arXiv subjects

Hongqiang Song

Publications and source records attributed to Hongqiang Song.

47 records · Page 3Linked to original sources

arXiv2018

Two-sided-loop jets associated with magnetic reconnection between emerging loops and twisted filament threads

Coronal jets are always produced by magnetic reconnection between emerging flux and pre-existing overlying magnetic fields. When the overlying field is vertical/obilique or horizontal, the coronal jet will appear as anemone type or two-sided-loop type. Most of observational jets are of the anemone type, and only a few of two-sided-loop jets have been reported. Using the high-quality data from New Vacuum Solar Telescope, Interface Region Imaging Spectrograph, and Solar Dynamics Observatory, we present an example of two-sided-loop jets simultaneously observed in the chromosphere, transition region, and corona. The continuous emergence of magnetic flux brought in successively emerging of coronal loops and the slowly rising of an overlying horizontal filament threads. Sequentially, there appeared the deformation of the loops, the plasmoids ejection from the loop top, and pairs of loop brightenings and jet moving along the untwisting filament threads. All the observational results indicate there exist magnetic reconnection between the emerging loops and overlying horizontal filament threads, and it is the first example of two-sided-loop jets associated with ejected plasmoids and twisted overlying fields.

astro-ph.SR↗

arXiv2018

An extreme ultraviolet wave generating upward secondary waves in a streamer-like solar structure

Extreme ultraviolet (EUV) waves, spectacular horizontally propagating disturbances in the low solar corona, always trigger horizontal secondary waves (SWs) when they encounter ambient coronal structure. We present a first example of upward SWs in a streamer-like structure after the passing of an EUV wave. The event occurred on 2017 June 1. The EUV wave happened during a typical solar eruption including a filament eruption, a CME, a C6.6 flare. The EUV wave was associated with quasi-periodic fast propagating (QFP) wave trains and a type II radio burst that represented the existence of a coronal shock. The EUV wave had a fast initial velocity of $\sim$1000 km s$^{-1}$, comparable to high speeds of the shock and the QFP wave trains. Intriguingly, upward SWs rose slowly ($\sim$80 km s$^{-1}$) in the streamer-like structure after the sweeping of the EUV wave. The upward SWs seemed to originate from limb brightenings that were caused by the EUV wave. All the results show the EUV wave is a fast-mode magnetohydrodynamic shock wave, likely triggered by the flare impulses. We suggest that part of the EUV wave was probably trapped in the closed magnetic fields of streamer-like structure, and upward SWs possibly resulted from the release of trapped waves in the form of slow-mode. It is believed that an interplay of the strong compression of the coronal shock and the configuration of the streamer-like structure is crucial for the formation of upward SWs.

astro-ph.SR↗

arXiv2018

Two-stage energy release process of a confined flare with double HXR peaks

A complete understanding of the onset and subsequent evolution of confined flares has not been achieved. Earlier studies mainly analyzed disk events so as to reveal their magnetic topology and cause of confinement. In this study, taking advantage of a tandem of instruments working at different wavelengths of X-rays, EUVs, and microwaves, we present dynamic details of a confined flare observed on the northwestern limb of the solar disk on July 24th, 2016. The entire dynamic evolutionary process starting from its onset is consistent with a loop-loop interaction scenario. The X-ray profiles manifest an intriguing double-peak feature. From spectral fitting, it is found that the first peak is non-thermally dominated while the second peak is mostly multi-thermal with a hot (~10 MK) and a super-hot (~30 MK) component. This double-peak feature is unique in that the two peaks are clearly separated by 4 minutes, and the second peak reaches up to 25-50 keV; in addition, at energy bands above 3 keV the X-ray fluxes decline significantly between the two peaks. This, together with other available imaging and spectral data, manifest a two-stage energy release process. A comprehensive analysis is carried out to investigate the nature of this two-stage process. We conclude that the second stage with the hot and super-hot sources mainly involves direct heating through loop-loop reconnection at a relatively high altitude in the corona. The uniqueness of the event characteristics and complete data set make the study a nice addition to present literature on solar flares.

astro-ph.SR↗

arXiv2017

The Origin of Solar Filament Plasma Inferred from in situ Observations of Elemental Abundances

Solar filaments/prominences are one of the most common features in the corona, which may lead to energetic coronal mass ejections (CMEs) and flares when they erupt. Filaments are about one hundred times cooler and denser than the coronal material, and physical understanding of their material origin remains controversial. Two types of scenarios have been proposed: one argues that the filament plasma is brought into the corona from photosphere or chromosphere through a siphon or evaporation/injection process, while the other suggests that the material condenses from the surrounding coronal plasma due to thermal instability. The elemental abundance analysis is a reasonable clue to constrain the models, as the siphon or evaporation/injection model would predict that the filament material abundances are close to the photospheric or chromospheric ones, while the condensation model should have coronal abundances. In this letter, we analyze the elemental abundances of a magnetic cloud that contains the ejected filament material. The corresponding filament eruption occurred on 1998 April 29, accompanying an M6.8 class soft X-ray flare located at the heliographic coordinates S18E20 (NOAA 08210) and a fast halo CME with the linear velocity of 1374 km s$^{-1}$ near the Sun. We find that the abundance ratios of elements with low and high First Ionization Potential such as Fe/O, Mg/O, and Si/O are 0.150, 0.050, and 0.070, respectively, approaching their corresponding photospheric values 0.065, 0.081, and 0.066, which does not support the coronal origin of the filament plasma.

astro-ph.SR↗

arXiv2016

An Eruptive Hot-Channel Structure Observed at Metric Wavelength as a Moving Type-IV Solar Radio Burst

Hot channel (HC) structure, observed in the high-temperature passbands of the AIA/SDO, is regarded as one candidate of coronal flux rope which is an essential element of solar eruptions. Here we present the first radio imaging study of an HC structure in the metric wavelength. The associated radio emission manifests as a moving type-IV (t-IVm) burst. We show that the radio sources co-move outwards with the HC, indicating that the t-IV emitting energetic electrons are efficiently trapped within the structure. The t-IV sources at different frequencies present no considerable spatial dispersion during the early stage of the event, while the sources spread gradually along the eruptive HC structure at later stage with significant spatial dispersion. The t-IV bursts are characterized by a relatively-high brightness temperature ($\sim$ 10$^{7}$ $-$ 10$^{9}$ K), a moderate polarization, and a spectral shape that evolves considerably with time. This study demonstrates the possibility of imaging the eruptive HC structure at the metric wavelength and provides strong constraints on the t-IV emision mechanism, which, if understood, can be used to diagnose the essential parameters of the eruptive structure.

astro-ph.SR↗

arXiv2016

A Statistical Study of the Average Iron Charge Distributions inside Magnetic Clouds for Solar Cycle 23

Magnetic clouds (MCs) are the interplanetary counterpart of coronal magnetic flux ropes. They can provide valuable information to reveal the flux rope characteristics at their eruption stage in the corona, which are unable to be explored in situ at present. In this paper, we make a comprehensive survey of the average iron charge state ( Fe) distributions inside 96 MCs for solar cycle 23 using ACE (Advanced Composition Explorer) data. As the Fe in the solar wind are typically around 9+ to 11+, the Fe charge state is defined as high when the Fe is larger than 12+, which implies the existence of a considerable amount of Fe ions with high charge states (e.g., \geq 16+). The statistical results show that the Fe distributions of 92 (~ 96%) MCs can be classified into four groups with different characteristics. In group A (11 MCs), the Fe shows a bimodal distribution with both peaks higher than 12+. Group B (4 MCs) presents a unimodal distribution of Fe with its peak higher than 12+. In groups C (29 MCs) and D (48 MCs), the Fe remains higher and lower than 12+ throughout ACE passage through the MC, respectively. Possible explanations to these distributions are discussed.

astro-ph.SR↗

arXiv2015

Evidence of the Solar EUV hot channel as a magnetic flux rope from remote-sensing and in-situ observations

Hot channels (HCs), high temperature erupting structures in the lower corona of the Sun, have been proposed as a proxy of magnetic flux ropes (MFRs) since their initial discovery. However, it is difficult to make definitive proof given the fact that there is no direct measurement of magnetic field in the corona. An alternative way is to use the magnetic field measurement in the solar wind from in-situ instruments. On 2012 July 12, an HC was observed prior to and during a coronal mass ejection (CME) by the AIA high-temperature images. The HC is invisible in the EUVI low-temperature images, which only show the cooler leading front (LF). However, both the LF and an ejecta can be observed in the coronagraphic images. These are consistent with the high temperature and high density of the HC and support that the ejecta is the erupted HC. In the meanwhile, the associated CME shock was identified ahead of the ejecta and the sheath through the COR2 images, and the corresponding ICME was detected by \textit{ACE}, showing the shock, sheath and magnetic cloud (MC) sequentially, which agrees with the coronagraphic observations. Further, the MC contained a low-ionization-state center and a high-ionization-state shell, consistent with the pre-existing HC observation and its growth through magnetic reconnection. All of these observations support that the MC detected near the Earth is the counterpart of the erupted HC in the corona for this event. Therefore, our study provides strong observational evidence of the HC as an MFR.

astro-ph.SR↗

arXiv2015

Acceleration phases of a solar filament during its eruption

Filament eruptions often lead to coronal mass ejections (CMEs), which can affect critical technological systems in space and on the ground when they interact with the geo-magnetosphere in high speeds. Therefore, it is an important issue to investigate the acceleration mechanisms of CMEs in solar/space physics. Based on observations and simulations, the resistive magnetic reconnection and the ideal instability of magnetic flux rope have been proposed to accelerate CMEs. However, it remains elusive whether both of them play a comparable role during a particular eruption. It has been extremely difficult to separate their contributions as they often work in a close time sequence during one fast acceleration phase. Here we report an intriguing filament eruption event, which shows two apparently separated fast acceleration phases and provides us an excellent opportunity to address the issue. Through analyzing the correlations between velocity (acceleration) and soft (hard) X-ray profiles, we suggest that the instability and magnetic reconnection make a major contribution during the first and second fast acceleration phases, respectively. Further, we find that both processes have a comparable contribution to accelerate the filament in this event.

astro-ph.SR↗

arXiv2015

First Taste of Hot Channel in Interplanetary Space

Hot channel (HC) is a high temperature ($\sim$10 MK) structure in the inner corona revealed first by Atmospheric Imaging Assembly (AIA) on board \textit{Solar Dynamics Observatory}. Eruption of HC is often associated with flare and coronal mass ejection. Previous studies suggest that HC is a good proxy of magnetic flux rope (MFR) in the inner corona, in addition to another well-known MFR candidate, the prominence-cavity structure that is with a normal coronal temperature ($\sim$1-2 MK). In this paper, we report a high temperature structure (HTS, $\sim$1.5 MK) contained in an interplanetary coronal mass ejection induced by an HC eruption. According to the observations of bidirectional electrons, high temperature and density, strong magnetic field, and its association with the shock, sheath, and plasma pile-up region, we suggest that the HTS is the interplanetary counterpart of the HC. The scale of the measured HTS is around 14 R$_\odot$, and it maintained a much higher temperature than the background solar wind even at 1 AU. It is significantly different from the typical magnetic clouds (MCs), which usually have a much lower temperature. Our study suggests that the existence of a corotating interaction region ahead of the HC formed a magnetic container to inhibit the HC expansion and cooling down to a low temperature.

astro-ph.SR↗

arXiv2014

Direct observations of magnetic flux rope formation during a solar coronal mass ejection

Coronal mass ejections (CMEs) are the most spectacular eruptive phenomena in the solar atmosphere. It is generally accepted that CMEs are results of eruptions of magnetic flux ropes (MFRs). However, a heated debate is on whether MFRs pre-exist before the eruptions or they are formed during the eruptions. Several coronal signatures, \textit{e.g.}, filaments, coronal cavities, sigmoid structures and hot channels (or hot blobs), are proposed as MFRs and observed before the eruption, which support the pre-existing MFR scenario. There is almost no reported observation about MFR formation during the eruption. In this letter, we present an intriguing observation of a solar eruptive event occurred on 2013 November 21 with the Atmospheric Imaging Assembly on board the \textit{Solar Dynamic Observatory}, which shows a detailed formation process of the MFR during the eruption. The process started with the expansion of a low-lying coronal arcade, possibly caused by the flare magnetic reconnection underneath. The newly-formed ascending loops from below further pushed the arcade upward, stretching the surrounding magnetic field. The arcade and stretched magnetic field lines then curved-in just below the arcade vertex, forming an X-point. The field lines near the X-point continued to approach each other and a second magnetic reconnection was induced. It is this high-lying magnetic reconnection that led to the formation and eruption of a hot blob ($\sim$ 10 MK), presumably a MFR, producing a CME. We suggest that two spatially-separated magnetic reconnections occurred in this event, responsible for producing the flare and the hot blob (CME), respectively.

astro-ph.SR↗

arXiv2014

Temperature evolution of magnetic flux rope in a failed solar eruption

In this presentation, we report for the first time the detailed temperature evolution process of the magnetic flux rope in a failed solar eruption. Occurred on January 05, 2013, the flux rope was impulsively accelerated to a speed of ~ 400 km/s in the first minute, then decelerated and came to a complete stop in two minutes. The failed eruption resulted in a large-size high-lying (~ 100 Mm above the surface) high-temperature "fire ball" sitting in the corona for more than two hours. The time evolution of the thermal structure of the flux rope was revealed through the differential emission measure analysis technique, which produced temperature maps using observations of the Atmospheric Imaging Assembly on board Solar Dynamic Observatory. The average temperature of the flux rope steadily increased from ~ 5 MK to ~ 10 MK during the first nine minutes of the evolution, which was much longer than the rise time (about three minutes) of the associated soft X-ray flare. We suggest that the flux rope be heated by the energy release of the continuing magnetic reconnection, different from the heating of the low-lying flare loops, which is mainly produced by the chromospheric plasma evaporation. The loop arcade overlying the flux rope was pushed up by ~ 10 Mm during the attempted eruption. The pattern of the velocity variation of the loop arcade strongly suggests that the failure of the eruption be caused by the strapping effect of the overlying loop arcade.

physics.space-ph↗