arXiv subjects

JET-EFDA contributors

Publications and source records attributed to JET-EFDA contributors.

5 recordsLinked to original sources

arXiv2014

Surface analysis of tiles and samples exposed to the first JET campaigns with the ITER-Like Wall

This paper reports on the first post-mortem analyses of tiles removed from JET after the first campaigns with the ITER-like Wall (ILW) during 2011-2 [1]. Tiles from the divertor have been analysed by the Ion Beam Analysis (IBA) techniques Rutherford Backscattering Spectroscopy (RBS) and Nuclear Reaction Analysis (NRA) and by Secondary Ion Mass Spectrometry (SIMS) to determine the amount of beryllium deposition and deuterium retention in the tiles exposed to the scrape-off layer. Films 10-20 microns thick were present at the top of Tile 1, but only very thin films (<1 micron) were found in the shadowed areas and on other divertor tiles. The total amount of Be found in the divertor following the ILW campaign was a factor of ~9 less that the material deposited in the 2007-9 carbon campaign, after allowing for the longer operations in 2007-9.

physics.ins-det↗

arXiv2013

Impact of nitrogen seeding on confinement and power load control of a high-triangularity JET ELMy H-mode plasma with a metal wall

This paper reports the impact on confinement and power load of the high-shape 2.5MA ELMy H-mode scenario at JET of a change from an all carbon plasma facing components to an all metal wall. In preparation to this change, systematic studies of power load reduction and impact on confinement as a result of fuelling in combination with nitrogen seeding were carried out in JET-C and are compared to their counterpart in JET with a metallic wall. An unexpected and significant change is reported on the decrease of the pedestal confinement but is partially recovered with the injection of nitrogen.

physics.plasm-ph↗

arXiv2013

Design and operations of load-tolerant external conjugate-T matching system for the A2 ICRH antennas at JET

A load-tolerant External Conjugate-T (ECT) impedance matching system for two A2 Ion Cyclotron Resonance Heating (ICRH) antennas has been successfully put into operation at JET. The system allows continuous injection of the RF power into plasma in the presence of strong antenna loading perturbations caused by Edge Localized Modes (ELMs). Reliable ECT performance has been demonstrated under a variety of antenna loading conditions including H-mode plasmas with Radial Outer Gaps (ROG) in the range of 4-14 cm. The high resilience to ELMs predicted during the circuit simulations has been fully confirmed experimentally. Dedicated arc detection techniques and real-time matching algorithms have been developed as a part of the ECT project. The new Advanced Wave Amplitude Comparison System (AWACS) has proven highly efficient in detection of arcs both between and during ELMs. The ECT system has allowed the delivery of up to 4 MW of RF power without trips into plasmas with Type-I ELMs. Together with the 3dB system and the ITER-Like Antenna (ILA), the ECT has brought the total RF power coupled to ELMy plasma to over 8 MW, considerably enhancing JET research capabilities. This paper provides an overview of the key design features of the ECT system and summarizes the main experimental results achieved so far.

physics.plasm-ph↗

arXiv2013

Ion temperature profile stiffness: non-linear gyrokinetic simulations and comparison with experiment

Recent experimental observations at JET show evidence of reduced ion temperature profile stiffness, hypothesised to be due to concomitant low magnetic shear (s) and significant toroidal rotational flow shear. Non-linear gyrokinetic simulations are performed, aiming to investigate the physical mechanism behind the observations. A comprehensive set of simulations are carried out, comparing the impact on the ion heat flux of various parameters that differ within the data-set. These parameters include q, s, rotation, effect of rotation on the magnetohydrodynamic (MHD) equilibrium, R/L_n, beta_e, Z_eff, and the fast particle content. The effect of toroidal flow shear itself is not predicted by the simulations to lead to a significant reduction in ion heat flux, due both to an insufficient magnitude of flow shear and significant parallel velocity gradient destabilisation. It is however found that non-linear electromagnetic effects due to both thermal and fast-particle pressure gradients, even at low beta_e, can significantly reduce the profile stiffness. A total of five discharges are examined, at both inner and outer radii. For all cases studied, the simulated and experimental ion heat flux values agree within reasonable variations of input parameters around the experimental uncertainties.

physics.plasm-ph↗

arXiv2013

Nonlinear stabilization of tokamak microturbulence by fast ions

Nonlinear electromagnetic stabilization by suprathermal pressure gradients found in specific regimes is shown to be a key factor in reducing tokamak microturbulence, augmenting significantly the thermal pressure electromagnetic stabilization. Based on nonlinear gyrokinetic simulations investigating a set of ion heat transport experiments on the JET tokamak, described by Mantica et al. [Phys. Rev. Lett. 107 135004 (2011)], this result explains the experimentally observed ion heat flux and stiffness reduction. These findings are expected to improve the extrapolation of advanced tokamak scenarios to reactor relevant regimes.

physics.plasm-ph↗