arXiv subjects

Hiroshi Idzuchi

Publications and source records attributed to Hiroshi Idzuchi.

6 recordsLinked to original sources

arXiv2023

Enhanced ferromagnetism in artificially stretched lattice in quasi two-dimensional Cr2Ge2Te6

In the fundamental understanding of magnetic interactions between atoms in solids, the crystal lattice is one of the key parameters. As the effective tool for controlling the lattice using tensile stress is limited, there are only few demonstrations of the control in magnetic properties with expanding the lattice structure. Here, we observe that the Curie temperature (Tc) of quasi two-dimensional Cr2Ge2Te6 with NiO overlayer doubles from ~60 K to ~120 K, describe a clear correlation of magnetic properties with lattice expansion, which is characterized by several probes and computational approaches, and address on the mechanisms leading to the increase in Tc via the change in exchange interactions.

cond-mat.mtrl-sci↗

arXiv2020

Strongly adhesive dry transfer technique for van der Waals heterostructure

That one can stack van der Waals materials with atomically sharp interfaces has provided a new material platform of constructing heterostructures. The technical challenge of mechanical stacking is picking up the exfoliated atomically thin materials after mechanical exfoliation without chemical and mechanical degradation. Chemically inert hexagonal boron nitride (hBN) has been widely used for encapsulating and picking up vdW materials. However, due to the relatively weak adhesion of hBN, assembling vdW heterostructures based on hBN has been limited. We report a new dry transfer technique. We used two vdW semiconductors (ZnPS3 and CrPS4) to pick up and encapsulate layers for vdW heterostructures, which otherwise are known to be hard to fabricate. By combining with optimized polycaprolactone (PCL) providing strong adhesion, we demonstrated various vertical heterostructure devices, including quasi-2D superconducting NbSe2 Josephson junctions with atomically clean interface. The versatility of the PCL-based vdW stacking method provides a new route for assembling complex 2D vdW materials without interfacial degradation.

physics.app-ph↗

arXiv2015

Spin relaxation characteristics in Ag nanowire covered with various oxides

We have studied spin relaxation characteristics in a Ag nanowire covered with various oxide layers of Bi2O3, Al2O3, HfO2, MgO or AgOx by using non-local spin valve structures. The spin-flip probability, a ratio of momentum relaxation time to spin relaxation time at 10 K, exhibits a gradual increase with an atomic number of the oxide constituent elements, Mg, Al, Ag and Hf. Surprisingly the Bi2O3 capping was found to increase the probability by an order of magnitude compared with other oxide layers. This finding suggests the presence of an additional spin relaxation mechanism such as Rashba effect at the Ag/Bi2O3 interface, which cannot be explained by the simple Elliott-Yafet mechanism via phonon, impurity and surface scatterings. The Ag/Bi2O3 interface may provide functionality as a spin to charge interconversion layer.

cond-mat.mtrl-sci↗

arXiv2013

5d transition metal oxide IrO2 as a material for spin current detection

Devices based on a pure spin current (a flow of spin angular momentum) have been attracting increasing attention as key ingredients for low-dissipation electronics. To integrate such spintronics devices into charge-based technologies, an electric detection of spin current is essential. Inverse spin Hall effect converts a spin current into an electric voltage through spin-orbit coupling. Noble metals such as Pt and Pd, and also Cu-based alloys, owing to the large direct spin Hall effect, have been regarded as potential materials for a spin-current injector. Those materials, however, are not promising as a spin-current detector based on inverse spin Hall effect. Their spin Hall resistivity rho_SH, representing the performance as a detector, is not large enough mainly due to their low charge resistivity. Here we demonstrate that heavy transition metal oxides can overcome such limitations inherent to metal-based spintronics materials. A binary 5d transition metal oxide IrO2, owing to its large resistivity as well as a large spin-orbit coupling associated with 5d character of conduction electrons, was found to show a gigantic rho_SH ~ 38 microohm cm at room temperature, one order of magnitude larger than those of noble metals and Cu-based alloys and even comparable to those of atomic layer thin film of W and Ta.

cond-mat.mes-hall↗

arXiv2013

Experimental Verification of Comparability between Spin-Orbit and Spin-Diffusion Lengths

We experimentally confirmed that the spin-orbit lengths of noble metals obtained from weak anti-localization measurements are comparable to the spin diffusion lengths determined from lateral spin valve ones. Even for metals with strong spin-orbit interactions such as Pt, we verified that the two methods gave comparable values which were much larger than those obtained from recent spin torque ferromagnetic resonance measurements. To give a further evidence for the comparability between the two length scales, we measured the disorder dependence of the spin-orbit length of copper by changing the thickness of the wire. The obtained spin-orbit length nicely follows a linear law as a function of the diffusion coefficient, clearly indicating that the Elliott-Yafet mechanism is dominant as in the case of the spin diffusion length.

cond-mat.mes-hall↗

arXiv2012

Towards coherent spin precession in pure-spin current

Non-local spin injection in lateral spin valves generates a pure spin current which is a diffusive flow of spins (i.e. spin angular momentums) with no net charge flow. The diffusive spins lose phase coherency in precession while undergoing frequent collisions and these events lead to a broad distribution of the dwell time in a transport channel between the injector and the detector. Here we show the lateral spin-valves with dual injectors enable us to detect a genuine in-plane precession signal from the Hanle effect, demonstrating the phase coherency in the in-plane precession is improved with an increase of the channel length. The coherency in the spin precession shows a universal behavior as a function of the normalized separation between the injector and the detector in material-independent fashion for metals and semiconductors including graphene.

cond-mat.mes-hall↗