arXiv subjects

Irakli Keshelashvili

Publications and source records attributed to Irakli Keshelashvili.

3 recordsLinked to original sources

arXiv2026

The Silicon Tracking System of the E16 experiment at J-PARC: construction, installation and commissioning in beam test experiments

The J-PARC E16 experiment aims to search for signatures of chiral symmetry restoration. It studies in-medium modifications of vector mesons that decay via the dielectron channel. The measurements use a high-intensity 30 GeV proton beam with C and Cu targets at rates up to 10 MHz. To achieve this, the experiment upgrades its tracking, by introducing innermost detector modules constructed with the same technology and procedures as the modules of the Silicon Tracking System (STS) of the Compressed Baryonic Matter (CBM) experiment at Facility for Antiproton and Ion Research (FAIR). A total of 15 modules were assembled, tested, characterized and then installed in the E16 detector setup. The detector was commissioned in a beam test experiment at Tsukuba, where the detector modules could be exposed to a 3 GeV electron beam. In preparation for the beam test the modules were characterized and calibrated, and performance studies were accomplished to assess the quality of the setup. During beamtime, three modules were operated and illuminated in two planes by the electron beam. This paper presents the results of the construction, characterization, commissioning, and operation of the E16-STS modules in beam test experiments.

physics.ins-det↗

arXiv2023

First Search for Axion-Like Particles in a Storage Ring Using a Polarized Deuteron Beam

Based on the notion that the local dark-matter field of axions or axion-like particles (ALPs) in our Galaxy induces oscillating couplings to the spins of nucleons and nuclei (via the electric dipole moment of the latter and/or the paramagnetic axion-wind effect), we establish the feasibility of a new method to search for ALPs in storage rings. Based on previous work that allows us to maintain the in-plane polarization of a stored deuteron beam for a few hundred seconds, we performed a first proof-of-principle experiment at the Cooler Synchrotron COSY to scan momenta near 970 MeV/c. This entailed a scan of the spin precession frequency. At resonance between the spin precession frequency of deuterons and the ALP-induced EDM oscillation frequency there will be an accumulation of the polarization component out of the ring plane. Since the axion frequency is unknown, the momentum of the beam and consequently the spin precession frequency were ramped to search for a vertical polarization change that would occur when the resonance is crossed. At COSY, four beam bunches with different polarization directions were used to make sure that no resonance was missed because of the unknown relative phase between the polarization precession and the axion/ALP field. A frequency window of 1.5-kHz width around the spin precession frequency of 121 kHz was scanned. We describe the experimental procedure and a test of the methodology with the help of a radiofrequency Wien filter located on the COSY ring. No ALP resonance was observed. As a consequence an upper limit of the oscillating EDM component of the deuteron as well as its axion coupling constants are provided.

hep-ex↗

arXiv2020

Development of a multi-channel power supply for silicon photo-multipliers used with inorganic scintillators

The motivation of the current R&D project is based upon the requirements of the JEDI international collaboration aiming to measure Electric Dipole Moments (EDMs) of charged particles in storage rings. One of the most important elements of such an experiment will be a specially designed polarimeter with the detection system based on a modular inorganic scintillator (LYSO crystal) calorimeter. The calorimeter modules are read out by Silicon Photo Multipliers (SiPMs). This paper describes the development of a multi-channel power supply for the polarimeter modules, providing very stable and clean bias voltages for SiPMs. In order to ensure the best possible performance of SiPMs in conjunction with the crystal-based calorimeter modules and to guarantee the required level of calorimeter stability, several quality requirements have to be met by the power supply. Additionally, it is required to provide features including remote control via the network, ramping of the output voltage, measuring and sending the information about its output voltages and currents, etc. The obtained results demonstrate that the goals for the JEDI polarimeter are met. The developed hardware will be useful in other fields of fundamental and applied research, medical diagnostic techniques and industry, where SiPMs are used.

physics.ins-det↗