arXiv subjects

I. Hernandez

Publications and source records attributed to I. Hernandez.

9 recordsLinked to original sources

arXiv2025

Characterization of micro-SPECT system based on Timepix detector

In this work, the characteristics of a prototype SPECT system based on the Timepix readout chip, with a MURA type encoding mask, were evaluated. The set-up has a small field of view and can be used in preclinical studies of drugs in small laboratory animals. Despite many existing test protocols developed and described in pertinent documents of national standard bodies and IAEA recommendation, they are not suitable for microtomographic systems based on semiconductor pixel detectors due to different detector technology, high spatial resolution and small area of interest. To measure their characteristics, special phantoms were developed, with a small "hot~region". Such micro-SPECT parameters as spatial resolution, contrast, linearity and system efficiency were studied using Tc-99m source. The detector calibration and data preprocessing are described.

physics.ins-det↗

arXiv2024

Measurement of the response function of the PIENU calorimeter

Measurements of the response function of the PIENU NaI(T$\ell$) and CsI crystal calorimeter using a monochromatic 70 MeV/c positron beam at various incidence angles are described. The experimental setup and relevant physical processes involved were simulated using Geant4 to reproduce positron energy spectra. Monte Carlo simulations were compared with experimental data across ten calorimeter-beam angles and showed good agreement. This allowed the validation of simulation parameters that were essential for precise measurements of pion decays.

hep-ex↗

arXiv2024

First Measurement of Correlated Charge Noise in Superconducting Qubits at an Underground Facility

We measure space- and time-correlated charge jumps on a four-qubit device, operating 107 meters below the Earth's surface in a low-radiation, cryogenic facility designed for the characterization of low-threshold particle detectors. The rock overburden of this facility reduces the cosmic ray muon flux by over 99% compared to laboratories at sea level. Combined with 4$\pi$ coverage of a movable lead shield, this facility enables quantifiable control over the flux of ionizing radiation on the qubit device. Long-time-series charge tomography measurements on these weakly charge-sensitive qubits capture discontinuous jumps in the induced charge on the qubit islands, corresponding to the interaction of ionizing radiation with the qubit substrate. The rate of these charge jumps scales with the flux of ionizing radiation on the qubit package, as characterized by a series of independent measurements on another energy-resolving detector operating simultaneously in the same cryostat with the qubits. Using lead shielding, we achieve a minimum charge jump rate of 0.19$^{+0.04}_{-0.03}$ mHz, almost an order of magnitude lower than that measured in surface tests, but a factor of roughly eight higher than expected based on reduction of ambient gammas alone. We operate four qubits for over 22 consecutive hours with zero correlated charge jumps at length scales above three millimeters.

quant-ph↗

arXiv2024

Cryogenic optical beam steering for superconducting device calibration

We have developed a calibration system based on a micro-electromechanical systems (MEMS) mirror that is capable of delivering an optical beam over a wavelength range of 180 -- 2000 nm (0.62 -- 6.89 eV) in a sub-Kelvin environment. This portable, integrated system can steer the beam over a $\sim$3 cm $\times$ 3 cm area on the surface of any sensor with a precision of $\sim$100 $\mu$m, enabling characterization of device response as a function of position. This fills a critical need in the landscape of calibration tools for sub-Kelvin devices, including those used for dark matter detection and quantum computing. These communities have a shared goal of understanding the impact of ionizing radiation on device performance, which can be pursued with our system. This paper describes the design of the first-generation calibration system and the results from successfully testing its performance at room temperature and 20 mK.

quant-ph↗

arXiv2024

Estimating the Energy Threshold of Phonon-mediated Superconducting Qubit Detectors Operated in an Energy-Relaxation Sensing Scheme

In recent years, the lack of a conclusive detection of WIMP dark matter at the 10 GeV/c$^{2}$ mass scale and above has encouraged development of low-threshold detector technology aimed at probing lighter dark matter candidates. Detectors based on Cooper-pair-breaking sensors have emerged as a promising avenue for this detection due to the low (meV-scale) energy required for breaking a Cooper pair in most superconductors. Among them, devices based on superconducting qubits are interesting candidates for sensing due to their observed sensitivity to broken Cooper pairs. We have developed an end-to-end G4CMP-based simulation framework and have used it to evaluate performance metrics of qubit-based devices operating in a gate-based "energy relaxation" readout scheme, akin to those used in recent studies of qubit sensitivity to ionizing radiation. We find that for this readout scheme, the qubit acts as a phonon sensor with an energy threshold ranging down to $\simeq$0.4 eV for near-term performance parameters.

physics.ins-det↗

arXiv2019

3D strain in 2D materials: Experimental test in unsupported monolayer graphene under pressure

Previous Raman measurements on supported graphene under high pressure reported a very different shift rate of in-plane phonon frequency of graphene (16 cm$^{-1}$GPa$^{-1}$) from graphite (4.7 cm$^{-1}$GPa$^{-1}$), implying very different in-plane anharmonicity that graphene gets stiffer than graphite in-plane under the same pressure. It was suggested that it could be due to the adhesion of graphene to substrates. We have therefore performed high pressure Raman measurements on unsupported graphene and we find a similar in-plane stiffness and anharmonicity of graphene (5.4 cm$^{-1}$GPa$^{-1}$) to graphite. On the other hand, the out-of-plane stiffness of graphene is hard to define, due to the 2D nature of graphene. However, we estimate a similar out-of-plane stiffness of graphene (1.4$\pm$295 GPa) to that of graphite (38.7$\pm$7 GPa), by measuring its effect on the shift of the in-plane phonon frequency with pressure.

cond-mat.mtrl-sci↗

arXiv2015

The Significance of Bundling Effects on Carbon Nanotubes' Response to Hydrostatic Compression

The study of the G-mode pressure coefficients of carbon nanotubes, reflecting the stiff sp2 bond pressure dependence, is essential to the understanding of their extraordinary mechanical properties as well as fundamental mechanics. However, it is hindered by the availability of carbon nanotubes samples only as bundles or isolated with surfactants. Octadecylamine functionalized carbon nanotubes are mostly of a single diameter and can be stably dispersed in 1, 2-dichloroethane and chloroform without surfactants. Here we perform high pressure Raman spectroscopy on these tubes and obtain their experimental G-mode pressure coefficients for individual tubes and bundles. The G-plus pressure coefficient for bundles is only about half of that for individual tubes in 1, 2-dichloroethane and is about two-thirds in chloroform. The G-minus pressure coefficient for bundles is about one-third of G-plus in 1, 2-dichloroethane and about the same in chloroform. These results for the first time provide unambiguous experimental evidence of the significant effect of bundling on carbon nanotubes' G-mode pressure coefficients, identifying it as one of the major reasons for the lack of consensus on what the values should be in the literature.

cond-mat.mtrl-sci↗

arXiv2012

Pressure coefficients of Raman modes of carbon nanotubes resolved by chirality: Environmental effect on graphene sheet

Studies of the mechanical properties of single-walled carbon nanotubes are hindered by the availability only of ensembles of tubes with a range of diameters. Tunable Raman excitation spectroscopy picks out identifiable tubes. Under high pressure, the radial breathing mode shows a strong environmental effect shown here to be largely independent of the nature of the environment . For the G-mode, the pressure coefficient varies with diameter consistent with the thick-wall tube model. However, results show an unexpectedly strong environmental effect on the pressure coefficients. Reappraisal of data for graphene and graphite gives the G-mode Grueuneisen parameter gamma = 1.34 and the shear deformation parameter beta = 1.34.

cond-mat.mes-hall↗

arXiv2012

Raman excitation spectroscopy of carbon nanotubes: effects of pressure medium and pressure

Raman excitation and emission spectra for the radial breathing mode (RBM) are reported, together with a preliminary analysis. From the position of the peaks on the two-dimensional plot of excitation resonance energy against Raman shift, the chiral indices (m, n) for each peak are identified. Peaks shift from their positions in air when different pressure media are added - water, hexane, sulphuric acid - and when the nanotubes are unbundled in water with surfactant and sonication. The shift is about 2 - 3 cm-1 in RBM frequency, but unexpectedly large in resonance energy, being spread over up to 100meV for a given peak. This contrasts with the effect of pressure. The shift of the peaks of semiconducting nanotubes in water under pressure is orthogonal to the shift from air to water. This permits the separation of the effects of the pressure medium and the pressure, and will enable the true pressure coefficients of the RBM and the other Raman peaks for each (m, n) to be established unambiguously.

cond-mat.mes-hall↗