SearcharxivSearch

arXiv subjects

I. Charaev

Publications and source records attributed to I. Charaev.

11 recordsLinked to original sources

Low-Temperature Heat Transport under Phonon Confinement in Nanostructures

Heat transport in bulk materials is well described using the Debye theory of 3D vibrational modes (phonons) and the acoustic match model. However, in cryogenic nanodevices, phonon wavelengths exceed device dimensions, leading to confinement effects that standard models fail to address. With the growing application of low-temperature devices in communication, sensing, and quantum technologies, there is an urgent need for models that accurately describe heat transport under confinement. We introduce a computational approach to obtain phonon heat capacity and heat transport rates between solids in various confined geometries, that can be easily integrated into, e.g., the standard two-temperature model. Confinement significantly reduces heat capacity and may slow down heat transport. We have validated our model in experiments on strongly disordered NbTiN superconducting nanostructures, widely used in highly efficient single-photon detectors, and we argue that confinement is due to their polycrystalline granular structure. These findings point to potential advances in cryogenic device performance through tailored material and microstructure engineering.

cond-mat.mes-hall

Fundamental limits of few-layer NbSe$_2$ microbolometers at terahertz frequencies

The rapid development of infrared spectroscopy, observational astronomy, and scanning near-field microscopy has been enabled by the emergence of sensitive mid- and far-infrared photodetectors. Owing to their exceptional signal-to-noise ratio and fast photoresponse, superconducting hot-electron bolometers (HEBs) have become a critical component in these applications. While superconducting HEBs are traditionally made from sputtered superconducting thin films like Nb or NbN, the potential of layered van der Waals (vdW) superconductors is untapped at THz frequencies. Here, we report the fabrication of superconducting HEBs out of few-layer NbSe$_2$ microwires. By improving the interface between NbSe$_2$ and metal leads connected to a broadband antenna, we overcome the impedance mismatch between this vdW superconductor and the radio frequency (RF) readout circuitry that allowed us to achieve large responsivity THz detection over the range from 0.13 to 2.5 THz with minimum noise equivalent power of 7~pW$\sqrt{Hz}$. Using the heterodyne sub-THz mixing technique, we reveal that NbSe$_2$ superconducting HEBs are relatively fast and feature a characteristic response time in the nanosecond range limited by the slow heat escape to the bath through a SiO$_2$ layer, on which they are assembled, in agreement with energy relaxation model. Our work expands the family of materials for superconducting HEBs technology, reveals NbSe$_2$ as a promising platform, and offers a reliable protocol for the in-lab production of custom bolometers using the vdW assembly technique.

cond-mat.supr-con

Single-photon detection using large-scale high-temperature MgB$_2$ sensors at 20 K

Ultra-fast single-photon detectors with high current density and operating temperature can benefit space and ground applications, including quantum optical communication systems, lightweight cryogenics for space crafts, and medical use. Here we demonstrate magnesium diboride (MgB$_2$) thin-film superconducting microwires capable of single-photon detection at 1.55 $\mu$m optical wavelength. We used helium ions to alter the properties of MgB$_2$, resulting in microwire-based detectors exhibiting single-photon sensitivity across a broad temperature range of up to 20 K, and detection efficiency saturation for 1 $\mu$m wide microwires at 3.7 K. Linearity of detection rate vs incident power was preserved up to at least ~100 Mcps. Despite the large active area of up to 400$\times$400 $\mu$m$^2$, the reset time was found to be as low as $\sim1$ ns. Our research provides new possibilities for breaking the operating temperature limit and maximum single-pixel count rate, expanding the detector area, and raises inquiries about the fundamental mechanisms of single-photon detection in high-critical-temperature superconductors.

cond-mat.supr-con

Phonon heat capacity and disorder: new opportunities for performance enhancement of superconducting devices

We experimentally study for the first time the self-heating normal domain in magnetic field using nanowires made of granular NbTiN films with sub-10~nm thicknesses. Specifically, we found that at temperatures below 10 K, the heat capacity of phonons in such films is reduced with respect to predictions of the Debye model. Moreover, as the temperature decreases, the phonon heat capacity reduces quicker than the Debye prediction. These effects strengthen when the film thickness decreases. We attribute the observed reduction in the heat capacity to the size effect, which arises from the confinement of phonon modes within the grains; a phenomenon that has been predicted but not yet observed. These findings hold great importance in understanding the role of heat transport in superconducting electronic devices and have the potential for practical applications in mid-infrared photon sensing with superconducting nanowire detectors.

cond-mat.supr-con

Single-photon detection using high-temperature superconductors

The detection of individual quanta of light is important for quantum computation, fluorescence lifetime imaging, single-molecule detection, remote sensing, correlation spectroscopy, and more. Thanks to their broadband operation, high detection efficiency, exceptional signal-to-noise ratio, and fast recovery times, superconducting nanowire single-photon detectors (SNSPDs) have become a critical component in these applications. The operation of SNSPDs based on conventional superconductors, which have a low critical temperature ($T_c$), requires costly and bulky cryocoolers. This motivated exploration of other superconducting materials with higher $T_c$ that would enable single-photon detection at elevated temperatures, yet this task has proven exceedingly difficult. Here we show that with proper processing, high-$T_c$ cuprate superconductors can meet this challenge. We fabricated superconducting nanowires (SNWs) out of thin flakes of Bi$_2$Sr$_2$CaCu$_2$O$_{8+\delta}$ and La$_{1.55}$Sr$_{0.45}$CuO$_4$/La$_2$CuO$_4$ (LSCO-LCO) bilayer films and demonstrated their single-photon response up to $25$ and $8$ K, respectively. The single-photon operation is revealed through the linear scaling of the photon count rate (PCR) on the radiation power. Both of our cuprate-based SNSPDs exhibited single-photon sensitivity at the technologically-important $1.5$ ${\mu}$m telecommunications wavelength. Our work expands the family of superconducting materials for SNSPD technology, opens the prospects of raising the temperature ceiling, and raises important questions about the underlying mechanisms of single-photon detection by unconventional superconductors.

cond-mat.supr-con

Compact microwave kinetic inductance nanowire galvanometer for cryogenic detectors at 4.2 K

We present a compact current sensor based on a superconducting microwave lumped-element resonator with a nanowire kinetic inductor, operating at 4.2 K. The sensor is suitable for multiplexed readout in GHz range of large-format arrays of cryogenic detectors. The device consists of a lumped-element resonant circuit, fabricated from a single 4-nm-thick superconducting layer of niobium nitride. Thus, the fabrication and operation is significantly simplified in comparison to state-of-the-art approaches. Because the resonant circuit is inductively coupled to the feed line the current to be measured can directly be injected without having the need of an impedance matching circuit, reducing the system complexity. With the proof-of-concept device we measured a current noise floor δImin of 10 pA/Hz1/2 at 10 kHz. Furthermore, we demonstrate the ability of our sensor to amplify a pulsed response of a superconducting nanowire single-photon detector using a GHz-range carrier for effective frequency-division multiplexing.

physics.ins-det

Proximity effect model of ultra-narrow NbN strips

We show that narrow superconducting strips in superconducting (S) and normal (N) states are universally described by the model presenting them as lateral NSN proximity systems in which the superconducting central band is sandwiched between damaged edge-bands with suppressed superconductivity.The width of the superconducting band was experimentally determined from the value of magnetic field at which the band transits from the Meissner state to the static vortex state. Systematic experimental study of 4.9 nm thick NbN strips with widths in the interval from 50 nm to 20 $μ$m, which are all smaller than the Pearl's length, demonstrates gradual evolution of the temperature dependence of the critical current with the change of the strip width.

physics.app-ph

Enhancement of superconductivity in NbN nanowires by negative electron-beam lithography with positive resist

We performed comparative experimental investigation of superconducting NbN nanowires which were prepared by means of positive-and negative electron-beam lithography with the same positive tone Poly-methyl-methacrylate (PMMA) resist. We show that nanowires with a thickness 4.9 nm and widths less than 100 nm demonstrate at 4.2 K higher critical temperature and higher density of critical and retrapping currents when they are prepared by negative lithography. Also the ratio of the experimental critical-current to the depairing critical current is larger for nanowires prepared by negative lithography. We associate the observed enhancement of superconducting properties with the difference in the degree of damage that nanowire edges sustain in the lithographic process. A whole range of advantages which is offered by the negative lithography with positive PMMA resist ensures high potential of this technology for improving performance metrics of superconducting nanowire singe-photon detectors.

physics.app-ph

Characteristics of superconducting tungsten silicide WxSi1-x for single photon detection

Superconducting properties of three series of amorphous WxSi1-x films with different thickness and stoichiometry were investigated by dc transport measurements in a magnetic field up to 9 T. These amorphous WxSi1-x films were deposited by magnetron co-sputtering of the elemental source targets onto silicon substrates at room temperature and patterned in form of bridges by optical lithography and reactive ion etching. Analysis of the data on magnetoconductivity allowed us to extract the critical temperature, superconducting coherence length, magnetic penetration depth, and diffusion coefficient of electrons in the normal state as a function of film thickness for each stoichiometry. Two basic time constants were derived from transport and time-resolving measurements. A dynamic process of the formation of a hot-spot was analyzed in the framework of a diffusion-based vortex-entry model. We used the two stage diffusion approach and defined a hotspot size by assuming that the quasi-particles and normal-state electrons have the equal diffusion constant. Our findings are consistent with the most recent results on a hot-spot relaxation time in the WxSi1-x superconducting nanowire single-photon detector. In the 5 nm thick W0.85Si0.15 film the hot-spot has a diameter of 105 nm at the peak of the number of non-equilibrium quasi-particles.

cond-mat.supr-con

Current dependence of the hot-spot response spectrum of superconducting single-photon detectors with different layouts

We show that avoiding bends in a current-carrying superconducting nanowire enhances the probability for low energy photons to be detected and that this enhancement is entirely due to the increase in the experimentally achievable critical current. We studied nanowires shaped as either meander or spiral. The spirals had different layouts, a double-spiral layout with an S-turn in the middle and a single-spiral layout without such turn. Nanowires were prepared from films of niobium nitride with a thickness of 5 nm. For specimens with each layout we measured the spectra of the single-photon response in the wavelength range from 400 nm to 1600 nm and defined the cut-off wavelength $λc$ beyond which the response rolls off. The largest and the smallest $λc$ were found for the single-spiral layout and for the meander, respectively. For all three layouts the relationship between $λc$ and the relative bias current falls onto a universal curve which has been predicted earlier in the framework of the modified hot-spot model. For the single-spiral layout, the efficiency of photon detection at wavelengths smaller than $λc$ reaches the expected absorbance of the spiral structure and the timing jitter per unit length of the nanowire has the smallest value.

cond-mat.supr-con

Asymmetry in the effect of magnetic field on photon detection and dark counts in bended nanostrips

Current crowding in the bends of superconducting nano-structures not only restricts measurable critical current in such structures but also redistributes local probabilities for dark and light counts to appear. Using structures from strips in the form of a square spiral which contain bends with the very same curvature with respect to the directions of bias current and external magnetic field, we have shown that dark counts as well as light counts at small photon energies originate from areas around the bends. The minimum in the rate of dark counts reproduces the asymmetry of the maximum critical current density as function of the magnetic field. Contrary, the minimum in the rate of light counts demonstrate opposite asymmetry. The rate of light counts become symmetric at large currents and fields. Comparing locally computed absorption probabilities for photons and the simulated threshold detection current we found the approximate locations of areas near bends which deliver asymmetric light counts. Any asymmetry is absent in Archimedean spiral structures without bends.

physics.optics