arXiv subjects

J. L. Long

Publications and source records attributed to J. L. Long.

15 recordsLinked to original sources

arXiv2021

Cryogenic microwave loss in epitaxial Al/GaAs/Al trilayers for superconducting circuits

Epitaxially-grown superconductor/dielectric/superconductor trilayers have the potential to form high-performance superconducting quantum devices and may even allow scalable superconducting quantum computing with low-surface-area qubits such as the merged-element transmon. In this work, we measure the power-independent loss and two-level-state (TLS) loss of epitaxial, wafer-bonded, and substrate-removed Al/GaAs/Al trilayers by measuring lumped element superconducting microwave resonators at millikelvin temperatures and down to single photon powers. The power-independent loss of the device is $(4.8 \pm 0.1) \times 10^{-5}$ and resonator-induced intrinsic TLS loss is $(6.4 \pm 0.2) \times 10^{-5}$. Dielectric loss extraction is used to determine a lower bound of the intrinsic TLS loss of the trilayer of $7.2 \times 10^{-5}$. The unusually high power-independent loss is attributed to GaAs's intrinsic piezoelectricity.

physics.app-ph↗

arXiv2020

Dielectric loss extraction for superconducting microwave resonators

The investigation of two-level-state (TLS) loss in dielectric materials and interfaces remains at the forefront of materials research in superconducting quantum circuits. We demonstrate a method of TLS loss extraction of a thin film dielectric by measuring a lumped element resonator fabricated from a superconductor-dielectric-superconductor trilayer. We extract the dielectric loss by formulating a circuit model for a lumped element resonator with TLS loss and then fitting to this model using measurements from a set of three resonator designs: a coplanar waveguide resonator, a lumped element resonator with an interdigitated capacitor, and a lumped element resonator with a parallel plate capacitor that includes the dielectric thin film of interest. Unlike other methods, this allows accurate measurement of materials with TLS loss lower than $10^{-6}$. We demonstrate this method by extracting a TLS loss of $1.02 \times 10^{-3}$ for sputtered $\mathrm{Al_2O_3}$ using a set of samples fabricated from an $\mathrm{Al/Al_2O_3/Al}$ trilayer. We observe a difference of 11$\%$ between extracted loss of the trilayer with and without the implementation of this method.

quant-ph↗

arXiv2017

Overlap junctions for high coherence superconducting qubits

Fabrication of sub-micron Josephson junctions is demonstrated using standard processing techniques for high-coherence, superconducting qubits. These junctions are made in two separate lithography steps with normal-angle evaporation. Most significantly, this work demonstrates that it is possible to achieve high coherence with junctions formed on aluminum surfaces cleaned in situ with Ar milling before the junction oxidation. This method eliminates the angle-dependent shadow masks typically used for small junctions. Therefore, this is conducive to the implementation of typical methods for improving margins and yield using conventional CMOS processing. The current method uses electron-beam lithography and an additive process to define the top and bottom electrodes. Extension of this work to optical lithography and subtractive processes is discussed.

cond-mat.supr-con↗

arXiv2017

Qubit gates using hyperbolic secant pulses

It has been known since the early days of quantum mechanics that hyperbolic secant pulses possess the unique property that they can perform cyclic evolution on two-level quantum systems independently of the pulse detuning. More recently, it was realized that they induce detuning- controlled phases without changing state populations. Here, we experimentally demonstrate the properties of hyperbolic secant pulses on superconducting transmon qubits and contrast them with the more commonly used Gaussian and square waves. We further show that these properties can be exploited to implement phase gates, nominally without exiting the computational subspace. This enables us to demonstrate the first microwave-driven Z-gates with a single control parameter, the detuning.

quant-ph↗

arXiv2009

Viscosity and dilepton production of a chemically equilibrating quark-gluon plasma at finite baryon density

By considering the effect of shear viscosity we have investigated the evolution of a chemically equilibrating quark-gluon plasma at finite baryon density. Based on the evolution of the system we have performed a complete calculation for the dilepton production from the following processes: $q\bar{q}{\to}l\bar{l}$, $q\bar{q}{\to}gl\bar{l}$, Compton-like scattering ($qg{\to}ql\bar{l}$, $\bar{q}g{\to}{\bar{q}}l\bar{l}$), gluon fusion $g\bar{g}{\to}c\bar{c}$, annihilation $q\bar{q}{\to}c\bar{c}$ as well as the multiple scattering of quarks. We have found that quark-antiquark annihilation, Compton-like scatterring, gluon fusion, and multiple scattering of quarks give important contributions. Moreover, we have also found that the dilepton yield is an increasing function of the initial quark chemical potential, and the increase of the quark phase lifetime because of the viscosity also obviously raises the dilepton yield.

nucl-th↗

arXiv2008

Nuclear quadrupole resonances in compact vapor cells: the crossover from the NMR to the NQR interaction regimes

We present the first experimental study that maps the transformation of nuclear quadrupole resonances from the pure nuclear quadrupole regime to the quadrupole-perturbed Zeeman regime. The transformation presents an interesting quantum-mechanical problem, since the quantization axis changes from being aligned along the axis of the electric-field gradient tensor to being aligned along the magnetic field. We achieve large nuclear quadrupole shifts for I = 3/2 131-Xe by using a 1 mm^3 cubic cell with walls of different materials. When the magnetic and quadrupolar interactions are of comparable size, perturbation theory is not suitable for calculating the transition energies. Rather than use perturbation theory, we compare our data to theoretical calculations using a Liouvillian approach and find excellent agreement.

quant-ph↗

arXiv2007

Three-Particle Correlations from Parton Cascades in Au+Au Collisions

We present a study of three-particle correlations among a trigger particle and two associated particles in Au + Au collisions at $\sqrt{s_{NN}}$ = 200 GeV using a multi-phase transport model (AMPT) with both partonic and hadronic interactions. We found that three-particle correlation densities in different angular directions with respect to the triggered particle (`center', `cone', `deflected', `near' and `near-away') increase with the number of participants. The ratio of `deflected' to `cone' density approaches to 1.0 with the increasing of number of participants, which indicates that partonic Mach-like shock waves can be produced by strong parton cascades in central Au+Au collisions.

nucl-th↗

arXiv2006

Time evolution of Mach-like structure in a partonic transport model

The time evolution of Mach-like structure (the splitting of the away side peak in di-hadron $Δϕ$ correlation) is presented in the framework of a dynamical partonic transport model. With the increasing of the lifetime of partonic matter, Mach-like structure can be produced and developed by strong parton cascade process. Not only the splitting parameter but also the number of associated hadrons ($N_{h}^{assoc}$) increases with the lifetime of partonic matter and partonic interaction cross section. Both the explosion of $N_{h}^{assoc}$ following the formation of Mach-like structure and the corresponding results of three-particle correlation support that a partonic Mach-like shock wave can be formed by strong parton cascade mechanism. Therefore, the studies about Mach-like structure may give us some critical information, such as the lifetime of partonic matter and hadronization time.

nucl-th↗

arXiv2006

Di-hadron azimuthal correlation and Mach-like cone structure in parton/hadron transport model

In the framework of a multi-phase transport model (AMPT) with both partonic and hadronic interactions, azimuthal correlations between trigger particles and associated scattering particles have been studied by the mixing-event technique. The momentum ranges of these particles are $3< p^{trig}_T< 6$ GeV/$c$ and $0.15< p_{T}^{assoc} < 3$ GeV/$c$ (soft), or $2.5 $ increases, with the impact parameter in the AMPT model including partonic dynamics from string melting scenario.

nucl-th↗

arXiv2006

Elliptic flow of $ϕ$ meson and strange quark collectivity at RHIC

Based on A Multi-Phase Transport (AMPT) model, we have studied the elliptic flow $v_{2}$ of $ϕ$ mesons from reconstructed $K^{+}K^{-}$ decay channel at the top Relativistic Heavy Ion Collider energy at Brookhaven National Laboratory. The dependences of $v_{2}$ on transverse momentum $p_T$ and collision centrality are presented and the rescattering effect of $ϕ$ mesons in the hadronic phase is also investigated. The results show that experimental measurement of $v_{2}$ for $ϕ$ mesons can retain the early collision information before $ϕ$ decays and that the $ϕ$ $v_2$ value obeys the constituent quark number scaling which has been observed for other mesons and baryons. Our study indicates that the $ϕ$ $v_2$ mostly reflects partonic level collectivity developed during the early stage of the nucleus-nucleus collision and the strange and light up/down quarks have developed similar angular anistropy properties at the hadronization.

nucl-th↗

arXiv2006

Di-hadron and Tri-hadron correlation and Mach-like cone structure

In a framework of a multi-phase transport model with both partonic and hadronic interactions, azimuthal correlations between trigger particles and associated scattering particles in Au + Au collisions at $\sqrt{s_{NN}}$ = 200 GeV/$c$ have been studied by the mixing-event technique. The Mach-like structure has been observed in correlation function for central collisions. It is shown that the Mach-like structure is basically born in the partonic process and further developed in hadronic rescattering process. However, hadronic rescattering alone cannot reproduce the amplitude of Mach-like cone on away side, therefore partonic cascade process is necessary to describe the amplitude of Mach-like cone on away side in experiment. In addition, three-particle correlations have been investigated in central Au + Au collisions with the AMPT model, and the results support the conclusion that partonic cascade processes enhance the opening angle of Mach-like cone structures.

nucl-th↗

arXiv2006

Strange quark collectivity of $ϕ$ meson at RHIC

Based on A Multi-Phase Transport model, the elliptic flow $v_{2}$ of $ϕ$ mesons which is reconstructed from $K^{+}K^{-}$ at the Relativistic Heavy Ion Collider (RHIC) energy has been studied. The results show that reconstructed $v_{2}$ of $ϕ$ meson can keep the earlier information before $ϕ$ decays and it seems to obey the number of constituent quark scaling as other mesons and baryons. This result indicates that the $ϕ$ $v_2$ mostly reflects the parton level collectivity developed during the early stage of the collisions and the strange and light up/down quarks have similar collectivity properties before the hadronization.

nucl-th↗

arXiv2005

Effect of Hadronic Rescattering on Elliptic Flow Following Hydrodynamics Model

The effect of hadronic rescattering on the elliptic flow has been investigated by the Cooper-Frye hadronization model from hydrodynamic evolution following by the afterburner hadronic rescattering model for 200 GeV/c Au + Au at 20-40% centrality. It is found that the hadronic rescattering can suppress elliptic flow $v_2$ in momentum space especially in lower transverse momentum region. In addition, the hadronic rescattering effects on transverse momentum spectra and anisotropy coordinate space of hadrons are studied.

nucl-th↗

arXiv2005

$Δ$-scaling and heat capacity in relativistic ion collisions

The $Δ$-scaling method has been applied to the total multiplicity distribution of the relativistic ion collisions of p+p, C+C and Pb+Pb which were simulated by a Monte Carlo package, LUCIAE 3.0. It is found that the $Δ$-scaling parameter decreases with the increasing of the system size. Moreover, the heat capacities of different mesons and baryons have been extracted from the event-by-event temperature fluctuation in the region of low transverse mass and they show the dropping trend with the increasing of impact parameter.

nucl-th↗

arXiv2004

Statistical nature of cluster emission in nuclear liquid-vapour phase coexistence

The emission of nuclear clusters is investigated within the framework of isospin dependent lattice gas model and classical molecular dynamics model. It is found that the emission of individual cluster which is heavier than proton is almost Poissonian except near the transition temperature at which the system is leaving the liquid-vapor phase coexistence and the thermal scaling is observed by the linear Arrhenius plots which is made from the average multiplicity of each cluster versus the inverse of temperature in the liquid vapor phase coexistence. The slopes of the Arrhenius plots, {\it i.e.} the "emission barriers", are extracted as a function of the mass or charge number and fitted by the formula embodied with the contributions of the surface energy and Coulomb interaction. The good agreements are obtained in comparison with the data for low energy conditional barriers. In addition, the possible influences of the source size, Coulomb interaction and "freeze-out" density and related physical implications are discussed.

nucl-th↗