Searcharxiv⌕ Search

arXiv subjects

J. Baehr

Publications and source records attributed to J. Baehr.

8 recordsLinked to original sources
arXiv2011

Reflective Optical System for Time-Resolved Electron Bunch Measurements at PITZ

The Photo-Injector Test facility at DESY, Zeuthen site (PITZ), produces pulsed electron beams with low transverse emittance and is equipped with diagnostic devices for measuring various electron bunch properties, including the longitudinal and transverse electron phase space distributions. The longitudinal bunch structure is recorded using a streak camera located outside the accelerator tunnel, connected to the diagnostics in the beam-line stations by an optical system of about 30 m length. This system mainly consists of telescopes of achromatic lenses, which transport the light pulses and image them onto the entrance slit of the streak camera. Due to dispersion in the lenses, the temporal resolution degrades during transport. This article presents general considerations for time-resolving optical systems as well as simulations and measurements of specific candidate systems. It then describes the development of an imaging system based on mirror telescopes which will improve the temporal resolution, with an emphasis on off-axis parabolic mirror systems working at unit magnification. A hybrid system of lenses and mirrors will serve as a proof of principle.

physics.acc-ph↗
arXiv2000

The H1 Forward Proton Spectrometer at HERA

The forward proton spectrometer is part of the H1 detector at the HERA collider. Protons with energies above 500 GeV and polar angles below 1 mrad can be detected by this spectrometer. The main detector components are scintillating fiber detectors read out by position-sensitive photo-multipliers. These detectors are housed in so-called Roman Pots which allow them to be moved close to the circulating proton beam. Four Roman Pot stations are located at distances between 60 m and 90 m from the interaction point.

hep-ex↗
arXiv1999

Measurements of the radiation hardness of selected scintillating and light guide fiber materials

Radiation hardness studies of KURARAY SCSF-78M scintillating fibers and clear fibers from KURARAY and pol.hi.tech. performed under different dose rate conditions in proton and electron beams are summarized. For high dose rates in-situ measurements of the fiber light output were done. During several months after irradiation all fibers were measured concerning light emission and transparency. Fibers irradiated at high rates to about 1 Mrad are clearly damaged but recover within a few hours up to several weeks. Using smaller rates up to the same integral dose a decrease of the light output of scintillating fibers of up to 30% can not be excluded. Clear fibers seem to be uneffected up to 400 krad. No significant influence of fiber coverage and atmosphere during irradiation was found.

physics.ins-det↗
arXiv1999

A Fiber Detector Radiation Hardness Test

An intense 146 MeV/c pion beam was stopped inside a scintillating fiber detector made out of 12 planes with 16 pixels each, where every pixel consists out of 8 times 8 scintillating fibers of 500 mkm diameter dense packed. The detector was irradiated for 52 hours to more than 1 Mrad at its center. Before and directly after the irradiation the detector has been exposed to a particle beam to compare the corresponding light output. This study was continued during the following three months using cosmic rays. No damage was found taking into account the measurement errors of 5-10 %. In contrast a 9 cm deep lucite degrader became irreversibly non-transparent in the irradiation region.

physics.ins-det↗
arXiv1998

Testrun results from prototype fiber detectors for high rate particle tracking

A fiber detector concept has been realized allowing to registrate particles within less than 100 nsec with a space point precision of about 0.1 mm at low occupancy. Three full size prototypes have been build by different producers and tested at a 3 GeV electron beam at DESY. After 3 m of light guides 8-10 photoelectrons were registrated by multichannel photomultipliers providing an efficiency of more than 99%. Using all available data a resolution of 0.086 mm was measured.

physics.ins-det↗
arXiv1998

Tests of a fiber detector concept for high rate particle tracking

A fiber detector concept is suggested allowing to registrate particles within less than 100 nsec with a space point precision of about 0.1 mm at low occuppancy. The fibers should be radiation hard for 1 Mrad/year. Corresponding prototypes have been build and tested at a 3 GeV electron beam at DESY. Preliminary results of these tests indicate that the design goal for the detector is reached.

physics.ins-det↗
arXiv1997

Development of scintillating fiber detector technology for high rate particle tracking

The performance of a scintillating fiber detector prototype for tracking under high rate conditions is investigated. A spatial resolution of about100 micron is aimed for the detector. Further demands are low occupancy and radiation hardness up to 1 Mrad/year. Fibers with different radii and different wavelengths of the scintillation light from different producers have been extensively tested concerning light output, attenuation length and radiation hardness, with and without coupling them to light guides of different length and diameter. In a testrun at a 3 GeV electron beam the space dependent efficiency and spatial resolution of fiber bundels were measured by means of two external reference detectors with a precision of 50 micron. The light output profile across fiber roads has been determined with the same accuracy. Different technologies were adopted for the construction of tracker modules consisting of 14 layers of 0.5 mm fibers and 0.7 mm pitch. A winding technology provides reliable results to produce later fiber modules of about 25 cm x 25 cm area. We conclude that on the basis of these results a fiber tracker for high rate conditions can be built.

hep-ex↗