arXiv subjects

Igor Konorov

Publications and source records attributed to Igor Konorov.

8 recordsLinked to original sources

arXiv2026

Characterisation of a Thick Pixelated Silicon Detector for Electron Spectroscopy of Neutron Beta Decay

Silicon detectors are commonly used for spectroscopy of low-energy particles. For electrons in the 1 MeV range, a rather large thickness of 2mm is required to entirely stop the electrons and commercial options are scarce. With the instrument PERC at the FRM II, we aim to measure beta spectra from polarised and unpolarised neutrons in order to determine the axial-vector coupling constant, the element $V_\textrm{ud}$ of the Cabibbo-Kobayashi-Maskawa quark-mixing matrix, and to search for hypothetical scalar and tensor contributions. We present the characterisation of a commercially available, pixelated detector to assess its suitability to measure the entire electron energy spectrum of free neutron beta decay.

physics.ins-det↗

arXiv2021

Performance of the Unified Readout System of Belle II

The Belle II experiment at the SuperKEKB collider at KEK, Tsukuba, Japan has successfully started taking data with the full detector in March 2019. Belle II is a luminosity frontier experiment of the new generation to search for physics beyond the Standard Model of elementary particles, from precision measurements of a huge number of B and charm mesons and tau leptons. In order to read out the events at a high rate from the seven subdetectors of Belle II, we adopt a highly unified readout system, including a unified trigger timing distribution system (TTD), a unified high speed data link system (Belle2link), and a common backend system to receive Belle2link data. Each subdetector frontend readout system has a field-programmable gate array (FPGA) in which unified firmware components of the TTD receiver and Belle2link transmitter are embedded. The system is designed for data taking at a trigger rate up to 30 kHz with a dead-time fraction of about 1% in the frontend readout system. The trigger rate is still much lower than our design. However, the background level is already high due to the initial vacuum condition and other accelerator parameters, and it is the most limiting factor of the accelerator and detector operation. Hence the occupancy and radiation effects to the frontend electronics are rather severe, and they cause various kind of instabilities. We present the performance of the system, including the achieved trigger rate, dead-time fraction, stability, and discuss the experience gained during the operation.

physics.ins-det↗

arXiv2021

Performance of the Data Handling Hub readout system for the Belle II pixel detector

The SuperKEKB accelerator in Tsukuba, Japan is providing e$^+$e$^-$ beams for the Belle II experiment since March 2019. To deal with the aimed peak luminosity being forty times higher than the one recorded at Belle, a pixel detector based on DEPFET technology has been installed. It features a long integration time of 20 $μ$s resulting in an expected data rate of 20 GByte/s (160 GBit/s) at a maximum occupancy of 3 %. To deal with this high amount of data, the data handling hub (DHH) has been developed. It contains all necessary functionality for the control and readout of the detector. In this paper we describe the architecture and features of the DHH system. Further we will show the key performance characteristics after one year of operation.

physics.ins-det↗

arXiv2019

Towards a first measurement of the free neutron bound beta decay detecting hydrogen atoms at a throughgoing beamtube in a high flux reactor

In addition to the common 3-body decay of the neutron $n\rightarrow p e^-\overline{ν_e}$ there should exist an effective 2-body subset with the electron and proton forming a Hydrogen bound state with well defined total momentum, total spin and magnetic quantum numbers. The atomic spectroscopic analysis of this bound system can reveal details about the underlying weak interaction as it mirrors the helicity distributions of all outgoing particles. Thus, it is unique in the information it carries, and an experiment unravelling this information is an analogue to the Goldhaber experiment performed more than 60 years ago. The proposed experiment will search for monoenergetic metastable BoB H atoms with 326 eV kinetic energy, which are generated at the center of a throughgoing beamtube of a high-flux reactor (e.g., at the PIK reactor, Gatchina). Although full spectroscopic information is needed to possibly reveal new physics our first aim is to prove the occurrence of this decay and learn about backgrounds. Key to the detection is the identification of a monoerergtic line of hydrogen atoms occurring at a rate of about 1 $\rm{s}^{-1}$ in the environment of many hydrogen atoms, however having a thermal distribution of about room temperature. Two scenarios for velocity (energy) filtering are discussed in this paper. The first builds on an purely electric chopper system, in which metastable hydrogen atoms are quenched to their ground state and thus remain mostly undetectable. This chopper system employs fast switchable Bradbury Nielsen gates. The second method exploits a strongly energy dependent charge exchange process of metastable hydrogen picking up an electron while traversing an argon filled gas cell, turning it into manipulable charged hydrogen. The final detection of hydrogen occurs through multichannel plate (MCP) detector.

physics.ins-det↗

arXiv2014

FPGA Based Data Read-Out System of the Belle 2 Pixel Detector

The upgrades of the Belle experiment and the KEKB accelerator aim to increase the data set of the experiment by the factor 50. This will be achieved by increasing the luminosity of the accelerator which requires a significant upgrade of the detector. A new pixel detector based on DEPFET technology will be installed to handle the increased reaction rate and provide better vertex resolution. One of the features of the DEPFET detector is a long integration time of 20 μs, which increases detector occupancy up to 3 %. The detector will generate about 2 GB/s of data. An FPGA-based two-level read-out system, the Data Handling Hybrid, was developed for the Belle 2 pixel detector. The system consists of 40 read-out and 8 controller modules. All modules are built in μTCA form factor using Xilinx Virtex-6 FPGA and can utilize up to 4 GB DDR3 RAM. The system was successfully tested in the beam test at DESY in January 2014. The functionality and the architecture of the Belle 2 Data Handling Hybrid system as well as the performance of the system during the beam test are presented in the paper.

physics.ins-det↗

arXiv2013

First Results of the PixelGEM Central Tracking System for COMPASS

For its physics program with a high-intensity hadron beam of up to 2e7 particles/s, the COMPASS experiment at CERN requires tracking of charged particles scattered by very small angles with respect to the incident beam direction. While good resolution in time and space is mandatory, the challenge is imposed by the high beam intensity, requiring radiation-hard detectors which add very little material to the beam path in order to minimize secondary interactions. To this end, a set of triple-GEM detectors with a hybrid readout structure consisting of pixels in the beam region and 2-D strips in the periphery was designed and built. Successful prototype tests proved the performance of this new detector type, showing both extraordinary high rate capability and detection efficiency. The amplitude information allowed to achieve spatial resolutions about a factor of 10 smaller than the pitch and a time resolution close to the theoretical limit imposed by the layout. The PixelGEM central tracking system consisting of five detectors, slightly improved with respect to the prototype, was completely installed in the COMPASS spectrometer in spring 2008.

physics.ins-det↗

arXiv2009

Development of a GEM-TPC prototype

The use of GEM foils for the amplification stage of a TPC instead of a con- ventional MWPC allows one to bypass the necessity of gating, as the backdrift is suppressed thanks to the asymmetric field configuration. This way, a novel continuously running TPC, which represents one option for the PANDA central tracker, can be realized. A medium sized prototype with a diameter of 300 mm and a length of 600 mm will be tested inside the FOPI spectrometer at GSI using a carbon or lithium beam at intermediate energies (E = 1-3AGeV). This detector test under realistic experimental conditions should allow us to verify the spatial resolution for single tracks and the reconstruction capability for displaced vertexes. A series of physics measurement implying pion beams is scheduled with the FOPI spectrometer together with the GEM-TPC as well.

physics.ins-det↗

arXiv2009

New pixelized Micromegas detector for the COMPASS experiment

New Micromegas (Micro-mesh gaseous detectors) are being developed in view of the future physics projects planned by the COMPASS collaboration at CERN. Several major upgrades compared to present detectors are being studied: detectors standing five times higher luminosity with hadron beams, detection of beam particles (flux up to a few hundred of kHz/mm^2, 10 times larger than for the present detectors) with pixelized read-out in the central part, light and integrated electronics, and improved robustness. Studies were done with the present detectors moved in the beam, and two first pixelized prototypes are being tested with muon and hadron beams in real conditions at COMPASS. We present here this new project and report on two series of tests, with old detectors moved into the beam and with pixelized prototypes operated in real data taking condition with both muon and hadron beams.

physics.ins-det↗