Searcharxiv⌕ Search

arXiv subjects

J. Endrizzi

Publications and source records attributed to J. Endrizzi.

2 recordsLinked to original sources

Development and characterization of monolithic sensors with internal gain in a 110 nm CMOS process

This paper presents the optimization and characterization of a Monolithic Active Pixel Sensor with internal gain implemented in the 110 nm CMOS process from LFoundry. This work, carried out within the framework of the latest ARCADIA production run, reports on the characterization of sensors with an optimized gain layer. Improvements over earlier prototypes, including substrate current reduction via guard-ring connection, are briefly discussed. Both laboratory and in-beam measurements are presented. Using soft X-rays from a 55Fe source, both the pixel response and the noise performance are analyzed. In addition, laser measurements demonstrate an electronic jitter ranging from 20 to 40 ps for a signal amplitude corresponding to one minimum ionizing particle (MIP). Finally, the results from several test beam campaigns are described, showing the signal amplitude, gain and time resolution of sensors with different doping profiles of the gain layer evaluated with MIPs. A time resolution of about 78 ps was measured in the optimal condition of bias voltage and electronics configuration. The results demonstrate that monolithic CMOS sensors with internal gain can achieve promising timing performance at ambient temperature, highlighting their strong potential for next-generation precision timing applications.

physics.ins-det↗

Thin single-crystal perovskite detector for high-energy charged particles

The organometal halide perovskites (OMHP) semi-conductors have shown recently a strong potential as radiation detectors, beside the well-known success in photovoltaics and as photo-detectors. Many studies have been published on X-rays detection, and a few studies about detection of alpha, beta-particles and protons. Less literature is present for high energy charged particles. OMHP-based devices for tracking and real-time monitoring for high energy particles may offer many advantages. OMHPs can be directly grown on pixelated electronics, even on curved substrates, without the need of complex and expensive bump-bonding procedures. Moreover, OMHPs have shown self-healing features after radiation exposure, which makes them attractive for high-flux applications. In this paper we report a device based on a thin single OMHP crystal, about 150 mum thick, directly grown on a patterned substrate through dewetting technique, able to detect high-energy charged particles in a high dynamic range of incident fluxes. A dedicated electronics circuit has been developed to match the expected time characteristics of the OMHP crystals. This is the first demonstration of thin OMHP single crystals being able to detect high energy charged particles of hundreds of MeV.

physics.ins-det↗