arXiv subjects

I. Rodionov

Publications and source records attributed to I. Rodionov.

12 recordsLinked to original sources

arXiv2024

Angstrom-scale ion-beam engineering of ultrathin buried oxides for quantum and neuro-inspired computing

Multilayer nanoscale systems incorporating buried ultrathin tunnel oxides, 2D materials, and solid electrolytes are crucial for next-generation logics, memory, quantum and neuro-inspired computing. Still, an ultrathin layer control at angstrom scale is challenging for cutting-edge applications. Here we introduce a scalable approach utilizing focused ion-beam annealing for buried ultrathin oxides engineering with angstrom-scale thickness control. Our molecular dynamics simulations of Ne+ irradiation on Al/a-AlOx/Al structure confirms the pivotal role of ion generated crystal defects. We experimentally demonstrate its performance on Josephson junction tunning in the resistance range of 2 to 37% with a standard deviation of 0.86% across 25x25 mm chip. Moreover, we showcase +-17 MHz frequency control (+-0.172 A tunnel barrier thickness) for superconducting transmon qubits with coherence times up to 500 us, which is promising for useful fault-tolerant quantum computing. This work ensures ultrathin multilayer nanosystems engineering at the ultimate scale by depth-controlled crystal defects generation.

cond-mat.mes-hall↗

arXiv2024

Lumped-element two-section impedance-matched SNAIL parametric amplifier

Broadband impedance-matched Josephson parametric amplifiers are key components for high-fidelity single-shot multi-qubit readout. Nowadays, several types of impedance matched parametric amplifiers have been proposed: the first is an impedance-matched parametric amplifier based on a Klopfenstein taper, and the second is an impedance-matched parametric amplifier based on auxiliary resonators. Here, we present the quantum-limited 3-wave-mixing lumped-element SNAIL parametric amplifier with two-units impedance matching transformer. A two-pole Chebyshev matching network with shunted resonators based on parallel-plate capacitors and superconducting planar coil. Operating in a flux-pumped mode, we experimentally demonstrate an average gain of $15dB$ across a $600MHz$ bandwidth, along with an average saturation power of $-107dBm$ and quantum-limited noise temperature.

quant-ph↗

arXiv2022

Broadband SNAIL parametric amplifier with microstrip impedance transformer

Josephson parametric amplifiers have emerged as a promising platform for quantum information processing and squeezed quantum states generation. Travelling wave and impedance-matched parametric amplifiers provide broad bandwidth for high-fidelity single-shot readout of multiple qubit superconducting circuits. Here, we present a quantum-limited 3-wave-mixing parametric amplifier based on superconducting nonlinear asymmetric inductive elements (SNAILs), whose useful bandwidth is enhanced with an on-chip two-section impedance-matching circuit based on microstrip transmission lines. The amplifier dynamic range is increased using an array of sixty-seven SNAILs with 268 Josephson junctions, forming a nonlinear quarter-wave resonator. Operating in a current-pumped mode, we experimentally demonstrate an average gain of $17 dB$ across $300 MHz$ bandwidth, along with an average saturation power of $- 100 dBm$, which can go as high as $- 97 dBm$ with quantum-limited noise performance. Moreover, the amplifier can be fabricated using a simple technology with just a one e-beam lithography step. Its central frequency is tuned over a several hundred megahertz, which in turn broadens the effective operational bandwidth to around $1.5 GHz$.

quant-ph↗

arXiv2007

Development of innovative micropattern gaseous detectors with resistive electrodes and first results of their applications

The paper summarizes our latest progress in the development of newly introduced micro pattern gaseous detectors with resistive electrodes. These resistive electrodes protect the detector and the front-end electronics in case of occasional discharges and thus make the detectors very robust and reliable in operation. As an example, we describe in greater detail a new recently developed GEM-like detector, fully spark-protected with electrodes made of resistive kapton. We discovered that all resistive layers used in these studies (including kapton), that are coated with photosensitive layers, such as CsI, can be used as efficient photo cathodes for detectors operating in a pulse counting mode. We describe the first applications of such detectors combined with CsI or SbCs photo cathodes for the detection of UV photons at room and cryogenic temperatures.

physics.ins-det↗

arXiv2006

A New GEM-like Imaging Detector with Electrodes Coated with Resistive Layers

We have developed and tested several prototypes of GEM-like detectors with electrodes coated with resistive layers: CuO or CrO. These detectors can operate stably at gains close to 10E5 and they are very robust. We discovered that the cathodes of these detectors could be coated by CsI layers and in such a way the detectors gain high efficiency for the UV photons. We also demonstrated that such detectors can operate stably in the cascade mode and high overall gains (~10E6) are reachable. This opens applications in several areas, for example in RICH or in noble liquid TPCs. Results from the first applications of these devices for UV photon detection at room and cryogenic temperatures are given.

physics.ins-det↗

arXiv2006

The first applications of novel gaseous detectors for UV visualization

We have demonstrated experimentally that recently developed gaseous detectors combined with solid or gaseous photo-cathodes have exceptionally low noise and high quantum efficiency for UV photons while being solar blind. For this reason they can be used for the detection of weak UV sources in daylight conditions. These detectors are extremely robust, can operate in poor gas conditions and are cheap. We present the first results of their applications to hyper-spectroscopy and flame detection in daylight conditions.

physics.ins-det↗

arXiv2006

A Novel UV Photon Detector with Resistive Electrodes

In this study we present first results from a new detector of UV photons: a thick gaseous electron multiplier (GEM) with resistive electrodes, combined with CsI or CsTe/CsI photocathodes. The hole type structure considerably suppresses the photon and ion feedback, whereas the resistive electrodes protect the detector and the readout electronics from damage by any eventual discharges. This device reaches higher gains than a previously developed photosensitive RPC and could be used not only for the imaging of UV sources, flames or Cherenkov light, for example, but also for the detection of X-rays and charged particles.

physics.ins-det↗

arXiv2005

Advanced Photodetectors for Hyperspectroscopy and Other Applications

Hyperspectroscopy is a new method of surface image taking, providing simultaneously high position and spectral resolutions which allow one to make some conclusions about chemical compositions of the surfaces. We are now studying applications of the hyperspctroscopic technique to be used for medicine. This may allow one to develop early diagnostics of some illnesses, as for example, skin cancer. For image taking advanced MCPs are currently used, sensitive in the spectral interval of 450-850 nm. One of the aims of this work is to extend the hyperspectrocpic method to the UV region of spectra: 185-280 nm. For this we have developed and successfully tested innovative 1D and 2D UV sealed photosensitive gaseous detectors with resistive electrodes. These detectors are superior MCPs due to the very low rate of noise pulses and thus due to the high signal to noise ratio. Other important features of these detectors are that they have excellent position resolutions - 30 micron in digital form, are vibration stable and are spark protected. The first results from the application of these detectors for spectroscopy, hyperspectroscopy and the flame detection are presented.

physics.ins-det↗

arXiv2005

Novel Single Photon Detectors for UV Imaging

There are several applications which require high position resolution UV imaging. For these applications we have developed and successfully tested a new version of a 2D UV single photon imaging detector based on a microgap RPC. The main features of such a detectors is the high position resolution - 30 micron in digital form and the high quantum efficiency (1-8% in the spectral interval of 220-140 nm). Additionally, they are spark- protected and can operate without any feedback problems at high gains, close to a streamer mode. In attempts to extend the sensitivity of RPCs to longer wavelengths we have successfully tested the operation of the first sealed parallel-plate gaseous detectors with CsTe photocathodes. Finally, the comparison with other types of photosensitive detectors is given and possible fields of applications are identified.

physics.ins-det↗

arXiv2002

The Development and Study of High-Position Resolution (50 micron) RPCs for Imaging X-rays and UV photons

Nowadays, commonly used Resistive Plate Chambers (RPCs) have counting rate capabilities of ~10E4Hz/cm2 and position resolutions of ~1cm. We have developed small prototypes of RPCs (5x5 and 10x10cm2) having rate capabilities of up to 10E7Hz/cm2 and position resolutions of 50 micron("on line" without application of any treatment method like "center of gravity"). The breakthrough in achieving extraordinary rate and position resolutions was only possible after solving several serious problems: RPC cleaning and assembling technology, aging, spurious pulses and afterpulses, discharges in the amplification gap and along the spacers. High-rate, high-position resolution RPCs can find a wide range of applications in many different fields, for example in medical imaging. RPCs with the cathodes coated by CsI photosensitive layer can detect ultraviolet photons with a position resolution that is better than ~30 micron. Such detectors can also be used in many applications, for example in the focal plane of high resolution vacuum spectrographs or as image scanners.

physics.ins-det↗

arXiv2002

Beyond the RICH: Innovative Photosensitive Gaseous Detectors for new Fields of Applications

We have developed and successfully used several innovative designs of detectors with solid photocathodes. The main advantage of these detectors is that rather high gains (>10E4) can be achieved in a single multiplication step. This is possible by, for instance, exploiting the secondary electron multiplication and limiting the energy of the steamers by distributed resistivity. The single step approach also allows a very good position resolution to be achieved in some devices: 50 micron on line without applying any treatment method (like center of gravity). The main focus of our report is new fields of applications for these detectors and the optimization of their designs for such purposes.

physics.ins-det↗

arXiv2002

Novel position-sensitive gaseous detectors with solid photo-cathodes

Currently a revolution is happening in the development of gaseous detectors of photons and particles. Recently developed gaseous detectors with solid photocathodes are now replacing photosensitive wire chambers, which dominated for years in high energy and space flight experiments. We will review the main developments in this field as well as their applications in high-energy physics, medicine, industry and plasma diagnostics. New results on solid photocathodes coupled with gaseous micropattern/wire detectors will also be presented.

physics.ins-det↗