Searcharxiv⌕ Search

arXiv subjects

I. Vivarelli

Publications and source records attributed to I. Vivarelli.

10 recordsLinked to original sources
arXiv2023

Exposing a fibre-based dual-readout calorimeter to a positron beam

A prototype of a dual-readout calorimeter using brass capillary tubes surrounding scintillating and clear plastic optical fibres was tested using beams of particles with energies between 10 and 100 GeV produced by the CERN SPS. The scope of the test was to characterise the performance of the tube-based detector response to positrons in terms of linearity, energy resolution, and lateral granularity. After calibrating the detector and processing the output signal to correct for the energy dependency on the particle impact point, the linearity of the measurement was found to be better than 1\%. The positron response was compared to that predicted by a Geant4-based simulation, finding good agreement both in terms of energy resolution and shower profile. The detector resolution was estimated to be well described by a stochastic term of 14.5\% with a negligible constant term.

physics.ins-det↗
arXiv2022

Dual-Readout Calorimetry for Future Experiments Probing Fundamental Physics

In this White Paper for the 2021 Snowmass process, we detail the status and prospects for dual-readout calorimetry. While all calorimeters allow estimation of energy depositions in their active material, dual-readout calorimeters aim to provide additional information on the light produced in the sensitive media via, for example, wavelength and polarization, and/or a precision timing measurements, allowing an estimation of the shower-by-shower particle content. Utilizing this knowledge of the shower particle content may allow unprecedented energy resolution for hadronic particles and jets and new types of particle flow algorithms. We also discuss the impact continued development of this kind of calorimetry could have on precision on Higgs boson property measurements at future colliders.

physics.ins-det↗
arXiv2018

Tests of a dual-readout fiber calorimeter with SiPM light sensors

In this paper, we describe the first tests of a dual-readout fiber calorimeter in which silicon photomultipliers are used to sense the (scintillation and Cherenkov) light signals. The main challenge in this detector is implementing a design that minimizes the optical crosstalk between the two types of fibers, which are located very close to each other and carry light signals that differ in intensity by about a factor of 60. The experimental data, which were obtained with beams of high-energy electrons and muons as well as in lab tests, illustrate to what extent this challenge was met. The Cherenkov light yield, a limiting factor for the energy resolution of this type of calorimeter, was measured to be about twice that of the previously tested configurations based on photomultiplier tubes. The lateral profiles of electromagnetic showers were measured on a scale of millimeters from the shower axis and significant differences were found between the profiles measured with the scintillating and the Cherenkov fibers.

physics.ins-det↗
arXiv2009

The Evolution of FTK, a Real-Time Tracker for Hadron Collider Experiments

We describe the architecture evolution of the highly-parallel dedicated processor FTK, which is driven by the simulation of LHC events at high luminosity (1034 cm-2 s-1). FTK is able to provide precise on-line track reconstruction for future hadronic collider experiments. The processor, organized in a two-tiered pipelined architecture, execute very fast algorithms based on the use of a large bank of pre-stored patterns of trajectory points (first tier) in combination with full resolution track fitting to refine pattern recognition and to determine off-line quality track parameters. We describe here how the high luminosity simulation results have produced a new organization of the hardware inside the FTK processor core.

physics.ins-det↗
arXiv2009

Development of FTK architecture: a fast hardware track trigger for the ATLAS detector

The Fast Tracker (FTK) is a proposed upgrade to the ATLAS trigger system that will operate at full Level-1 output rates and provide high quality tracks reconstructed over the entire detector by the start of processing in Level-2. FTK solves the combinatorial challenge inherent to tracking by exploiting the massive parallelism of Associative Memories (AM) that can compare inner detector hits to millions of pre-calculated patterns simultaneously. The tracking problem within matched patterns is further simplified by using pre-computed linearized fitting constants and leveraging fast DSP's in modern commercial FPGA's. Overall, FTK is able to compute the helix parameters for all tracks in an event and apply quality cuts in approximately one millisecond. By employing a pipelined architecture, FTK is able to continuously operate at Level-1 rates without deadtime. The system design is defined and studied using ATLAS full simulation. Reconstruction quality is evaluated for single muon events with zero pileup, as well as WH events at the LHC design luminosity. FTK results are compared with the tracking capability of an offline algorithm.

physics.ins-det↗
arXiv2009

Proceedings of the Workshop on Monte Carlo's, Physics and Simulations at the LHC PART II

These proceedings collect the presentations given at the first three meetings of the INFN "Workshop on Monte Carlo's, Physics and Simulations at the LHC", held at the Frascati National Laboratories in 2006. The first part of these proceedings contains pedagogical introductions to several basic topics of both theoretical and experimental high pT LHC physics. The second part collects more specialised presentations.

hep-ph↗
arXiv2009

Proceedings of the Workshop on Monte Carlo's, Physics and Simulations at the LHC PART I

These proceedings collect the presentations given at the first three meetings of the INFN "Workshop on Monte Carlo's, Physics and Simulations at the LHC", held at the Frascati National Laboratories in 2006. The first part of these proceedings contains pedagogical introductions to several basic topics of both theoretical and experimental high pT LHC physics. The second part collects more specialised presentations.

hep-ph↗
arXiv2006

A PMT-Block test bench

The front-end electronics of the ATLAS hadronic calorimeter (Tile Cal) is housed in a unit, called {\it PMT-Block}. The PMT-Block is a compact instrument comprising a light mixer, a PMT together with its divider and a {\it 3-in-1} card, which provides shaping, amplification and integration for the signals. This instrument needs to be qualified before being assembled on the detector. A PMT-Block test bench has been developed for this purpose. This test bench is a system which allows fast, albeit accurate enough, measurements of the main properties of a complete PMT-Block. The system, both hardware and software, and the protocol used for the PMT-Blocks characterisation are described in detail in this report. The results obtained in the test of about 10000 PMT-Blocks needed for the instrumentation of the ATLAS (LHC-CERN) hadronic Tile Calorimeter are also reported.

physics.ins-det↗
arXiv2004

Prospects for the Search for a Standard Model Higgs Boson in ATLAS using Vector Boson Fusion

The potential for the discovery of a Standard Model Higgs boson in the mass range m_H < 2 m_Z in the vector boson fusion mode has been studied for the ATLAS experiment at the LHC. The characteristic signatures of additional jets in the forward regions of the detector and of low jet activity in the central region allow for an efficient background rejection. Analyses for the H -> WW and H -> tau tau decay modes have been performed using a realistic simulation of the expected detector performance. The results obtained demonstrate the large discovery potential in the H -> WW decay channel and the sensitivity to Higgs boson decays into tau-pairs in the low-mass region around 120 GeV.

hep-ph↗
arXiv2002

The Higgs Working Group: Summary Report (2001)

Report of the Higgs working group for the Workshop `Physics at TeV Colliders', Les Houches, France, 21 May - 1 June 2001. It contains 7 separate sections: A. Theoretical Developments B. Higgs Searches at the Tevatron C. Experimental Observation of an invisible Higgs Boson at LHC D. Search for the Standard Model Higgs Boson using Vector Boson Fusion at the LHC E. Study of the MSSM channel $A/H \to ττ$ at the LHC F. Searching for Higgs Bosons in $t\bar t H$ Production G. Studies of Charged Higgs Boson Signals for the Tevatron and the LHC

hep-ph↗