arXiv subjects

J. Urakawa

Publications and source records attributed to J. Urakawa.

At least 19 recordsLinked to original sources

arXiv2018

Theoretical and Simulation Study of 'Comb' Electron beam and THz generation

A compact accelerator based super-radiant THz source is under development at Inter University Accelerator Centre (IUAC), New Delhi. The facility is based on the principle of pre-bunched Free Electron Laser (FEL) which will produce THz radiation in the range of ~0.18 to 3 THz from a modulated electron beam. A photocathode electron gun will generate a short train of microbunches (a "comb" beam) driven by a fiber laser system capable of producing multi micro-pulse laser beam with variable separation ( "comb" laser pulse). Upon acceleration, the electron beam will be injected in to a compact undulator magnet tuned to the same frequency as the separation of the electron micro-bunches. The paper discusses the process of enhancement of super-radiant emission of radiation due to modulation in the comb beam and the conditions required to achieve maximum enhancement of the radiation power. The feasibility study of generating a comb beam at the photocathode and its transport through the beamline while preserving its temporal structure has been reported. To evaluate the characteristics of the radiation emitted from the comb beam, a C++ based particle tracker and Lienard-Wiechert field solver has been developed. The conceptual understanding of the emission of radiation from comb beam is shown to conform with the numerical results. The code has been used to calculate the radiation pulse energy emitted into the central cone of undulator for various comb beam configurations.

physics.acc-ph↗

arXiv2017

Sub - THz Radiation from Dielectric Capillaries with Reflectors

In this report we present experimental investigations of THz radiation generated from a corrugated and a non-corrugated capillary with reflectors, using a femtosecond electron beam of LUCX accelerator at KEK, Japan. We discuss measurements of radiation angular distributions and their comparison with Particle In Cell simulations, and also investigate an off-central propagation of the beam in the capillaries based on experimental measurements and simulations.

physics.acc-ph↗

arXiv2017

Development of optical resonant cavities for laser-Compton scattering

We have been developing optical resonant cavities for laser-Compton scattering experiment at the Accelerator Test Facility in KEK. The main subject of the R&D is to increase laser pulse energy by coherently accumulating the pulses in an optical resonant cavity. We report previous results, current status and future prospects, including a new idea of an optical resonant cavity.

physics.acc-ph↗

arXiv2017

Femtosecond response time measurements of a Cs2Te photocathode

We present the response time measurements of a Cs2Te photocathode illuminated with two 100 fs duration, variable time separation laser pulses at 266 nm wavelength. The response time was confirmed in dispersive region downstream of a 12-cell standing wave S-band acceleration structure using a well-known RF zero-crossing technique. At the same time it was also measured by changing mechanical path-length difference between two micro-bunches. Both methods agree that Cs2Te photocathode time response is of the order of 250 fs and thereby it is possible to generate and control a THz sequence of relativistic electron bunches by a conventional S-band RF gun. This result further opens a possibility to construct wide-range tunable THz FEL.

physics.acc-ph↗

arXiv2017

Monochromaticity of coherent Smith-Purcell radiation from finite size grating

Investigation of coherent Smith-Purcell Radiation (SPR) spectral characteristics was performed both experimentally and by numerical simulation. The measurement of SPR spectral line shapes of different diffraction orders was carried out at KEK LUCX facility. A pair of room-temperature Schottky barrier diode (SBD) detectors with sensitivity bands of $60-90$~GHz and $320-460$~GHz was used in the measurements. Reasonable agreement of experimental results and simulations performed with CST Studio Suite justifies the use of different narrow-band SBD detectors to investigate different SPR diffraction orders. It was shown that monochromaticity of the SPR spectral lines increases with diffraction order. The comparison of coherent transition radiation and coherent SPR intensities in sub-THz frequency range showed that the brightnesses of both radiation mechanisms were comparable. A fine tuning feasibility of the SPR spectral lines is discussed.

physics.acc-ph↗

arXiv2016

Feedback-free optical cavity with self-resonating mechanism

We demonstrated the operation of a high finesse optical cavity without utilizing an active feedback system to stabilize the resonance. The effective finesse, which is a finesse including the overall system performance, of the cavity was measured to be $394,000 \pm 10,000$, and the laser power stored in the cavity was $2.52 \pm 0.13$ kW, which is approximately 187,000 times greater than the incident power to the cavity. The stored power was stabilized with a fluctuation of $1.7 \%$, and we confirmed continuous cavity operation for more than two hours. This result has the potential to trigger an innovative evolution for applications that use optical resonant cavities such as compact photon sources with laser-Compton scattering or cavity enhanced absorption spectroscopy.

physics.optics↗

arXiv2014

Laserwire at the Accelerator Test Facility 2 with Sub-Micrometre Resolution

A laserwire transverse electron beam size measurement system has been developed and operated at the Accelerator Test Facility 2 (ATF2) at KEK. Special electron beam optics were developed to create an approximately 1 x 100 μm (vertical x horizontal) electron beam at the laserwire location, which was profiled using a 150 mJ, 71 ps laser pulse with a wavelength of 532 nm. The precise characterisation of the laser propagation allows the non-Gaussian transverse profiles of the electron beam caused by the laser divergence to be deconvolved. A minimum vertical electron beam size of 1.07 ${\pm}$ 0.06 (stat.) ${\pm}$ 0.05 (sys.) μm was measured. A vertically focussing quadrupole just before the laserwire was varied whilst making laserwire measurements and the projected vertical emittance was measured to be 82.56 ${\pm}$ 3.04 pm rad.

physics.acc-ph↗

arXiv2014

Principal Component Analysis of Cavity Beam Position Monitor Signals

Model-independent analysis (MIA) methods are generally useful for analysing complex systems in which relationships between the observables are non-trivial and noise is present. Principle Component Analysis (PCA) is one of MIA methods allowing to isolate components in the input data graded to their contribution to the variability of the data. In this publication we show how the PCA can be applied to digitised signals obtained from a cavity beam position monitor (CBPM) system on the example of a 3-cavity test system installed at the Accelerator Test Facility 2 (ATF2) at KEK in Japan. We demonstrate that the PCA based method can be used to extract beam position information, and matches conventional techniques in terms of performance, while requiring considerably less settings and data for calibration.

physics.acc-ph↗

arXiv2013

Observation of the Stimulated Coherent Diffraction Radiation in an Open Resonator at LUCX Facility

We present an initial test of a new type of a pre-bunched beam pumped free electron maser based on Stimulated Coherent Diffraction Radiation (SCDR) generated in an open resonator. An ultra-fast Schottky Barrier Diode (time response $<1\,$ns) has enabled to investigate the properties of the radiation stored in the cavity as well as the intrinsic properties of the cavity itself. We observed a turn-by-turn SCDR generated by a multibunch beam. When the cavity length was exactly a half of the bunch spacing a clear resonance was observed. Moreover, turn-by-turn measurements revealed the cavity quality factor of $72.88$, which was rather high for an open resonator in the wavelength range of $3-5\,$mm. An exponential growth of the photon intensity as a function of the number of bunches was also demonstrated.

physics.acc-ph↗

arXiv2013

Development of an intense positron source using a crystal--amorphous hybrid target for linear colliders

In a conventional positron source driven by a few GeV electron beam, a high amount of heat is loaded into a positron converter target to generate intense positrons required by linear colliders, and which would eventually damage the converter target. A hybrid target, composed of a single crystal target as a radiator of intense gamma--rays, and an amorphous converter target placed downstream of the crystal, was proposed as a scheme which could overcome the problem.This paper describes the development of an intense positron source with the hybrid target. A series of experiments on positron generation with the hybrid target has been carried out with a 8--GeV electron beam at the KEKB linac. We observed that positron yield from the hybrid target increased when the incident electron beam was aligned to the crystal axis and exceeded the one from the conventional target with the converter target of the same thickness, when its thickness is less than about 2 radiation length. The measurements in the temperature rise of the amorphous converter target was successfully carried out by use of thermocouples. These results lead to establishment to the evaluation of the hybrid target as an intense positron source.

physics.acc-ph↗

arXiv2013

Cavity beam position monitor system for the Accelerator Test Facility 2

The Accelerator Test Facility 2 (ATF2) is a scaled demonstrator system for final focus beam lines of linear high energy colliders. This paper describes the high resolution cavity beam position monitor (BPM) system, which is a part of the ATF2 diagnostics. Two types of cavity BPMs are used, C-band operating at 6.423 GHz, and S-band at 2.888 GHz with an increased beam aperture. The cavities, electronics, and digital processing are described. The resolution of the C-band system with attenuators was determined to be approximately 250 nm and 1 m for the S-band system. Without attenuation the best recorded C-band cavity resolution was 27 nm.

physics.acc-ph↗

arXiv2012

High Resolution BPM Upgrade for the ATF Damping Ring at KEK

A beam position monitor (BPM) upgrade at the KEK Accelerator Test Facility (ATF) damping ring has been accomplished, carried out by a KEK/FNAL/SLAC collaboration under the umbrella of the global ILC R&D effort. The upgrade consists of a high resolution, high reproducibility read-out system, based on analog and processing, and also implements a new automatic gain error correction schema. The technical concept and realization as well as results of beam studies are presented.

physics.acc-ph↗

arXiv2012

Present status and first results of the final focus beam line at the KEK Accelerator Test Facility

ATF2 is a final-focus test beam line which aims to focus the low emittance beam from the ATF damping ring to a vertical size of about 37 nm and to demonstrate nanometer level beam stability. Several advanced beam diagnostics and feedback tools are used. In December 2008, construction and installation were completed and beam commissioning started, supported by an international team of Asian, European, and U.S. scientists. The present status and first results are described.

physics.acc-ph↗

arXiv2012

Production of gamma rays by pulsed laser beam Compton scattering off GeV-electrons using a non-planar four-mirror optical cavity

As part of the positron source R&D for future $e^+-e^-$ colliders and Compton based compact light sources, a high finesse non-planar four-mirror Fabry-Perot cavity has recently been installed at the ATF (KEK, Tsukuba, Japan). The first measurements of the gamma ray flux produced with a such cavity using a pulsed laser is presented here. We demonstrate the production of a flux of 2.7 $\pm$ 0.2 gamma rays per bunch crossing ($\sim3\times10^6$ gammas per second) during the commissioning.

physics.acc-ph↗

arXiv2011

Effect of Compton Scattering on the Electron Beam Dynamics at the ATF Damping Ring

Compton scattering provides one of the most promising scheme to obtain polarized positrons for the next generation of $e^-$ -- $e^+$ colliders. Moreover it is an attractive method to produce monochromatic high energy polarized gammas for nuclear applications and X-rays for compact light sources. In this framework a four-mirror Fabry-Pérot cavity has been installed at the Accelerator Test Facility (ATF - KEK, Tsukuba, Japan) and is used to produce an intense flux of polarized gamma rays by Compton scattering \cite{ipac-mightylaser}. For electrons at the ATF energy (1.28 GeV) Compton scattering may result in a shorter lifetime due to the limited bucket acceptance. We have implemented the effect of Compton scattering on a 2D tracking code with a Monte-Carlo method. This code has been used to study the longitudinal dynamics of the electron beam at the ATF damping ring, in particular the evolution of the energy spread and the bunch length under Compton scattering. The results obtained are presented and discussed. Possible methods to observe the effect of Compton scattering on the ATF beam are proposed.

physics.acc-ph↗

arXiv2011

High flux polarized gamma rays production: first measurements with a four-mirror cavity at the ATF

The next generation of e+/e- colliders will require a very intense flux of gamma rays to allow high current polarized positrons to be produced. This can be achieved by converting polarized high energy photons in polarized pairs into a target. In that context, an optical system consisting of a laser and a four-mirror passive Fabry-Perot cavity has recently been installed at the Accelerator Test Facility (ATF) at KEK to produce a high flux of polarized gamma rays by inverse Compton scattering. In this contribution, we describe the experimental system and present preliminary results. An ultra-stable four-mirror non planar geometry has been implemented to ensure the polarization of the gamma rays produced. A fiber amplifier is used to inject about 10W in the high finesse cavity with a gain of 1000. A digital feedback system is used to keep the cavity at the length required for the optimal power enhancement. Preliminary measurements show that a flux of about $4\times10^6 γ$/s with an average energy of about 24 MeV was generated. Several upgrades currently in progress are also described.

physics.acc-ph↗

arXiv2010

Shintake Monitor in ATF2: Performance Evaluation

The beam test for the Shintake monitor succeeded in measuring signal modulation with the laser interference fringe pattern in November 2009. We have studied the error sources, and evaluated the systematic error to be less than 30% for 1 minute measurements. This paper centers on the evaluation of the Shintake monitor performance through analyzing beam tests deta. Most systematic error sources are well understood, enabling accurate measurement of the beam size when it reaches 37 nm.

physics.ins-det↗

arXiv2006

Efficient propagation of the polarization from laser photons to positrons through Compton scattering and electron-positron pair creation

We demonstrated for the first time the production of highly polarized short-pulse positrons with a finite energy spread in accordance with a new scheme that consists of two-quantum processes, such as inverse Compton scatterings and electron-positron pair creations. Using a circularly polarized laser beam of 532 nm scattered off a high-quality electron beam with the energy of 1.28 GeV, we obtained polarized positrons with an intensity of 10^4 e+/bunch. Magnitude of positron polarizations was determined as 73+-15(sta) +-19(sys)% by means of a newly designed positron polarimeter.

hep-ex↗