arXiv subjects

J. Sears

Publications and source records attributed to J. Sears.

21 records · Page 2Linked to original sources

arXiv2016

Seeding the m = 0 instability in dense plasma focus Z-pinches with a hollow anode

The dense plasma focus (DPF) is a classic Z-pinch plasma device that has been studied for decades as a radiation source. The formation of the m = 0 plasma instability during the compression phase is linked to the generation of high-energy charged particle beams, which, when operated in deuterium, lead to beam-target fusion reactions and the generation of neutron yield. In this paper, we present a technique of seeding the m = 0 instability by employing a hollow in the anode. As the plasma sheath moves along the anode's hollow structure, a low density perturbation is formed and this creates a non-uniform plasma column which is highly unstable. Dynamics of the low density perturbation and preferential seeding of the m = 0 instability were studied in detail with fully kinetic plasma simulations performed in the Large Scale Plasma particle-in-cell code as well as with a simple snowplow model. The simulations showed that by employing an anode geometry with appropriate inner hollow radius, the neutron yield of the DPF is significantly improved and low-yield shots are eliminated.

physics.plasm-ph↗

arXiv2015

Thermocurrents and their Role in high Q Cavity Performance

Over the past years it became evident that the quality factor of a superconducting cavity is not only determined by its surface preparation procedure, but is also influenced by the way the cavity is cooled down. Moreover, different data sets exists, some of them indicate that a slow cool-down through the critical temperature is favourable while other data states the exact opposite. Even so there where speculations and some models about the role of thermo-currents and flux-pinning, the difference in behaviour remained a mystery. In this paper we will for the first time present a consistent theoretical model which we confirmed by data that describes the role of thermo-currents, driven by temperature gradients and material transitions. We will clearly show how they impact the quality factor of a cavity, discuss our findings, relate it to findings at other labs and develop mitigation strategies which especially addresses the issue of achieving high quality factors of so-called nitrogen doped cavities in horizontal test.

physics.acc-ph↗

arXiv2014

Sudden reversal in the pressure dependence of Tc in the iron-based superconductor CsFe2As2: A possible link between inelastic scattering and pairing symmetry

We report a sudden reversal in the pressure dependence of Tc in the iron-based superconductor CsFe2As2, similar to that discovered recently in KFe2As2 [Tafti et al., Nat. Phys. 9, 349 (2013)]. As in KFe2As2, we observe no change in the Hall coefficient at the zero temperature limit, again ruling out a Lifshitz transition across the critical pressure Pc. We interpret the Tc reversal in the two materials as a phase transition from one pairing state to another, tuned by pressure, and investigate what parameters control this transition. Comparing samples of different residual resistivity, we find that a 6-fold increase in impurity scattering does not shift Pc. From a study of X-ray diffraction on KFe2As2 under pressure, we report the pressure dependence of lattice constants and As-Fe-As bond angle. The pressure dependence of these lattice parameters suggests that Pc should be significantly higher in CsFe2As2 than in KFe2As2, but we find on the contrary that Pc is lower in CsFe2As2. Resistivity measurements under pressure reveal a change of regime across Pc, suggesting a possible link between inelastic scattering and pairing symmetry.

cond-mat.supr-con↗