arXiv subjects

Ivan Hofsajer

Publications and source records attributed to Ivan Hofsajer.

4 recordsLinked to original sources

arXiv2020

Optimal DG allocation and sizing in power system networks using swarm-based algorithms

Distributed generation (DG) units are power generating plants that are very important to the architecture of present power system networks. The benefit of the addition of these DG units is to increase the power supply to a network. However, the installation of these DG units can cause an adverse effect if not properly allocated and/or sized. Therefore, there is a need to optimally allocate and size them to avoid cases such as voltage instability and expensive investment costs. In this paper, two swarm-based meta-heuristic algorithms, particle swarm optimization (PSO) and whale optimization algorithm (WOA) were developed to solve optimal placement and sizing of DG units in the quest for transmission network planning. A supportive technique, loss sensitivity factors (LSF) was used to identify potential buses for optimal location of DG units. The feasibility of the algorithms was confirmed on two IEEE bus test systems (14- and 30-bus). Comparison results showed that both algorithms produce good solutions and they outperform each other in different metrics. The WOA real power loss reduction considering techno-economic factors in the IEEE 14-bus and 30-bus test system are 6.14 MW and 10.77 MW, compared to the PSOs' 6.47 MW and 11.73 MW respectively. The PSO has a more reduced total DG unit size in both bus systems with 133.45 MW and 82.44 MW compared to WOAs' 152.21 MW and 82.44 MW respectively. The paper unveils the strengths and weaknesses of the PSO and the WOA in the application of optimal sizing of DG units in transmission networks.

cs.NE↗

arXiv2019

Trends in the optimal location and sizing of electrical units in smart grids using meta-heuristic algorithms

The development of smart grids has effectively transformed the traditional grid system. This promises numerous advantages for economic values and autonomous control of energy sources. In smart grids development, there are various objectives such as voltage stability, minimized power loss, minimized economic cost and voltage profile improvement. Thus, researchers have investigated several approaches based on meta-heuristic optimization algorithms for the optimal location and sizing of electrical units in a distribution system. Meta-heuristic algorithms have been applied to solve different problems in power systems and they have been successfully used in distribution systems. This paper presents a comprehensive review on existing methods for the optimal location and sizing of electrical units in distribution networks while considering the improvement of major objective functions. Techniques such as voltage stability index, power loss index, and loss sensitivity factors have been implemented alongside the meta-heuristic optimization algorithms to reduce the search space of solutions for objective functions. However, these techniques can cause a loss of optimality. Another perceived problem is the inappropriate handling of multiple objectives, which can also affect the optimality of results. Hence, a recent method such as Pareto fronts generation has been developed to produce non-dominating solutions. This review shows a need for more research on (i) the effective handling of multiple objective functions, (ii) more efficient meta-heuristic optimization algorithms and/or (iii) better supporting techniques.

eess.SY↗

arXiv2018

Why Small, Cold and Quiet DC-DC Conversion is Impossible

Using the first law of thermodynamics and the Parseval-Plancheral theorem, it is shown that every DC-DC converter must trade-off size, heat and conducted electromagnetic noise. It is therefore fundamentally impossible to simultaneously reduce all three of these characteristics to their respective theoretical minimum values. A figure of merit is introduced which holistically captures the performance of an arbitrary DC-DC converter, this is called the converter's non-ideality and it has a target value of zero. It is derived using the first law of thermodynamics and is shown to be dependent on the efficiency and the root-mean-squared total harmonic distortion of the output voltage. Interestingly, it is also shown that: boost conversion is impossible without energy storage; ideal rectifiers convert all of the input power spectral density into DC (and introduces more noise in the process); the input current of any DC-DC converter scales with the gain of the device squared. Using an arbitrary DC-DC converter, the culprit of this inherent trade-off is shown to be the act of switching itself. Switching creates harmonics which need to be filtered or transformed into heat in order to get a pure DC voltage at the output of the converter. Even with ideal sub-systems, whether or not resonant conversion is employed, the result stands. The conclusion is that spreading of the switching noise is a primary goal in attempting to reach the impossible.

physics.gen-ph↗

arXiv2018

Random Switching for High Performance DC-DC Power Converters

Random Pulse Width Modulation (RPWM) has been successfully applied in power electronics for nearly 30 years. The effects of the various possible RPWM strategies on the Power Spectral Density have been thoroughly studied. Despite the effectiveness of RPWM in spreading harmonic content, an appeal is consistently made to maintain the textbook Pulse Width Modulation scheme 'on average'. Random Switching (RS) does away with this notion and probabilistically operates the switch. In addition to fulfilling several optimality conditions, including being the only viable switching strategy at the theoretical limit of performance and having lower switching losses than any other RPWM; RS allows for design of the DC behaviour separately from that of the PSD. The pulse amplitude probability affects the DC and total PSD. The first and second moment of the pulse length probability distribution affects the shape of the envelope of the noise of the PSD. The minimum pulse length acts like a selective harmonic filter. The PSD can therefore be shaped without external filtering by changing these probabilities. Gaussian and Huffman pulse length probabilities are shown to be good choices depending on whether real-time PSD control or spectrum usage are the design goal. In addition, it is shown that Cúk's state space averaging model applies to RS, with $D \to p$, hence no new tools are needed to understand the low frequency behavior or control performance. A benefit of closed loop random switching is that no filtering of the controlled variable is required. Randomly responding in a biased manner dependent on the error is hence shown to be useful. There are several good reasons to consider RS for high performance applications.

eess.SP↗