arXiv subjects

I. Deppner

Publications and source records attributed to I. Deppner.

13 recordsLinked to original sources

arXiv2026

Demonstrating CBM Capabilities by $\Lambda$ Baryon Reconstruction in Ni+Ni Collisions with the mCBM Experiment at SIS18 of GSI/FAIR

The Compressed Baryonic Matter (CBM) experiment at the upcoming Facility for Antiproton and Ion Research (FAIR) is a high-rate fixed-target experiment designed to investigate nuclear matter at extreme baryon densities in relativistic nucleus-nucleus collisions. To enable high-statistics measurements of rare probes, CBM is designed to operate at event rates up to 10 MHz. This necessitates the development of fast and radiation-tolerant detectors, self-triggered front-end electronics, a free-streaming data acquisition architecture, and real-time event reconstruction capabilities. Prototype versions and pre-series productions of the CBM detector systems have been deployed in the mini-CBM demonstrator setup mCBM - an experimental precursor comprising sub-components of all major CBM systems, installed at the SIS18 facility of GSI/FAIR within the FAIR Phase-0 program. In 2024, Ni+Ni collisions at a kinetic beam energy of 1.93 AGeV and an average interaction rate of about 250 kHz were successfully recorded. This dataset enables a detailed evaluation of the operational performance of the detector systems as well as the complete CBM data chain, while the reconstruction of rare $\Lambda$ baryons serves as a natural benchmark. This paper presents the first results on $\Lambda$ signal reconstruction with the mCBM experiment, demonstrating the readiness of the detector technologies and the data chain for the upcoming full-scale CBM experiment.

physics.ins-det↗

arXiv2021

Commissioning and testing of pre-series triple GEM prototypes for CBM-MuCh in the mCBM experiment at the SIS18 facility of GSI

Large area triple GEM chambers will be employed in the first two stations of the MuCh system of the CBM experiment at the upcoming Facility for Antiproton and Ion Research FAIR in Darmstadt/Germany. The GEM detectors have been designed to take data at an unprecedented interaction rate (up to 10 MHz) in nucleus-nucleus collisions in CBM at FAIR. Real-size trapezoidal modules have been installed in the mCBM experiment and tested in nucleus-nucleus collisions at the SIS18 beamline of GSI as a part of the FAIR Phase-0 program. In this report, we discuss the design, installation, commissioning, and response of these GEM modules in detail. The response has been studied using the free-streaming readout electronics designed for the CBM-MuCh and CBM-STS detector system. In free-streaming data, the first attempt on an event building based on the timestamps of hits has been carried out, resulting in the observation of clear spatial correlations between the GEM modules in the mCBM setup for the first time. Accordingly, a time resolution of $\sim$15\,ns have been obtained for the GEM detectors.

physics.ins-det↗

arXiv2020

Detector control system for the CBM-TOF

A high-performance time-of-flight (TOF) MRPC wall is being built for the CBM experiment at FAIR for charged hadron identification. The detector control system for the TOF system will be based on EPICS. All components like power supplies for low and high voltages, power distribution boxes, gas control and front-end electronics (FEE) are controlled and monitored. In a test, called mini-CBM, all these functionalities are implemented and tested. For monitoring the detector environment and the status of the front-end electronics, a slow control application is implemented based on IPbus, which is an FPGA-based slow control bus used for the TOF data acquisition system. In addition to the functions of control and monitoring, exception handling and data archiving services are implemented as well. This system has been fully verified in beam tests in 2019 at GSI.

physics.ins-det↗

arXiv2018

The CBM Time-of-Flight system

The Compressed Baryonic Matter spectrometer (CBM) is a future fixed-target heavy-ion experiment located at the Facility for Anti-proton and Ion Research (FAIR) in Darmstadt, Germany. The key element in CBM providing hadron identification at incident beam energies between 2 and 11 AGeV (for Au-nuclei) will be a 120 m$^2$ large Time-of-Flight (ToF) wall composed of Multi-gap Resistive Plate Chambers (MRPC) with a system time resolution better than 80 ps. Aiming for an interaction rate of 10 MHz for Au+Au collisions the MRPCs have to cope with an incident particle flux between 0.1~kHz/cm$^2$ and 100~kHz/cm$^2$ depending on their location. Characterized by granularity and rate capability the actual conceptual design of the ToF-wall foresees 6 different counter granularities and 4 different counter designs. In order to elaborate the final MRPC design of these counters several heavy-ion in-beam and cosmic tests were performed. In this contribution we present the conceptual design of the TOF wall and in particular discuss performance results of full-size MRPC prototypes.

physics.ins-det↗

arXiv2018

Wide acceptance measurement of the K$^-$/K$^+$ ratio from Ni+Ni collisions at 1.91A GeV

The FOPI Collaboration at the GSI SIS-18 synchrotron measured charged kaons from central and semi-central collisions of Ni+Ni at a beam energy of 1.91A GeV. We present the distribution of the K$^-$\K$^+$ ratio on the energy vs polar angle plane in the nucleon-nucleon center-of-mass frame, with and without subtraction of the contribution of $\phi$(1020) meson decays to the K$^-$ yield. The acceptance of the current experiment is substantially wider compared to the previous measurement of the same colliding system. The ratio of K$^-$ to K$^+$ energy spectra is expected to be sensitive to the in-medium modifications of basic kaon properties like mass. Recent results obtained by the HADES Collaboration at 1.23A and 1.76A GeV indicate that after inclusion of the $\phi$ meson decay contribution to the K$^-$ production no difference between the slopes of the K$^-$ and K$^+$ energy spectra is observed within uncertainties. For our data a linear fit to this ratio obtained after subtraction of the $\phi$ meson contribution still shows a decrease with kinetic energy, although a constant value cannot be rejected. The contribution of $\Lambda(1520) \rightarrow p\text{K}^-$ decays estimated from fitting the thermal model to the experimental yields appears to be another factor of moderate relevance.

nucl-ex↗

arXiv2017

Determination of N* amplitudes from associated strangeness production in p+p collisions

We present the first determination of the energy-dependent production amplitudes of N$^{*}$ resonances with masses between 1650 MeV/c$^{2}$ and 1900 MeV/c$^{2}$ for an excess energy between $0$ and $600$ MeV. A combined Partial Wave Analysis of seven exclusively reconstructed data samples for the reaction p+p $\rightarrow pK\Lambda$ measured by the COSY-TOF, DISTO, FOPI and HADES collaborations in fixed target experiments at kinetic energies between 2.14 and 3.5 GeV is used to determine the amplitude of the resonant and non-resonant contributions.

nucl-ex↗

arXiv2016

Performance studies of MRPC prototypes for CBM

Multi-gap Resistive Plate Chambers (MRPCs) with multi-strip readout are considered to be the optimal detector candidate for the Time-of-Flight (ToF) wall in the Compressed Baryonic Matter (CBM) experiment. In the R&D phase MRPCs with different granularities, low-resistive materials and high voltage stack configurations were developed and tested. Here, we focus on two prototypes called HD-P2 and THU-strip, both with strips of 27 cm$^2$ length and low-resistive glass electrodes. The HD-P2 prototype has a single-stack configuration with 8 gaps while the THU-strip prototype is constructed in a double-stack configuration with 2 $\times$ 4 gaps. The performance results of these counters in terms of efficiency and time resolution carried out in a test beam time with heavy-ion beam at GSI in 2014 are presented in this proceeding.

physics.ins-det↗

arXiv2016

Time and position resolution of high granularity, high counting rate MRPC for the inner zone of the CBM-TOF wall

Multi-gap RPC prototypes with readout on a multi-strip electrode were developed for the small polar angle region of the CBM-TOF subdetector, the most demanding zone in terms of granularity and counting rate. The prototypes are based on low resistivity ($\sim$10$^{10}$ $\Omega$cm) glass electrodes for performing in high counting rate environment. The strip width/pitch size was chosen such to fulfill the impedance matching with the front-end electronics and the granularity requirements of the innermost zone of the CBM-TOF wall. The in-beam tests using secondary particles produced in heavy ion collisions on a Pb target at SIS18 - GSI Darmstadt and SPS - CERN were focused on the performance of the prototype in conditions similar to the ones expected at SIS100/FAIR. An efficiency larger than 98\% and a system time resolution in the order of 70~-~80~ps were obtained in high counting rate and high multiplicity environment.

physics.ins-det↗

arXiv2016

Centrality dependence of subthreshold $\phi$ meson production in Ni+Ni collisions at 1.9A GeV

We analysed the $\phi$ meson production in central Ni+Ni collisions at the beam kinetic energy of 1.93A GeV with the FOPI spectrometer and found the production probability per event of $[8.6 ~\pm~ 1.6 ~(\text{stat}) \pm 1.5 ~(\text{syst})] \times 10^{-4}$. This new data point allows for the first time to inspect the centrality dependence of the subthreshold $\phi$ meson production in heavy-ion collisions. The rise of $\phi$ meson multiplicity per event with mean number of participants can be parameterized by the power function with exponent $\alpha = 1.8 \pm 0.6$. The ratio of $\phi$ to $\text{K}^-$ production yields seems not to depend within the experimental uncertainties on the collision centrality, and the average of measured values was found to be $0.36 \pm 0.05$.

nucl-ex↗

arXiv2015

Strange meson production in Al+Al collisions at 1.9A GeV

The production of K$^+$, K$^-$ and $\varphi$(1020) mesons is studied in Al+Al collisions at a beam energy of 1.9A GeV which is close or below the production threshold in NN reactions. Inverse slopes, anisotropy parameters, and total emission yields of K$^{\pm}$ mesons are obtained. A comparison of the ratio of kinetic energy distributions of K$^-$ and K$^+$ mesons to the HSD transport model calculations suggests that the inclusion of the in-medium modifications of kaon properties is necessary to reproduce the ratio. The inverse slope and total yield of $\phi$ mesons are deduced. The contribution to K$^-$ production from $\phi$ meson decays is found to be [17 $\pm$ 3 (stat) $^{+2}_{-7}$ (syst)] %. The results are in line with previous K$^{\pm}$ and $\phi$ data obtained for different colliding systems at similar incident beam energies.

nucl-ex↗

arXiv2014

Influence of $\phi$ mesons on negative kaons in Ni+Ni collisions at 1.91A GeV beam energy

$\phi$ and K$^-$ mesons from Ni+Ni collisions at the beam energy of 1.91A GeV have been measured by the FOPI spectrometer, with a trigger selecting central and semi-central events amounting to 51% of the total cross section. The phase space distributions, and the total yield of K$^-$, as well as the kinetic energy distribution and the total yield of $\phi$ mesons are presented. The $\phi$\K$^-$ ratio is found to be $0.44 \pm 0.07(\text{stat}) ^{+0.18}_{-0.12} (\text{syst})$, meaning that about 22% of K$^-$ mesons originate from the decays of $\phi$ mesons, occurring mostly in vacuum. The inverse slopes of direct kaons are up to about 15 MeV larger than the ones extracted within the one-source model, signalling that a considerable share of gap between the slopes of K$^+$ and K$^-$ could be explained by the contribution of $\phi$ mesons to negative kaons.

nucl-ex↗

arXiv2014

Azimuthal Emission Patterns of $K^{+}$ and of $ K^{-} $ Mesons in Ni + Ni Collisions near the Strangeness Production Threshold

Azimuthal emission patterns of $K^\pm$ mesons have been measured in Ni + Ni collisions with the FOPI spectrometer at a beam kinetic energy of 1.91 A GeV. The transverse momentum $p_{T}$ integrated directed and elliptic flow of $K^{+}$ and $K^{-}$ mesons as well as the centrality dependence of $p_{T}$ - differential directed flow of $K^{+}$ mesons are compared to the predictions of HSD and IQMD transport models. The data exhibits different propagation patterns of $K^{+}$ and $K^{-}$ mesons in the compressed and heated nuclear medium and favor the existence of a kaon-nucleon in-medium potential, repulsive for $K^{+}$ mesons and attractive for $K^{-}$ mesons.

nucl-ex↗

arXiv2009

Measurement of the in-medium K0 inclusive cross section in pi- -induced reactions at 1.15 GeV/c

The K0 meson production by pi- mesons of 1.15 GeV/c momentum on C, Al, Cu, Sn and Pb nuclear targets was measured with the FOPI spectrometer at the SIS accelerator of GSI. Inclusive production cross-sections and the momentum distributions of K0 mesons are compared to scaled elementary production cross-sections and to predictions of theoretical models describing the in-medium production of kaons. The data represent a new reference for those models, which are widely used for interpretation of the strangeness-production in heavy-ion collisions. The presented results demonstrate the sensitivity of the kaon production to the reaction amplitudes inside nuclei and point to the existence of a repulsive KN-potential of 20+-5 MeV at normal nuclear matter density.

nucl-ex↗