arXiv subjects

Jacob Egge

Publications and source records attributed to Jacob Egge.

5 recordsLinked to original sources

arXiv2026

Any Light Particle Searches with ALPS II: Description of the first science campaign

From February to May of 2024 the Any Light Particle Search II (ALPS II) conducted its first science campaign using the `light-shining-through-a-wall' technique to search for pseudo-Goldstone bosons that lie beyond the Standard Model of particle physics and which are inaccessible by accelerator-based experiments. The experimental setup consists of two strings of superconducting dipole magnets, each more than 100 m long, that are separated by a wall. Laser light is directed through the first magnet string and a heterodyne detection system is used to measure the electromagnetic power that traverses a wall via the conversion to and then from a bosonic field. After the wall, a high-finesse optical cavity resonantly enhances the signal power. Two searches were carried out, one with the laser polarized perpendicular to the magnetic field direction and another with its polarization state aligned parallel to the magnetic field. No evidence for the existence of new bosons was found. In its first science campaign, ALPS II reached photon-boson conversion probability sensitivities of a few $10^{-13}$. The ongoing upgrade of the optical system aims to increase this sensitivity by about four orders of magnitude.

hep-ex↗

arXiv2025

Any Light Particle Searches with ALPS II: first science results

The light-shining-through-a-wall experiment ALPS II at DESY in Hamburg searched for axions and similar lightweight particles in its first science campaign from February to May 2024. No evidence for the existence of such particles was found. For pseudoscalar bosons like the axion, with masses below about 0.1 meV, we achieved a limit for the di-photon coupling strength of 1.5e-9 1/GeV at a 95% confidence level. This is more than a factor of 20 improvement compared to all previous similar experiments. We also provide limits on photon interactions for scalar, vector and tensor bosons. An achievement of this first science campaign is the demonstration of stable operation and robust calibration of the complex experiment. Currently, the optical system of ALPS II is being upgraded aiming for another two orders of magnitude sensitivity increase.

hep-ex↗

arXiv2025

Sensitivity of a Gigahertz Fabry-P\'erot Resonator for Axion Dark Matter Detection

Axions are hypothetical pseudo-Nambu Goldstone bosons that could explain the observed cold dark matter density and solve the strong CP problem of quantum chromodynamics (QCD). Haloscope experiments commonly employ resonant cavities to search for a conversion of axion dark matter into photons in external magnetic fields. As the expected signal power degrades with increasing frequency, this approach becomes challenging at frequencies beyond tens of Gigahertz. Here, we propose a novel haloscope design based on an open Fabry-P\'erot resonator. Operating a small-scale resonator at cryogenic temperatures and at modest magnetic fields should already lead to an unparalleled sensitivity for photon-axion couplings $g_{a\gamma} \gtrsim 3\times10^{-12}\,\mathrm{GeV}^{-1}$ at 35GHz. We demonstrate how this sensitivity could be further improved using graded-phase mirrors and sketch possibilities to probe benchmark models of the QCD axion.

physics.ins-det↗

arXiv2022

Axion haloscope signal power from reciprocity

Axion haloscopes search for dark matter axions from the galactic halo, most commonly by measuring a power excess sourced by the axion effective current density. Constraining axion parameters from detection or lack thereof requires estimating the expected signal power. Often, this is done by studying the response of the haloscope to a known, but different, source current density, for example via a reflection measurement. However, only in the special case when both sources induce the same electromagnetic fields, do the quantities derived from a reflection measurement adequately describe the setup during an axion measurement. While this might be valid for the traditional resonant cavity haloscope, new broadband or open designs like dish antennas or dielectric haloscopes cannot make this assumption. A more general relation between axion- and reflection-induced fields is needed. In this article, we use the Lorentz reciprocity theorem to derive an expression for the axion signal power which instead of the unmeasurable axion-induced fields depends on the measurable reflection-induced fields. This entirely circumvents the need to know the response of the haloscope to the unknown axion source. It applies to a wide variety of haloscopes including resonant cavities, dielectric haloscopes, and broadband dish antennas.

hep-ph↗

arXiv2020

A first proof of principle booster setup for the MADMAX dielectric haloscope

Axions and axion-like particles are excellent low-mass dark matter candidates. The MADMAX experiment aims to directly detect galactic axions with masses between $40\,μ{\rm eV}$ and $400\,μ{\rm eV}$ by using the axion-induced emission of electromagnetic waves from boundaries between materials of different dielectric constants under a strong magnetic field. Combining many such surfaces, this emission can be significantly enhanced (boosted) using constructive interference and resonances. We present a first proof of principle realization of such a booster system consisting of a copper mirror and up to five sapphire disks. The electromagnetic response of the system is investigated by reflectivity measurements. The mechanical accuracy, calibration process of unwanted reflections and the repeatability of a basic tuning algorithm to place the disks are investigated. We find that for the presented cases the electromagnetic response in terms of the group delay predicted by one-dimensional calculations is sufficiently realized in our setup. The repeatability of the tuning is at the percent level, and would have small impact on the sensitivity of such a booster.

physics.ins-det↗