SearcharxivSearch

arXiv subjects

J. Lefebvre

Publications and source records attributed to J. Lefebvre.

12 recordsLinked to original sources

Characterization of external cross-talk from silicon photomultipliers in a liquid xenon detector

The Light-only Liquid Xenon experiment (LoLX) employs a small-scale detector equipped with 96 Hamamatsu VUV4 silicon photomultipliers (SiPMs) submerged in 5 kg of liquid xenon (LXe) to perform characterization measurements of light production, transport and detection in xenon. In this work, we perform a novel measurement of the "external cross-talk" (ExCT) of SiPMs, where photons produced in the avalanche process escape the device and produce correlated signals on other SiPMs. SiPMs are the photodetector technology of choice for next generation rare-event search experiments; understanding the sources and effects of correlated noise in SiPMs is critical for producing accurate estimates of detector performance and sensitivity projections. We measure the probability to observe ExCT through timing correlation of detected photons in low-light conditions within LoLX. Measurements of SiPM ExCT are highly detector dependent; thus the ExCT process is simulated and modelled using the Geant4 framework. Using the simulation, we determine the average transport and detection efficiency for ExCT photons within LoLX, a necessary input to extract the expected ExCT probability from the data. For an applied overvoltage of 4 V and 5 V, we measure a mean number of photons emitted into the LXe per avalanche of $0.5^{+0.3}_{-0.2}$ and $0.6^{+0.3}_{-0.2}$, respectively. Using an optical model to describe photon transmission through the SiPM surface, this corresponds to an estimated photon yield inside the bulk silicon of $20^{+11}_{-9}$ and $25^{+12}_{-9}$ photons per avalanche. The relative increase in intensity of SiPM ExCT emission between 4 V and 5 V is consistent with expectation for the linear increase of gain with respect to overvoltage.

physics.ins-det

Cellulose-Bound Magnesium Diboride Superconductivity

Two-phase superconductor tapes were produced by blending high purity magnesium diboride powder with a liquid ethylcellulose-based polymeric binder. This procedure produced a material which is easily formable with a high superconducting transition temperature (38K). We show that the bulk superconducting properties are not affected by the presence of the binder, nor is there any evidence of a chemical reaction between the superconducting particles and the binder. However, the transport properties of the material are strongly affected by the presence of the binder, which leads to a seven order of magnitude increase of the normal state resistance along with a seven order of magnitude decrease of the transport critical current density. This new material is shown to be equivalent to a system of coupled Josephson junctions.

cond-mat.supr-con

The strengthening of reentrant pinning by collective interactions in the peak effect

Since it was first observed about 40 years ago [1], the peak effect has been the subject of numerous research mainly impelled by the desire to determine its exact mechanisms. Despite these efforts, a consensus on this question has yet to be reached. Experimentally, the peak effect indicates a transition from a depinned vortex phase to a reentrant pinning phase at high magnetic field. To study the effects of intrinsic pinning on the peak effect, we consider Fe$_{x}$Ni$_{1-x}$Zr$_{2}$ superconducting metallic glasses in which the vortex pinning force varies depending on the Fe content and in which a huge peak effect is seen as a function of magnetic field. The results are mapped out as a phase diagram in which it is readily seen that the peak effect becomes broader with decreasing pinning force. Typically, pinning can be understood by increased pinning centers, but here, we show that reentrant pinning is due to the strengthening of interactions (while decreasing pinning strength). Our results demonstrate the strengthening of the peak effect by collective effects.

cond-mat.supr-con

Tuning the exciton g-factor in single InAs/InP quantum dots

Photoluminescence data from single, self-assembled InAs/InP quantum dots in magnetic fields up to 7 T are presented. Exciton g-factors are obtained for dots of varying height, corresponding to ground state emission energies ranging from 780 meV to 1100 meV. A monotonic increase of the g-factor from -2 to +1.2 is observed as the dot height decreases. The trend is well reproduced by sp3 tight binding calculations, which show that the hole g-factor is sensitive to confinement effects through orbital angular momentum mixing between the light-hole and heavy-hole valence bands. We demonstrate tunability of the exciton g-factor by manipulating the quantum dot dimensions using pyramidal InP nanotemplates.

cond-mat.mes-hall

Superconductivity and short range order in metallic glasses Fe$_{x}$Ni$_{1-x}$Zr$_{2}$

In amorphous superconductors, superconducting and vortex pinning properties are strongly linked to the absence of long range order. Consequently, superconductivity and vortex phases can be studied to probe the underlying microstructure and order of the material. This is done here from resistance and local magnetization measurements in the superconducting state of Fe$_{x}$Ni$_{1-x}$Zr$_{2}$ metallic glasses with $0\leq x \leq 0.6$. Firstly, we present typical superconducting properties such as the critical temperature and fields and their dependence on Fe content in these alloys. Then, the observations of peculiar clockwise hysteresis loops, wide double-step transitions and large magnetization fluctuations in glasses containing a large amount of Fe are analyzed to reveal a change in short range order with Fe content.

cond-mat.supr-con

Local magnetization fluctuations in superconducting glasses resolved by Hall sensors

We report on magnetization measurements performed on a series of Fe$_{x}$Ni$_{1-x}$Zr$_{2}$ superconducting metallic glasses with $0\leq x\leq0.5$ using the Hall effect of a nearby 2-dimensional electron gas (2DEG) in a GaAs/Al$_{0.33}$Ga$_{0.67}$As heterostructure as a local probe. The great sensitivity of the Hall effect of the 2DEG in such heterostructure is exploited to determine the magnetization of the superconductor due to the Meissner effect and flux trapping. The data is used to determine the lower critical field B$_{c1}$ of the superconductors as a function of temperature. Surprisingly large fluctuations in the magnetization are also observed and attributed to the presence of large flux clusters in the superconductor.

cond-mat.supr-con

Transverse depinning in weakly-pinned vortices

We present experiments on weakly-pinned vortices, which exhibit a large critical transverse depinning force. These results are obtained in the superconducting metallic glasses Fe$_{x}$Ni$_{1-x}$Zr$_{2}$ using crossed ac and dc driving currents. We study the vortex depinning force due to the transverse ac drive as a function of a longitudinal dc drive; the ac/dc combination permits the separation of the transverse drive from the longitudinal one. We show that the force required for depinning in the transverse direction is greatly enhanced by the longitudinal drive, which demonstrates the existence of a large transverse critical force. The measurements are performed as a function of magnetic field and temperature and show that the transverse critical force exists in a large portion of the phase diagram. Hysteresis observed at the transverse depinning threshold is consistent with a first-order transverse depinning transition.

cond-mat.supr-con

Experimental evidence for a large critical transverse depinning force in weakly-pinned vortices

We present experimental evidence for the existence of a large critical transverse depinning force. These results are obtained in the weakly-pinned superconducting metal glasses Fe$_{x}$Ni$_{1-x}$Zr$_{2}$ using crossed ac and dc driving currents. We study the depinning force due to the transverse ac drive as a function of a longitudinal dc drive. The ac/dc combination allows us to separate the transverse drive from the longitudinal one. We show that the force required for depinning in the transverse direction is enhanced by a longitudinal drive, which leads to the existence of a large transverse critical force.

cond-mat.supr-con

Transverse Vortex Dynamics in Superconductors

We experimentally characterize the transverse vortex motion and observed some striking features. We found large structures and peaks in the Hall resistance, which can be attributed to the long-range inhomogeneous vortex flow present in some phases of vortex dynamics. We further demonstrate the existence of a moving vortex phase between the pinned phase (peak effect) and the field induced normal state. The measurements were performed on NiZr2 based superconducting glasses.

cond-mat.supr-con

Temperature dependent PL from SWNTs

Photoluminescence (PL) and photoluminescence excitation (PLE) spectroscopy of pillar-suspended single-walled carbon nanotubes has been measured for temperatures between 300 K and 5 K.

cond-mat.mes-hall

Photoluminescence from single walled carbon nanotubes: a comparison between suspended and micelle-encapsulated nanotubes

Single walled carbon nanotubes (SWNTs) are luminescent. Up to now, two preparation methods, both of which isolate individual SWNTs, have enabled the detection of nanotube bandgap photoluminescence (PL): encapsulation of individual SWNTs into surfactant micelles, and direct growth of individual SWNTs suspended in air between pillars. This paper compares the PL obtained from suspended SWNTs to published PL data obtained from encapsulated SWNTs. We find that emission peaks are blue-shifted by 28 meV on average for the suspended nanotubes as compared to the encapsulated nanotubes. Similarly, the resonant absorption peaks are blue-shifted on average by 16 meV. Both shifts depend weakly on the particular chirality and diameter of the SWNT.

cond-mat

Self-Assembled InAs Quantum Dots on Patterned InP Substrates

The size distribution of self-assembled InAs quantum dots grown on (001) InP under the Stranski-Krastanow growth mode is controlled using selective area/chemical beam epitaxy, which allows the formation of quantum dots at specific locations. As the dimensions of the patterned areas are decreased from 1000 nm down to 50 nm or less, scanning electron microscopy reveals a gradual increase in the spatial correlation between quantum dots, which leads to the formation of ordered arrays for dimensions below 200 nm.

cond-mat.mes-hall