dark setup. MKIDs are superconducting natively multiplexed resonators which enable kilopixel arrays, such as for the proposed Probe far-Infrared Mission for Astrophysics (PRIMA). In such telescope applications one must map the spatial location of each MKID with their individual resonance frequencies. Traditional LED arrays or beam-mapping methods become increasingly difficult as pixel spacing decreases, e.g., 900 {\mu}m separated MKIDs in the spectrometer module of PRIMA. Our new mapping technique uses a cryogenic interferometer in reflection mode. As on-resonance signals reflect from an MKID, they accrue a phase proportional to the path-length, exactly corresponding to their physical distance on the feedline. Specifically, we use a superconducting transmission line that has nonlinear kinetic inductance. The slow-wave structure of this nonlinear device is designed to have a signal speed of 0.64% the speed of light, enabling a compact system. Current biasing this line allows for varying the wave speed and ensuring that the phase measured is periodic within a nulling interferometric mode. Using this setup, we measure a length ordering that reflects the bimodal MKID distribution of a 44 pixel array of MKIDs designed for PRIMA which contains the same spacing as the final kilopixel array design.

astro-ph.IM↗

arXiv2024

A 4-8 GHz Kinetic Inductance Travelling-Wave Parametric Amplifier Using Four-Wave Mixing with Near Quantum-Limit Noise Performance

Kinetic inductance traveling-wave parametric amplifiers (KI-TWPA) have a wide instantaneous bandwidth with near quantum-limited performance and a relatively high dynamic range. Because of this, they are suitable readout devices for cryogenic detectors and superconducting qubits and have a variety of applications in quantum sensing. This work discusses the design, fabrication, and performance of a KI-TWPA based on four-wave mixing in a NbTiN microstrip transmission line. This device amplifies a signal band from 4 to 8~GHz without contamination from image tones, which are produced in a separate higher frequency band. The 4 - 8~GHz band is commonly used to read out cryogenic detectors, such as microwave kinetic inductance detectors (MKIDs) and Josephson junction-based qubits. We report a measured maximum gain of over 20 dB using four-wave mixing with a 1-dB gain compression point of -58 dBm at 15 dB of gain over that band. The bandwidth and peak gain are tunable by adjusting the pump-tone frequency and power. Using a Y-factor method, we measure an amplifier-added noise of $ 0.5 \leq N_{added} \leq 1.5$ photons from 4.5 - 8 GHz.

quant-ph↗

arXiv2023

Plasma-enhanced atomic layer deposition of titanium nitride for superconducting devices

This study presents a comprehensive investigation into the exceptional superconducting attributes of titanium nitride (TiN) achieved through plasma-enhanced atomic layer deposition (PEALD) on both planar and intricate three-dimensional (3D) structures. We introduced an additional substrate biasing cycle to densify the film and remove ligand residues, augmenting the properties while minimizing impurities. While reactive-sputtered TiN films exhibit high quality, our technique ensures superior uniformity by consistently maintaining a desired sheet resistance greater than 95 percent across a 6inch wafer, a critical aspect for fabricating extensive arrays of superconducting devices and optimizing wafer yield. Moreover, our films demonstrate exceptional similarity to conventional reactive-sputtered films, consistently reaching a critical temperature (Tc) of 4.35 K with a thickness of around 40 nm. This marks a notable achievement compared to previously reported ALD-based superconducting TiN. Using the same process as for planar films, we obtained Tc for aspect ratios (ARs) ranging from 2 to 40, observing a Tc of approximately 2 K for ARs between 2 and 10.5. We elucidate the mechanisms contributing to the limitations and degradation of superconducting properties over these aggressive 3D structures. Our results seamlessly align with both current and next-generation superconducting technologies, meeting stringent criteria for thin-film constraints, large-scale deposition, conformality, 3D integration schemes, and yield optimization.

cond-mat.supr-con↗

arXiv2023

Parallel Plate Capacitor Aluminum KIDs for Future Far-Infrared Space-Based Observatories

Future space-based far-infrared astrophysical observatories will require exquis-itely sensitive detectors consistent with the low optical backgrounds. The PRobe far-Infrared Mission for Astrophysics (PRIMA) will deploy arrays of thousands of superconducting kinetic inductance detectors (KIDs) sensitive to radiation between 25 and 265 $\mu$m. Here, we present laboratory characterization of prototype, 25 -- 80 $\mu$m wavelength, low-volume, aluminum KIDs designed for the low-background environment expected with PRIMA. A compact parallel plate capacitor is used to minimize the detector footprint and suppress TLS noise. A novel resonant absorber is designed to enhance response in the band of interest. We present noise and optical efficiency measurements of these detectors taken with a low-background cryostat and a cryogenic blackbody. A microlens-hybridized KID array is found to be photon noise limited down to about 50 aW with a limiting detector NEP of about $6.5 \times 10^{-19}~\textrm{W/Hz}^{1/2}$. A fit to an NEP model shows that our optical system is well characterized and understood down to 50 aW. We discuss future plans for low-volume aluminum KID array development as well as the testbeds used for these measurements.

astro-ph.IM↗

arXiv2008

Experimental evidence for a surface distribution of two-level systems in superconducting lithographed microwave resonators

We present measurements of the temperature-dependent frequency shift of five niobium superconducting coplanar waveguide microresonators with center strip widths ranging from 3 $μ$m to 50 $μ$m, taken at temperatures in the range 100-800 mK, far below the 9.2 K transition temperature of niobium. These data agree well with the two-level system (TLS) theory. Fits to this theory provide information on the number of TLS that interact with each resonator geometry. The geometrical scaling indicates a surface distribution of TLS, and the data are consistent with a TLS surface layer thickness of order a few nm, as might be expected for a native oxide layer.

cond-mat.supr-con↗