arXiv subjects

J. Alessi

Publications and source records attributed to J. Alessi.

4 recordsLinked to original sources

arXiv2019

Enhanced Polarization of Low Pressure $^3$He through Metastability-Exchange Optical Pumping at High Field

We report high steady-state nuclear polarization of 1 torr $^3$He gas nuclei via metastability-exchange optical pumping at magnetic fields above 2 T. The introduction of highly polarized $^3$He gas into Brookhaven's Electron Beam Ion Source would enable a new, polarized $^3$He ion source for use at the Relativistic Heavy Ion Collider and a future Electron-Ion Collider facility. By adapting recent developments in high field metastability-exchange optical pumping for higher pressure gas, we have successfully polarized 1 torr $^3$He sealed cells in the EBIS solenoid. Through careful manipulation of the RF discharge parameters, polarizations above 80% were attained at 2, 3 and 4 T, with 89% being reached at 3 T with a 664 s relaxation time.

physics.ins-det↗

arXiv2000

A Super-Conducting Linac Driver for the HFBR

This paper reports on the feasibility study of a proton Super-Conducting Linac (SCL) as a driver gor the High-Flux Breader Reactor (HFBR) at Brookhaven National Laboratory (BNL). The Linac operates in Continuos Wave (CW) mode to produce an average 10 MW of beam power. The Linac energy is 1.0 GeV. The average proton beam intensity is 10 mA.

physics.acc-ph↗

arXiv1997

The NSNS High Energy Beam Transport Line

In the National Spallation Neutron Source (NSNS) design, a 180 meter long transport line connects the 1 GeV linac to an accumulator ring. The linac beam has a current of 28 mA, pulse length of 1 ms, and 60 Hz rep rate. The high energy transport line consists of sixteen 60 degrees FODO cells, and accommodates a 90 degrees achromatic bend, an energy compressor, collimators, part of injection system, and enough diagnostic devices to measure the beam quality before injection. To reduce the uncontrolled beam losses, this line has nine beam halo scrapers and very tight tolerances on both transverse and longitudinal beam dynamics under space charge conditions. The design of this line is presented.

physics.acc-ph↗

arXiv1997

The Algebraic Reconstruction Technique (ART)

Projections of charged particle beam current density (profiles) are frequently used as a measure of beam position and size. In conventional practice only two projections, usually horizontal and vertical, are measured. This puts a severe limit on the detail of information that can be achieved. A third projection provides a significant improvement. The Algebraic Reconstruction Technique (ART) uses three or more projections to reconstruct 3-dimensional density profiles. At the 200 MeV H- linac, we have used this technique to measure beam density, and it has proved very helpful, especially in helping determine if there is any coupling present in x-y phase space. We will present examples of measurements of current densities using this technique.

physics.acc-ph↗