arXiv subjects

J. Frühauf

Publications and source records attributed to J. Frühauf.

6 recordsLinked to original sources

arXiv2026

Demonstrating CBM Capabilities by $Λ$ Baryon Reconstruction in Ni+Ni Collisions with the mCBM Experiment at SIS18 of GSI/FAIR

The Compressed Baryonic Matter (CBM) experiment at the upcoming Facility for Antiproton and Ion Research (FAIR) is a high-rate fixed-target experiment designed to investigate nuclear matter at extreme baryon densities in relativistic nucleus-nucleus collisions. To enable high-statistics measurements of rare probes, CBM is designed to operate at event rates up to 10 MHz. This necessitates the development of fast and radiation-tolerant detectors, self-triggered front-end electronics, a free-streaming data acquisition architecture, and real-time event reconstruction capabilities. Prototype versions and pre-series productions of the CBM detector systems have been deployed in the mini-CBM demonstrator setup mCBM - an experimental precursor comprising sub-components of all major CBM systems, installed at the SIS18 facility of GSI/FAIR within the FAIR Phase-0 program. In 2024, Ni+Ni collisions at a kinetic beam energy of 1.93 AGeV and an average interaction rate of about 250 kHz were successfully recorded. This dataset enables a detailed evaluation of the operational performance of the detector systems as well as the complete CBM data chain, while the reconstruction of rare $Λ$ baryons serves as a natural benchmark. This paper presents the first results on $Λ$ signal reconstruction with the mCBM experiment, demonstrating the readiness of the detector technologies and the data chain for the upcoming full-scale CBM experiment.

physics.ins-det↗

arXiv2021

Commissioning and testing of pre-series triple GEM prototypes for CBM-MuCh in the mCBM experiment at the SIS18 facility of GSI

Large area triple GEM chambers will be employed in the first two stations of the MuCh system of the CBM experiment at the upcoming Facility for Antiproton and Ion Research FAIR in Darmstadt/Germany. The GEM detectors have been designed to take data at an unprecedented interaction rate (up to 10 MHz) in nucleus-nucleus collisions in CBM at FAIR. Real-size trapezoidal modules have been installed in the mCBM experiment and tested in nucleus-nucleus collisions at the SIS18 beamline of GSI as a part of the FAIR Phase-0 program. In this report, we discuss the design, installation, commissioning, and response of these GEM modules in detail. The response has been studied using the free-streaming readout electronics designed for the CBM-MuCh and CBM-STS detector system. In free-streaming data, the first attempt on an event building based on the timestamps of hits has been carried out, resulting in the observation of clear spatial correlations between the GEM modules in the mCBM setup for the first time. Accordingly, a time resolution of $\sim$15\,ns have been obtained for the GEM detectors.

physics.ins-det↗

arXiv2020

Detector control system for the CBM-TOF

A high-performance time-of-flight (TOF) MRPC wall is being built for the CBM experiment at FAIR for charged hadron identification. The detector control system for the TOF system will be based on EPICS. All components like power supplies for low and high voltages, power distribution boxes, gas control and front-end electronics (FEE) are controlled and monitored. In a test, called mini-CBM, all these functionalities are implemented and tested. For monitoring the detector environment and the status of the front-end electronics, a slow control application is implemented based on IPbus, which is an FPGA-based slow control bus used for the TOF data acquisition system. In addition to the functions of control and monitoring, exception handling and data archiving services are implemented as well. This system has been fully verified in beam tests in 2019 at GSI.

physics.ins-det↗

arXiv2016

Performance studies of MRPC prototypes for CBM

Multi-gap Resistive Plate Chambers (MRPCs) with multi-strip readout are considered to be the optimal detector candidate for the Time-of-Flight (ToF) wall in the Compressed Baryonic Matter (CBM) experiment. In the R&D phase MRPCs with different granularities, low-resistive materials and high voltage stack configurations were developed and tested. Here, we focus on two prototypes called HD-P2 and THU-strip, both with strips of 27 cm$^2$ length and low-resistive glass electrodes. The HD-P2 prototype has a single-stack configuration with 8 gaps while the THU-strip prototype is constructed in a double-stack configuration with 2 $\times$ 4 gaps. The performance results of these counters in terms of efficiency and time resolution carried out in a test beam time with heavy-ion beam at GSI in 2014 are presented in this proceeding.

physics.ins-det↗

arXiv2016

Time and position resolution of high granularity, high counting rate MRPC for the inner zone of the CBM-TOF wall

Multi-gap RPC prototypes with readout on a multi-strip electrode were developed for the small polar angle region of the CBM-TOF subdetector, the most demanding zone in terms of granularity and counting rate. The prototypes are based on low resistivity ($\sim$10$^{10}$ $Ω$cm) glass electrodes for performing in high counting rate environment. The strip width/pitch size was chosen such to fulfill the impedance matching with the front-end electronics and the granularity requirements of the innermost zone of the CBM-TOF wall. The in-beam tests using secondary particles produced in heavy ion collisions on a Pb target at SIS18 - GSI Darmstadt and SPS - CERN were focused on the performance of the prototype in conditions similar to the ones expected at SIS100/FAIR. An efficiency larger than 98\% and a system time resolution in the order of 70~-~80~ps were obtained in high counting rate and high multiplicity environment.

physics.ins-det↗

arXiv2012

Technical Design Study for the PANDA Time Projection Chamber

This document illustrates the technical layout and the expected performance of a Time Projection Chamber as the central tracking system of the PANDA experiment. The detector is based on a continuously operating TPC with Gas Electron Multiplier (GEM) amplification.

physics.ins-det↗