SearcharxivSearch

arXiv subjects

Isaac F. Silvera

Publications and source records attributed to Isaac F. Silvera.

18 recordsLinked to original sources

Reflectance of Rhenium as a Function of Pressure in a Diamond Anvil Cell

We have measured the reflectance of rhenium in the visible region to pressures up to 100 GPa in a diamond anvil cell (DAC). By photographing the reflecting surface, we visually show that there are challenges to obtaining accurate values in a DAC for several reasons and propose some useful procedures. We also show that knowledge of the reflectance of rhenium can overcome the problem of absorption of light by diamonds when studying the reflectance of materials at high pressure in a DAC.

cond-mat.mtrl-sci

Finite element simulation of the liquid-liquid transition to metallic hydrogen

Hydrogen at high temperature and pressure undergoes a phase transition from a liquid molecular phase to a conductive atomic state, or liquid metallic hydrogen, sometimes referred to as the plasma phase transition (PPT). The PPT phase line was observed in a recent experiment studying laser-pulse heated hydrogen in a diamond anvil cell in the pressure range $\sim 100 - 170 \text{GPa}$ for temperatures up to $\sim 2000 \text{K}$. The experimental signatures of the transition are (i) a negative pressure-temperature slope, (ii) a plateau in the heating curve, assumed to be related to the latent heat of transformation, and (iii) an abrupt increase in the reflectance of the sample. We present a finite element simulation that accurately takes into account the position and time dependence of the heat deposited by the laser pulse. We calculate the heating curves and the sample reflectance and transmittance. This simulation confirms that the observed plateaus are related to the phase transition, however we find that large values of latent heat are needed and may indicate that dynamics at the transition are more complex than considered in current models. Finally, experiments are proposed that can distinguish between a change in optical properties due to a transition to a metallic state or due to closure of the bandgap in molecular hydrogen.

cond-mat.mtrl-sci

Comment on: Observation of a first order phase transition to metal hydrogen near 425 GPa

Loubeyre, Occelli, and Dumas (LOD) [1] claim to have produced metallic hydrogen (MH) at a pressure of 425 GPa, without the necessary supporting evidence of an insulator to metal transition. The paper is much ado about nothing. Most of the results have been reported earlier. Zha, Liu, and Hemley [2] studied hydrogen at low temperature up to 360 GPa in 2012; they reported absorption studies up to 0.1eV. Eremets et al [3] studied dense hydrogen up to 480 GPa using standard bevel diamonds. They reported darkening of the sample and electrical conductivity in which they reported semi-metallic behavior around 440 GPa. In 2016 Dias, Noked, and Silvera [4] reported hydrogen was opaque at 420 GPa. In 2017 Dias and Silvera observed atomic metallic hydrogen at 495 GPa in the temperature range 5.5-83 K [5].

cond-mat.other

Striking Isotope Effect on the Metallization Phase Lines of Liquid Hydrogen and Deuterium

Liquid atomic metallic hydrogen is the simplest, lightest, and most abundant of all liquid metals. The role of nucleon motions or ion dynamics has been somewhat ignored in relation to the dissociative insulator-metal transition. Almost all previous experimental high-pressure studies have treated the fluid isotopes, hydrogen and deuterium, with no distinction. Studying both hydrogen and deuterium at the same density, most crucially at the phase transition line, can experimentally reveal the importance of ion dynamics. We use static compression to study the optical properties of dense deuterium in the pressure region of 1.2-1.7 Mbar and measured temperatures up to ~3000 K. We observe an abrupt increase in reflectance, consistent with dissociation-induced metallization, at the transition. Here we show that at the same pressure (density) for the two isotopes, the phase line of this transition reveals a prominent isotopic shift, ~700 K. This shift is lower than the isotopic difference in the free-molecule dissociation energies, but it is still large considering the high density of the liquid and the complex many-body effects. Our work reveals the importance of quantum nuclear effects in describing the metallization transition and conduction properties in dense hydrogen systems at conditions of giant planetary interiors, and provides an invaluable benchmark for ab-initio calculations.

cond-mat.other

Conductivity and Dissociation in Metallic Hydrogen: Implications for Planetary Interiors

Liquid metallic hydrogen (LMH) was recently produced under static compression and high temperatures in bench-top experiments. Here, we report a study of the optical reflectance of LMH in the pressure region of 1.4-1.7 Mbar and use the Drude free-electron model to determine its optical conductivity. We find static electrical conductivity of metallic hydrogen to be 11,000-15,000 S/cm. A substantial dissociation fraction is required to best fit the energy dependence of the observed reflectance. LMH at our experimental conditions is largely atomic and degenerate, not primarily molecular. We determine a plasma frequency and the optical conductivity. Properties are used to analyze planetary structure of hydrogen rich planets such as Jupiter.

cond-mat.mtrl-sci

Observation of the Wigner-Huntington Transition to Solid Metallic Hydrogen

We have studied solid hydrogen under pressure at low temperatures. With increasing pressure we observe changes in the sample, going from transparent, to black, to a reflective metal, the latter studied at a pressure of 495 GPa. We have measured the reflectance as a function of wavelength in the visible spectrum finding values as high as 0.90 from the metallic hydrogen. We have fit the reflectance using a Drude free electron model to determine the plasma frequency of 30.1 eV at T= 5.5 K, with a corresponding electron carrier density of 6.7x1023 particles/cm3, consistent with theoretical estimates. The properties are those of a metal. Solid metallic hydrogen has been produced in the laboratory.

cond-mat.mtrl-sci

Expanded Comment on: Optical Properties of Fluid Hydrogen at the Transition to a Conducting State

We comment on a recent paper published by McWilliams et al claiming that high-pressure/high-temperature hydrogen is a semi-conductor or semi-metal, in conflict with all earlier measurements on this system which show that it is metallic. We point out problems and inconsistencies and propose an alternate interpretation such that their results can be compatible with the observation of metallic hydrogen.

cond-mat.mtrl-sci

New low temperature phase in dense hydrogen: The phase diagram to 421 GPa

In the quest to make metallic hydrogen at low temperatures a rich number of new phases have been found and the highest pressure ones have somewhat flat phase lines, around room temperature. We have studied hydrogen to static pressures of GPa in a diamond anvil cell and down to liquid helium temperatures, using infrared spectroscopy. We report a new phase at a pressure of GPa and T=5 K. Although we observe strong darkening of the sample in the visible, we have no evidence that this phase is metallic hydrogen.

cond-mat.other

No "Evidence for a new phase of dense hydrogen above 325 GPa"

In recent years there has been intense experimental activity to observe solid metallic hydrogen. Wigner and Huntington predicted that under extreme pressures insulating molecular hydrogen would dissociate and transition to atomic metallic hydrogen. Recently Dalladay-Simpson, Howie, and Gregoryanz reported a phase transition to an insulating phase in molecular hydrogen at a pressure of 325 GPa and 300 K. Because of its scientific importance we have scrutinized their experimental evidence to determine if their claim is justified. Based on our analysis, we conclude that they have misinterpreted their data: there is no evidence for a phase transition at 325 GPa.

cond-mat.other

New Phases and Dissociation-Recombination of Hydrogen Deuteride to 3.4 Megabar

We present infrared absorption studies of solid hydrogen deuteride to pressures as high as 3.4 megabar in a diamond anvil cell and temperatures in the range 5 to 295 K. Above 198 GPa the sample transforms to a mixture of HD ,H2 and D2, interpreted as a process of dissociation and recombination. Three new phases-lines are observed, two of which differ remarkably from those of the high-pressure homonuclear species, but none are metallic. The time-dependent spectral changes are analyzed to determine the molecular concentrations as a function of time; the nucleon exchange achieves steady state concentrations in ~20 hours at ~200 GPa.

cond-mat.other

A First-order Phase Transition to Metallic Hydrogen

The insulator-metal transition in hydrogen is one of the most outstanding problems in condensed matter physics. The high-pressure metallic phase is now predicted to be liquid atomic from T=0 K to very high temperatures. We have conducted measurements of optical properties of hot dense hydrogen in the region of 1.1-1.7 Mbar and up to 2200 K. We observe a first-order phase transition accompanied by changes in transmittance and reflectance characteristic of a metal. The phase line of this transition has a negative slope in agreement with theories of the so-called plasma phase transition.

cond-mat.mtrl-sci

Has Metallic Hydrogen Been Made in a Diamond Anvil Cell?

Eremets and Troyan recently reported a transition of molecular hydrogen to metallic hydrogen (MH) at a pressure of ~270 GPa and 300 K. The quest for MH has been going on since 1935 when Wigner and Huntington predicted solid H2 at 0 K would transition to solid H with an associated insulator-metal transition at high pressure. Since then, observation of MH in solid hydrogen has yet to be confirmed. Because of its scientific importance we have considered their experimental evidence to determine if their claim is justified. Based on our analysis there is no evidence for MH in their experiments.

cond-mat.other

Nanoshells as a high-pressure gauge analyzed to 200 GPa

In this article we present calculations which indicate that nanoshells can be used as a high pressure gauge in Diamond Anvil Cells (DACs). Nanoparticles have important advantages in comparison with the currently used ruby fluorescence gauge. Because of their small dimensions they can be spread uniformly over a diamond surface without bridging between the two diamond anvils. Furthermore their properties are measured by broad band optical transmission spectroscopy leading to a very large signal-to-noise ratio even in the multi-megabar pressure regime where ruby measurements become challenging. Finally their resonant frequencies can be tuned to lie in a convenient part of the visible spectrum accessible to CCD detectors. Theoretical calculations for a nanoshell with a SiO2 core and a golden shell, using both the hybridization model and Mie theory, are presented here. The calculations for the nanoshell in vacuum predict that nanoshells can indeed have a measurable pressure-dependent optical response desirable for gauges.However when the nanoshells are placed in commonly used DAC pressure media, resonance peak positions as a function of pressure are no longer single-valued and depend on the pressure media, rendering them impractical as a pressure gauge. To overcome these problems an alternative nanoparticle is studied: coating the nanoshell with an extra dielectric layer (SiO2) provides an easy way to shield the pressure gauge from the influence of the medium, leaving the compression of the particle due to the pressure as the main effect on the spectrum. We have analyzed the response to pressure up to 200 GPa. We conclude that a coated nanoshell could provide a new gauge for high-pressure measurements that has advantages over current methods.

cond-mat.mes-hall

Novel Methods to Create Multielectron Bubbles in Superfluid Helium

An equilibrium multielectron bubble in liquid helium is a fascinating object with a spherical two-dimensional electron gas on its surface. We describe two ways of creating them. MEBs have been observed in the dome of a cylindrical cell with an unexpectedly short lifetime; we show analytically why these MEBs can discharge by tunneling. Using a novel method, MEBs have been extracted from a vapor sheath around a hot filament in superfluid helium by applying electric fields up to 15 kV/cm, and photographed with high-speed video. Charges as high as 1.6x10-9 C (~1010 electrons) have been measured. The latter method provides a means of capture in an electromagnetic trap to allow the study of the extensive exciting properties of these elusive objects.

cond-mat.other

Thermionic Emission, Multielectron Bubbles, and A Novel Electron Collector in a Liquid Helium Environment

We study two techniques to create electrons in a liquid helium environment. One is thermionic emission of tungsten filaments in a low temperature cell in the vapor phase with a superfluid helium film covering all surfaces; the other is operating a glowing filament immersed in bulk liquid helium. We present both the steady state and rapid sweep I-V curves and the electron current yield. These curves, having a negative dynamic resistance region, differ remarkably from those of a vacuum tube filament. A novel low temperature vapor-phase electron collector for which the insulating helium film on the collector surface can be removed is used to measure emission current. We also discuss our achievement of producing multi-electron bubbles (MEBs) in liquid helium by a new method.

cond-mat.other

The Melting Line of Hydrogen at High Pressures

The insulator to metal transition in solid hydrogen was predicted over 70 years ago but the demonstration of this transition remains a scientific challenge. In this regard, a peak in the temperature vs. pressure melting line of hydrogen may be a possible precursor for metallization. However, previous measurements of the fusion curve of hydrogen have been limited in pressure by diffusion of hydrogen into the gasket or diamonds. To overcome this limitation we have used an innovative technique of pulsed laser heating of the sample and final peak in the melting line at P=64.7+-4GPa and T=1055+-20 K.

cond-mat.mtrl-sci

Electron Emission in Superfluid and Low-temperature Vapor Phase Helium

Tungsten filaments used as sources of electrons in a low temperature liquid or gaseous helium environment have remarkable properties of operating at thousands of degrees Kelvin in surroundings at temperatures of order 1 K. We provide an explanation of this performance in terms of important changes in the thermal transport mechanisms. The behavior can be cast as a first-order phase transition.

cond-mat.other

The effect of pressure on statics, dynamics and stability of multielectron bubbles

The effect of pressure and negative pressure on the modes of oscillation of a multi-electron bubble in liquid helium is calculated. Already at low pressures of the order of 10-100 mbar, these effects are found to significantly modify the frequencies of oscillation of the bubble. Stabilization of the bubble is shown to occur in the presence of a small negative pressure, which expands the bubble radius. Above a threshold negative pressure, the bubble is unstable.

cond-mat