arXiv subjects

J. Nilsson

Publications and source records attributed to J. Nilsson.

11 recordsLinked to original sources

arXiv2022

Evaluation of a method for time-of-flight, wavelength and distance calibration for neutron scattering instruments by means of a mini-chopper and standard neutron monitors

Accurate conversion of neutron time-of-flight (TOF) to wavelength, and its uncertainty, is of fundamental importance to neutron scattering measurements. Especially in cases where instruments are highly configurable, the determination of the absolute wavelength after any change must always be performed. Inspired by the manner with which neutron spectrometers determine the absolute wavelength, we evaluate for the first time, in the author's knowledge, a commonly used method for converting TOF to neutron wavelength, the distance of a monitor from the source of neutrons and we analytically calculate the uncertainty contributions that limit the precision of the conversion. The method was evaluated at the V20 test beamline at the Helmholtz Zentrum Berlin (HZB), emulating the ESS source with a pulse of 2.86 ms length and 14 Hz repetition rate, by using a mini-chopper operated at 140 Hz, beam monitors (BMs) and data acquisition infrastructure. The mini-chopper created well-defined neutron pulses and the BM was placed at two positions, enabling the average wavelength of each of the pulses created to be determined. The used experimental setup resulted in absolute wavelength determination at the monitor positions with a $δλ_{mean} / λ_{mean}$ of $\sim$1.8% for $λ>4$ Å. With a modest increase of the distance between the reference monitor positions a $δλ_{mean} / λ_{mean}$ of below 0.5% can be achieved. Further improvements are possible by using a thinner monitor, smaller chopper disc openings and a higher rotational speed chopper. The method requires only two neutron measurements and doesn't necessitate the use of crystals or complex fitting, and could constitute a suitable addition to imaging, diffraction, reflectometers and small angle neutron scattering instruments, at spallation sources, that do not normally utilise fast choppers.

physics.ins-det↗

arXiv2019

First neutron data recorded at the V20 Test Instrument utilizing prototype chopper systems and beam monitors planned for ESS

The main objective of the European Spallation Source (ESS) is to perform consistently high impact neutron scattering science using the highest neutron flux of any facility in its class. This ambition is naturally accompanied by operational challenges related to the vertical integration of the instruments' hardware and software shared between collaborators from 13 European countries. The present work will detail integration tests performed at the V20 Test Instrument at Helmholtz-Zentrum Berlin in Germany. An ESS chopper prototype was successfully controlled through the ESS Chopper Integration Controller (CHIC) and Experimental Physics and Industrial Control System (EPICS). Neutron data were successfully collected and time stamped using neutron beam monitors, the ESS prototype detector readout electronics and the Data Management Software Center (DMSC) data acquisition (DAQ) software. Chopper rotation events were timestamped and the chopper disk showed excellent stability and neutron absorption characteristics. The test resulted in (i) the expected time-of-flight (TOF) response, (ii) collected data that compared well with instrument reference data and (iii) revealing the diagnostic power of the performed integration tests. The results of this integration test validate the ESS chopper and detector DAQ architecture choices.

physics.ins-det↗

arXiv2018

Software-based data acquisition and processing for neutron detectors at European Spallation Source - early experience from four detector designs

European Spallation Source (ESS) will deliver neutrons at high flux for use in diverse neutron scattering techniques. The neutron source facility and the scientific instruments will be located in Lund, and the Data Management and Software Centre (DMSC), in Copenhagen. A number of detector prototypes are being developed at ESS together with its European in-kind partners, for example: SoNDe, Multi-Grid, Multi-Blade and Gd-GEM. These are all position sensitive detectors but use different techniques for the detection of neutrons. Except for digitization of electronics readout, all neutron data is anticipated to be processed in software. This provides maximum flexibility and adaptability and allows deep inspection of the raw data for commissioning which will reduce the risk of starting up new detector technologies. But it also requires development of high performance software processing pipelines and optimized and scalable processing algorithms. This report provides a description of the ESS system architecture for the neutron data path. Special focus is on the interface between the detectors and DMSC which is based on UDP over Ethernet links. The report also describes the software architecture for detector data processing and the tools we have developed, which have proven very useful for efficient early experimentation, and can be run on a single laptop. Processing requirements for the SoNDe, Multi-Grid, Multi-Blade and Ge-GEM detectors are presented and compared to event processing rates archived so far.

physics.ins-det↗

arXiv2015

Few-second-long correlation times in a quantum dot nuclear spin bath probed by frequency-comb NMR spectroscopy

One of the key challenges in spectroscopy is inhomogeneous broadening that masks the homogeneous spectral lineshape and the underlying coherent dynamics. A variety of techniques including four-wave mixing and spectral hole-burning are used in optical spectroscopy while in nuclear magnetic resonance (NMR) spin-echo is the most common way to counteract inhomogeneity. However, the high-power pulses used in spin-echo and other sequences often create spurious dynamics obscuring the subtle spin correlations that play a crucial role in quantum information applications. Here we develop NMR techniques that allow the correlation times of the fluctuations in a nuclear spin bath of individual quantum dots to be probed. This is achieved with the use of frequency comb excitation which allows the homogeneous NMR lineshapes to be measured avoiding high-power pulses. We find nuclear spin correlation times exceeding 1 s in self-assembled InGaAs quantum dots - four orders of magnitude longer than in strain-free III-V semiconductors. The observed freezing of the nuclear spin fluctuations opens the way for the design of quantum dot spin qubits with a well-understood, highly stable nuclear spin bath.

cond-mat.mes-hall↗

arXiv2015

An entangled-LED driven quantum relay over 1 km

Quantum cryptography allows confidential information to be communicated between two parties, with secrecy guaranteed by the laws of nature alone. However, upholding guaranteed secrecy over quantum communication networks poses a further challenge, as classical receive-and-resend routing nodes can only be used conditional of trust by the communicating parties. Here, we demonstrate the operation of a quantum relay over 1 km of optical fiber, which teleports a sequence of photonic quantum bits to a receiver by utilizing entangled photons emitted by a semiconductor LED. The average relay fidelity of the link is 0.90+/-0.03, exceeding the classical bound of 0.75 for the set of states used, and sufficiently high to allow error correction. The fundamentally low multi-photon emission statistics and the integration potential of the source present an appealing platform for future quantum networks.

quant-ph↗

arXiv2013

Heterogeneous teleportation with laser and quantum light sources

Quantum information technology is set to transform critical network security using quantum cryptography, and complex scientific and engineering simulations with quantum computing. Quantum computer nodes may be based on a variety of systems, such as linear optics, ions, or solid state architectures such as NV-centers in diamond, semiconductor quantum dots or spins in silicon. Interfacing any of these platforms with photonic qubits in secure quantum networks will require quantum teleportation protocols to transfer the information, and matter-light teleportation has for some of these systems been demonstrated. However, although it is conceivable that the input photon originates from a dissimilar source to that supplying the entangled resources, every demonstration so far of teleportation using linear optics use the same or identical sources for the input and entangled photons, often accompanied by a fourth heralding photon. Here we show that photons from fundamentally different sources can be used in the optical quantum teleportation protocol. Input photons are generated by a laser, and teleported using polarisation-entangled photon pairs electrically generated by an entangled-light-emitting diode (ELED). The sources have bandwidth differing by a factor 1000, different photon statistics and need not be precisely degenerate- but we still observe a teleportation fidelity of 0.77, beating the quantum limit by 10 standard deviations. This is a significant leap towards practical applications, such as extending the range of existing QKD systems using quantum relays and repeaters, which usually use weak coherent laser pulses for quantum information transport. The use of an ELED offers practical advantages of electrical control, and as we show erases the multi-photon character of the laser input field, thus eliminating errors if used in a quantum optics circuit.

quant-ph↗

arXiv2013

Voltage control of electron-nuclear spin correlation time in a single quantum dot

We demonstrate bias control of the hyperfine coupling between a single electron in an InAs quantum dot and the surrounding nuclear spins monitored through the positively charged exciton X+ emission. In applied longitudinal magnetic fields we vary simultaneously the correlation time of the hyperfine interaction and the nuclear spin relaxation time and thereby the amplitude of the achieved dynamic nuclear polarization under optical pumping conditions. In applied transverse magnetic fields a change in the applied bias allows to switch from the anomalous Hanle effect to the standard electron spin depolarization curves.

cond-mat.mes-hall↗

arXiv2009

Observation of the Kohn anomaly near the K point of bilayer graphene

The dispersion of electrons and phonons near the K point of bilayer graphene was investigated in a resonant Raman study using different laser excitation energies in the near infrared and visible range. The electronic structure was analyzed within the tight-binding approximation, and the Slonczewski-Weiss-McClure (SWM) parameters were obtained from the analysis of the dispersive behavior of the Raman features. A softening of the phonon branches was observed near the K point, and results evidence the Kohn anomaly and the importance of considering electron-phonon and electron-electron interactions to correctly describe the phonon dispersion in graphene systems.

cond-mat.mes-hall↗

arXiv2008

f-Sum Rule and Unconventional Spectral Weight Transfer in Graphene

We derive and analyze the f-sum rule for a two-dimensional (2D) system of interacting electrons whose behavior is described by the Dirac equation. We apply the sum rule to analyze the spectral weight transfer in graphene within different approximations discussed in the literature. We find that the sum rule is generically dominated by inter-band transitions while other excitations produce sub-leading behavior. The f-sum rule provides strong constraints for theories of interacting electrons in graphene.

cond-mat.mes-hall↗

arXiv2007

Probing the Electronic Structure of Bilayer Graphene by Raman Scattering

The electronic structure of bilayer graphene is investigated from a resonant Raman study using different laser excitation energies. The values of the parameters of the Slonczewski-Weiss-McClure model for graphite are measured experimentally and some of them differ significantly from those reported previously for graphite, specially that associated with the difference of the effective mass of electrons and holes. The splitting of the two TO phonon branches in bilayer graphene is also obtained from the experimental data. Our results have implications for bilayer graphene electronic devices.

cond-mat.mtrl-sci↗

arXiv2003

Processing Issues in Top-Down Approaches to Quantum Computer Development in Silicon

We describe critical processing issues in our development of single atom devices for solid-state quantum information processing. Integration of single 31P atoms with control gates and single electron transistor (SET) readout structures is addressed in a silicon-based approach. Results on electrical activation of low energy (15 keV) P implants in silicon show a strong dose effect on the electrical activation fractions. We identify dopant segregation to the SiO2/Si interface during rapid thermal annealing as a dopant loss channel and discuss measures of minimizing it. Silicon nanowire SET pairs with nanowire width of 10 to 20 nm are formed by electron beam lithography in SOI. We present first results from Coulomb blockade experiments and discuss issues of control gate integration for sub-40nm gate pitch levels.

cond-mat↗