arXiv subjects

J. -F. Ostiguy

Publications and source records attributed to J. -F. Ostiguy.

8 recordsLinked to original sources

arXiv2024

Space charge dominated momentum spread and compensation strategies in the post-linac section of Proton Improvement Plan-II at Fermilab

The upcoming Proton Improvement Plan-II (PIP-II), designated for enhancements to the Fermilab accelerator complex, features a new 800 MeV superconducting linac and a Beam Transfer Line (BTL) to transport the beam to the existing Booster synchrotron. To mitigate the space charge tune shift associated with a high intensity accumulated beam, the low emittance linac beam is used to paint the ring phase space both transversely and longitudinally. To prevent losses caused by particles injected outside the rf separatrix while painting longitudinal phase space, the momentum spread of the incoming beam should not exceed 2.1 x 10^-4. Detailed simulations showed that due to space charge, the rms momentum spread increases to 4 x 10^-4 while it is transported in the BTL --about twice the allowable limit. In this paper, we outline a mitigation strategy involving a debuncher cavity. We discuss location, operating frequency, and gap voltage under both nominal and perturbed beam conditions, specifically accounting for momentum jitter. The impact of cavity misalignments is also assessed. The paper concludes by recommending an optimized configuration.

physics.acc-ph↗

arXiv2024

Full-Cycle Simulations of the Fermilab Booster

The Proton Improvement Plan phase II (PIP-II) project currently under construction at FNAL will replace the existing 400 MeV normal conducting linac with a new 800 MeV superconducting linac. The beam power in the downstream rapid-cycling Booster synchrotron will be doubled by raising the machine cycle frequency from 15 to 20 Hz and by increasing the injected beam intensity by a factor 1.5. This has to be accomplished without raising uncontrolled losses beyond the administrative limit of 500 W. In addition, slip-stacking efficiency in the Recycler, the next machine in the accelerator chain, sets an upper limit on the longitudinal emittance of the beam delivered by the Booster. As part of an effort to better understand potential losses and emittance blow-up in the Booster, we have been conducting full cycle 6D simulations using the code PyORBIT. The simulations include space charge, wall impedance effects and transition crossing. In this paper, we discuss our experience with the code and present representative results for possible operational scenarios.

physics.acc-ph↗

arXiv2022

Operation of the H- Linac at FNAL

The Fermi National Accelerator Laboratory (FNAL) Linac has been in operation for 52 years. In approximately four years, it will be replaced by a new 800 MeV superconducting machine, the PIP-II SRF Linac. In the current configuration, the Linac delivers H- ions at 400 MeV and injects protons by charge exchange into the Booster synchrotron. Despite its age, the Linac is the most stable accelerator in the FNAL complex, reliably sending 22 mA in daily operations. We will discuss the status of the operation, beam studies, and plans.

physics.acc-ph↗

arXiv2013

Design of MEBT for the Project X Injector Experiment at Fermilab

The Project X Injector Experiment (PXIE), a test bed for the Project X front end, will be completed at Fermilab at FY12-16. One of the challenging goals of PXIE is demonstration of the capability to form a 1 mA H- beam with an arbitrary selected bunch pattern from the initially 5 mA 162.5 MHz CW train. The bunch selection will be made in the Medium Energy Beam Transport (MEBT) at 2.1 MeV by diverting undesired bunches to an absorber. This paper presents the MEBT scheme and describes development of its elements, including the kickers and absorber.

physics.acc-ph↗

arXiv2013

PXIE Optics and Layout

The Project X Injector Experiment (PXIE) will serve as a prototype for the Project X front end. The aim is to validate the Project-X design and to decrease technical risks, known to be mainly related to the front end. PXIE will accelerate a 1 mA CW beam to about 25 MeV. It will consist of an ion source, LEBT, CW RFQ, MEBT, two SC cryomodules, a diagnostic section and a beam dump. A bunch-by-bunch chopper located in the MEBT section will allow formation of an arbitrary bunch structure. PXIE deviates somewhat from the current Project-X front end concept in that it provides additional instrumentation and relies on a reduced number of kickers for bunch chopping; the diagnostic section also include an RF separator to allow studying extinction of removed bunches. The paper discusses the main requirements and constraints motivating the facility layout and optics. Final adjustments to the Project X front end design, if needed, will be based on operational experience gained with PXIE.

physics.acc-ph↗

arXiv2009

Longitudinal Stability of Recycler Bunches; Part I: Thresholds for Loss of Landau Damping

We examine the stability of intense flat bunches in barrier buckets used in the Recycler. We consider some common stationary distributions and show that they would be unstable against rigid dipole oscillations. We then discuss an analytical model for the line density that best describes measured bunch profiles. We include space charge in this model to predict the bunch intensity at which Landau damping would be lost. The dependence of this threshold on the bunch length is studied and related to the results of an experimental study with shorter bunch lengths. The threshold for the microwave instability is estimated. These studies will be followed by more detailed numerical studies.

physics.acc-ph↗

arXiv2004

Recent Enhancements to the MARS15 Code

The MARS code is under continuous development and has recently undergone substantial improvements that further increase its reliability and predictive power in numerous shielding, accelerator, detector and space applications. The major developments and new features of the MARS15 (2004) version described in this paper concern an extended list of elementary particles and arbitrary heavy ions and their interaction cross-sections, inclusive and exclusive nuclear event generators, module for modelling particle electromagnetic interactions, enhanced geometry and histograming options, improved MAD-MARS Beam Line Builder, enhanced Graphical-User Interface, and an MPI-based parallelization of the code.

nucl-th↗

arXiv2000

Optimized Wakefield Computations Using A Network Model

During the course of the last decade, traveling wave accelerating structures for a future Linear Collider have been the object of intense R&D efforts. An important problem is the efficient computation of the long range wakefield with the ability to include small alignment and tuning errors. To that end, SLAC has developed an RF circuit model with a demonstrated ability to reproduce experimentally measured wakefields. The wakefield computation involves the repeated solution of a deterministic system of equations over a range of frequencies. By taking maximum advantage of the sparsity of the equations, we have achieved significant performance improvements. These improvements make it practical to consider simulations involving an entire linac ($\sim 10^3$ structures). One might also contemplate assessing, in real time, the impact of fabrication errors on the wakefield as an integral part of quality control.

physics.acc-ph↗