arXiv subjects

J. Hassel

Publications and source records attributed to J. Hassel.

15 recordsLinked to original sources

arXiv2022

Initial experimental results on a superconducting-qubit reset based on photon-assisted quasiparticle tunneling

We present here our recent results on qubit reset scheme based on a quantum-circuit refrigerator (QCR). In particular, we use the photon-assisted quasiparticle tunneling through a superconductor--insulator--normal-metal--insulator--superconductor junction to controllably decrease the energy relaxation time of the qubit during the QCR operation. In our experiment, we use a transmon qubit with dispersive readout. The QCR is capacitively coupled to the qubit through its normal-metal island. We employ rapid, square-shaped QCR control voltage pulses with durations in the range of 2--350 ns and a variety of amplitudes to optimize the reset time and fidelity. Consequently, we reach a qubit ground-state probability of roughly 97% with 80-ns pulses starting from the first excited state. The qubit state probability is extracted from averaged readout signal, where the calibration is based of the Rabi oscillations, thus not distinguishing the residual thermal population of the qubit.

quant-ph↗

arXiv2022

Qubit-compatible substrates with superconducting through-silicon vias

We fabricate and characterize superconducting through-silicon vias and electrodes suitable for superconducting quantum processors. We measure internal quality factors of a million for test resonators excited at single-photon levels, on chips with superconducting vias used to stitch ground planes on the front and back sides of the chips. This resonator performance is on par with the state of the art for silicon-based planar solutions, despite the presence of vias. Via stitching of ground planes is an important enabling technology for increasing the physical size of quantum processor chips, and is a first step toward more complex quantum devices with three-dimensional integration.

quant-ph↗

arXiv2021

A superconductor free of quasiparticles for seconds

Superconducting devices, based on the Cooper pairing of electrons, play an important role in existing and emergent technologies, ranging from radiation detectors to quantum computers. Their performance is limited by spurious quasiparticle excitations formed from broken Cooper pairs. Efforts to achieve ultra-low quasiparticle densities have reached time-averaged numbers of excitations on the order of one in state-of-the-art devices. However, the dynamics of the quasiparticle population as well as the time scales for adding and removing individual excitations remain largely unexplored. Here, we experimentally demonstrate a superconductor completely free of quasiparticles for periods lasting up to seconds. We monitor the quasiparticle number on a mesoscopic superconductor in real time by measuring the charge tunneling to a normal metal contact. Quiet, excitation-free periods are interrupted by random-in-time Cooper pair breaking events, followed by a burst of charge tunneling within a millisecond. Our results demonstrate the possibility of operating devices without quasiparticles with potentially improved performance. In addition, our experiment probes the origins of nonequilibrium quasiparticles in our device; the decay of the Cooper pair breaking rate over several weeks following the initial cooldown rules out processes arising from cosmic or long-lived radioactive sources.

cond-mat.supr-con↗

arXiv2020

Quantum paraelectric varactors for radio-frequency measurements at mK temperatures

Radio-frequency reflectometry allows for fast and sensitive electrical readout of charge and spin qubits hosted in quantum dot devices coupled to resonant circuits. Optimizing readout, however, requires frequency tuning of the resonators and impedance matching. This is difficult to achieve using conventional semiconductor or ferroelectric-based varactors in the detection circuit as their performance degrades significantly in the mK temperature range relevant for solid-state quantum devices. Here we explore a different type of material, strontium titanate, a quantum paraelectric with exceptionally large field-tunable permittivity at low temperatures. Using strontium titanate varactors we demonstrate perfect impedance matching and resonator frequency tuning at 6 mK and characterize the varactors at this temperature in terms of their capacitance tunability, dissipative losses and magnetic field sensitivity. We show that this allows us to optimize the radio-frequency readout signal-to-noise ratio of carbon nanotube quantum dot devices to achieve a charge sensitivity of 4.8 $\mu$e/Hz$^{1/2}$ and capacitance sensitivity of 0.04 aF/Hz$^{1/2}$.

cond-mat.mes-hall↗

arXiv2018

Magnetic field sensing with the kinetic inductance of a high-$T_\mathrm{c}$ superconductor

We carry out an experimental feasibility study of a magnetic field sensor based on the kinetic inductance of the high-$T_\mathrm{c}$ superconductor yttrium barium copper oxide. We pattern thin superconducting films into radio-frequency resonators that feature a magnetic field pick-up loop. At 77 K and for film thicknesses down to 75 nm, we observe the persistence of screening currents that modulate the loop kinetic inductance. According to the experimental results the device concept appears attractive for sensing applications in ambient magnetic field environments. We report on a device with a magnetic field sensitivity of 4 pT/Hz${}^{1/2}$, an instantaneous dynamic range of 11 $\mu$T, and operability in magnetic fields up to 28 $\mu$T.

physics.ins-det↗

arXiv2018

Nanobolometer with Ultralow Noise Equivalent Power

Since the introduction of bolometers more than a century ago, they have been applied in a broad spectrum of contexts ranging from security and the construction industry to particle physics and astronomy. However, emerging technologies and missions call for faster bolometers with lower noise. Here, we demonstrate a nanobolometer that exhibits roughly an order of magnitude lower noise equivalent power, $20\textrm{ zW}/\sqrt{\textrm{Hz}}$, than previously reported for any bolometer. Importantly, it is more than an order of magnitude faster than other low-noise bolometers, with a time constant of 30 $\mu$s at $60\textrm{ zW}/\sqrt{\textrm{Hz}}$. These results suggest a calorimetric energy resolution of $0.3\textrm{ zJ}=h\times 0.4$ THz with a time constant of 30 $\mu$s. Thus the introduced nanobolometer is a promising candidate for future applications requiring extreme precision and speed such as those in astronomy and terahertz photon counting.

physics.ins-det↗

arXiv2014

Photon Generation from Quantum Vacuum using a Josephson Metamaterial

When one of the parameters in the Euler-Lagrange equations of motion of a system is modulated, particles can be generated out of the quantum vacuum. This phenomenon is known as the dynamical Casimir effect, and it was recently realized experimentally in systems of superconducting circuits, for example by using modulated resonators made of coplanar waveguides, or arrays of superconducting quantum intereference devices (SQUIDs) forming a Josephson metamaterial. In this paper, we consider a simple electrical circuit model for dynamical Casimir effects, consisting of an LC resonator, with the inductor modulated externally at 10.8 GHz and with the resonant frequency tunable over a range of $\pm$ 400 MHz around 5.4 GHz. The circuit is analyzed classically using a circuit simulator (APLAC). We demonstrate that if an additional source of classical noise couples to the resonator (on top of the quantum vacuum), for example via dissipative "internal modes", then the resulting spectrum of the photons in the cavity will present two strongly asymmetric branches. However, according to the theory of the dynamical Casimir effect, these branches should be symmetric, a prediction which is confirmed by our experimental data. The simulation presented here therefore shows that the origin of the photons generated in our experiment with Josephson metamaterials is the quantum vacuum, and not a spurious classical noise source.

cond-mat.mes-hall↗

arXiv2008

Superconducting transition detector in power amplification mode: a tool for cryogenic multiplexing

We demonstrate that substantial power gain can be obtained with superconducting transition detectors. We describe the properties of the detector as a power amplifier theoretically. In our first experiments power gain of 23 was reached in a good agreement with the theory. The gain facilitates noise matching of the readout circuit to the detectors in the case of time division multiplexing.

cond-mat.supr-con↗

arXiv2007

Verification of stable operation of rapid single flux quantum devices with selective dissipation

It has been suggested that Rapid Single Flux Quantum (RSFQ) devices could be used as the classical interface of superconducting qubit systems. One problem is that the interface acts as a dissipative environment for a qubit. Recently ways to modify the RSFQ damping to reduce the dissipation have been introduced. One of the solutions is to damp the Josephson junctions by a frequency-dependent linear circuit instead of the plain resistor. The approach has previously been experimentally tested with a simple SFQ comparator. In this paper we perform experiments with a full RSFQ circuit, and thus conclude that in terms of stable operation the approach is applicable for scalable RSFQ circuits. Realisation and optimisation issues are also discussed.

cond-mat.supr-con↗

arXiv2006

High resolution superconducting single flux quantum comparator for sub kelvin temperatures

A design of subkelvin single flux quantum (SFQ) circuits with reduced power dissipation and additional cooling of shunt resistors for superconducting qubit control circuits has been developed and characterized. We demonstrate operation of SFQ comparators with current resolution of 40 nA at 2 GHz sampling rate. Due to improved cooling the electron temperature in shunt resistors of a SFQ comparator is below 50 mK when the bath temperature is about 30 mK.

cond-mat.supr-con↗

arXiv2006

Description of self-synchronization effects in distributed Josephson junction arrays using harmonic analysis and power balance

Power generation and synchronisation in Josephson junction arrays have attracted attention for a long time. This stems from fundamental interest in nonlinear coupled systems as well as from potential in practical applications. In this paper we study the case of an array of junctions coupled to a distributed transmission line either driven by an external microwave or in a self-oscillating mode. We simplify the theoretical treatment in terms of harmonic analysis and power balance. We apply the model to explain the large operation margins of SNS- and SINIS-junction arrays. We show the validity of the approach by comparing with experiments and simulations with self-oscillating es-SIS junction arrays.

cond-mat.supr-con↗

arXiv2005

RSFQ devices with selective dissipation for quantum information processing

We study the possibility to use frequency dependent damping in RSFQ circuits as means to reduce dissipation and consequent decoherence in RSFQ/qubit circuits. We show that stable RSFQ operation can be achieved by shunting the Josephson junctions with an $RC$ circuit instead of a plain resistor. We derive criteria for the stability of such an arrangement, and discuss the effect on decoherence and the optimisation issues. We also design a simple flux generator aimed at manipulating flux qubits.

cond-mat.supr-con↗

arXiv2004

Theory of the Bloch Oscillating Transistor

The Bloch oscillating transistor (BOT) is a device, where single electron current through a normal tunnel junction can be used to enhance Cooper pair current in a mesoscopic Josephson junction leading to signal amplification. In this paper we develop a theory, where the BOT dynamics is described as a two-level system. The theory is used to predict current-voltage characteristics and small-signal response. Transition from stable operation into hysteretic regime is studied. By identifying the two-level switching noise as the main source of fluctuations, the expressions for equivalent noise sources and the noise temperature are derived. The validity of the model is tested by comparing the results with simulations.

cond-mat.mes-hall↗

arXiv2003

Control of Coulomb blockade in a mesoscopic Josephson junction using single electron tunneling

We study a circuit where a mesoscopic Josephson junction (JJ) is embedded in an environment consisting of a large bias resistor and a normal metal - superconductor tunnel junction (NIS). The effective Coulomb blockade of the JJ can be controlled by the tunneling current through the NIS junction leading to transistor-like characteristics. We show using phase correlation theory and numerical simulations that substantial current gain with low current noise ($i_{n}\lesssim 1$ fA/$\sqrt{\text{Hz}}$) and noise temperature ($\lesssim $ 0.1 K) can be achieved. Good agreement between our numerical simulations and experimental results is obtained.

cond-mat.mes-hall↗

arXiv2003

The Bloch Oscillating Transistor

We introduce a new mesoscopic transistor, which consists of a superconducting island connected to superconducting and normal electrodes via two mesoscopic tunnel junctions. Furthermore, the island is being charged through a resistor. The interplay between Bloch oscillations, single-electron effects and ohmic current leads to a device having a high current gain. The operation and characteristics of the transistor are analyzed with a numerical model.

cond-mat.mes-hall↗