Searcharxiv⌕ Search

arXiv subjects

Jagmohan Chauhan

Publications and source records attributed to Jagmohan Chauhan.

28 records · Page 2Linked to original sources

The INTERSPEECH 2021 Computational Paralinguistics Challenge: COVID-19 Cough, COVID-19 Speech, Escalation & Primates

The INTERSPEECH 2021 Computational Paralinguistics Challenge addresses four different problems for the first time in a research competition under well-defined conditions: In the COVID-19 Cough and COVID-19 Speech Sub-Challenges, a binary classification on COVID-19 infection has to be made based on coughing sounds and speech; in the Escalation SubChallenge, a three-way assessment of the level of escalation in a dialogue is featured; and in the Primates Sub-Challenge, four species vs background need to be classified. We describe the Sub-Challenges, baseline feature extraction, and classifiers based on the 'usual' COMPARE and BoAW features as well as deep unsupervised representation learning using the AuDeep toolkit, and deep feature extraction from pre-trained CNNs using the Deep Spectrum toolkit; in addition, we add deep end-to-end sequential modelling, and partially linguistic analysis.

eess.AS↗

The Benefit of the Doubt: Uncertainty Aware Sensing for Edge Computing Platforms

Neural networks (NNs) lack measures of "reliability" estimation that would enable reasoning over their predictions. Despite the vital importance, especially in areas of human well-being and health, state-of-the-art uncertainty estimation techniques are computationally expensive when applied to resource-constrained devices. We propose an efficient framework for predictive uncertainty estimation in NNs deployed on embedded edge systems with no need for fine-tuning or re-training strategies. To meet the energy and latency requirements of these embedded platforms the framework is built from the ground up to provide predictive uncertainty based only on one forward pass and a negligible amount of additional matrix multiplications with theoretically proven correctness. Our aim is to enable already trained deep learning models to generate uncertainty estimates on resource-limited devices at inference time focusing on classification tasks. This framework is founded on theoretical developments casting dropout training as approximate inference in Bayesian NNs. Our layerwise distribution approximation to the convolution layer cascades through the network, providing uncertainty estimates in one single run which ensures minimal overhead, especially compared with uncertainty techniques that require multiple forwards passes and an equal linear rise in energy and latency requirements making them unsuitable in practice. We demonstrate that it yields better performance and flexibility over previous work based on multilayer perceptrons to obtain uncertainty estimates. Our evaluation with mobile applications datasets shows that our approach not only obtains robust and accurate uncertainty estimations but also outperforms state-of-the-art methods in terms of systems performance, reducing energy consumption (up to 28x), keeping the memory overhead at a minimum while still improving accuracy (up to 16%).

cs.LG↗

Exploring Automatic COVID-19 Diagnosis via voice and symptoms from Crowdsourced Data

The development of fast and accurate screening tools, which could facilitate testing and prevent more costly clinical tests, is key to the current pandemic of COVID-19. In this context, some initial work shows promise in detecting diagnostic signals of COVID-19 from audio sounds. In this paper, we propose a voice-based framework to automatically detect individuals who have tested positive for COVID-19. We evaluate the performance of the proposed framework on a subset of data crowdsourced from our app, containing 828 samples from 343 participants. By combining voice signals and reported symptoms, an AUC of $0.79$ has been attained, with a sensitivity of $0.68$ and a specificity of $0.82$. We hope that this study opens the door to rapid, low-cost, and convenient pre-screening tools to automatically detect the disease.

cs.SD↗

Exploring Automatic Diagnosis of COVID-19 from Crowdsourced Respiratory Sound Data

Audio signals generated by the human body (e.g., sighs, breathing, heart, digestion, vibration sounds) have routinely been used by clinicians as indicators to diagnose disease or assess disease progression. Until recently, such signals were usually collected through manual auscultation at scheduled visits. Research has now started to use digital technology to gather bodily sounds (e.g., from digital stethoscopes) for cardiovascular or respiratory examination, which could then be used for automatic analysis. Some initial work shows promise in detecting diagnostic signals of COVID-19 from voice and coughs. In this paper we describe our data analysis over a large-scale crowdsourced dataset of respiratory sounds collected to aid diagnosis of COVID-19. We use coughs and breathing to understand how discernible COVID-19 sounds are from those in asthma or healthy controls. Our results show that even a simple binary machine learning classifier is able to classify correctly healthy and COVID-19 sounds. We also show how we distinguish a user who tested positive for COVID-19 and has a cough from a healthy user with a cough, and users who tested positive for COVID-19 and have a cough from users with asthma and a cough. Our models achieve an AUC of above 80% across all tasks. These results are preliminary and only scratch the surface of the potential of this type of data and audio-based machine learning. This work opens the door to further investigation of how automatically analysed respiratory patterns could be used as pre-screening signals to aid COVID-19 diagnosis.

cs.SD↗

A First Step Towards On-Device Monitoring of Body Sounds in the Wild

Body sounds provide rich information about the state of the human body and can be useful in many medical applications. Auscultation, the practice of listening to body sounds, has been used for centuries in respiratory and cardiac medicine to diagnose or track disease progression. To date, however, its use has been confined to clinical and highly controlled settings. Our work addresses this limitation: we devise a chest-mounted wearable for continuous monitoring of body sounds, that leverages data processing algorithms that run on-device. We concentrate on the detection of heart sounds to perform heart rate monitoring. To improve robustness to ambient noise and motion artefacts, our device uses an algorithm that explicitly segments the collected audio into the phases of the cardiac cycle. Our pilot study with 9 users demonstrates that it is possible to obtain heart rate estimates that are competitive with commercial heart rate monitors, with low enough power consumption for continuous use.

cs.HC↗

BreathRNNet: Breathing Based Authentication on Resource-Constrained IoT Devices using RNNs

Recurrent neural networks (RNNs) have shown promising results in audio and speech processing applications due to their strong capabilities in modelling sequential data. In many applications, RNNs tend to outperform conventional models based on GMM/UBMs and i-vectors. Increasing popularity of IoT devices makes a strong case for implementing RNN based inferences for applications such as acoustics based authentication, voice commands, and edge analytics for smart homes. Nonetheless, the feasibility and performance of RNN based inferences on resources-constrained IoT devices remain largely unexplored. In this paper, we investigate the feasibility of using RNNs for an end-to-end authentication system based on breathing acoustics. We evaluate the performance of RNN models on three types of devices; smartphone, smartwatch, and Raspberry Pi and show that unlike CNN models, RNN models can be easily ported onto resource-constrained devices without a significant loss in accuracy.

cs.CR↗

BehavioCog: An Observation Resistant Authentication Scheme

We propose that by integrating behavioural biometric gestures---such as drawing figures on a touch screen---with challenge-response based cognitive authentication schemes, we can benefit from the properties of both. On the one hand, we can improve the usability of existing cognitive schemes by significantly reducing the number of challenge-response rounds by (partially) relying on the hardness of mimicking carefully designed behavioural biometric gestures. On the other hand, the observation resistant property of cognitive schemes provides an extra layer of protection for behavioural biometrics; an attacker is unsure if a failed impersonation is due to a biometric failure or a wrong response to the challenge. We design and develop an instantiation of such a "hybrid" scheme, and call it BehavioCog. To provide security close to a 4-digit PIN---one in 10,000 chance to impersonate---we only need two challenge-response rounds, which can be completed in less than 38 seconds on average (as estimated in our user study), with the advantage that unlike PINs or passwords, the scheme is secure under observation.

cs.CR↗

Are wearable devices ready for HTTPS? Measuring the cost of secure communication protocols on wearable devices

The majority of available wearable devices require communication with Internet servers for data analysis and storage, and rely on a paired smartphone to enable secure communication. However, wearable devices are mostly equipped with WiFi network interfaces, enabling direct communication with the Internet. Secure communication protocols should then run on these wearables itself, yet it is not clear if they can be efficiently supported. In this paper, we show that wearable devices are ready for direct and secure Internet communication by means of experiments with both controlled and Internet servers. We observe that the overall energy consumption and communication delay can be reduced with direct Internet connection via WiFi from wearables compared to using smartphones as relays via Bluetooth. We also show that the additional HTTPS cost caused by TLS handshake and encryption is closely related to number of parallel connections, and has the same relative impact on wearables and smartphones.

cs.CR↗

Gesture-based Continuous Authentication for Wearable Devices: the Google Glass Case

We study the feasibility of touch gesture behavioural biometrics for implicit authentication of users on a smartglass (Google Glass) by proposing a continuous authentication system using two classifiers: SVM with RBF kernel, and a new classifier based on Chebyshev's concentration inequality. Based on data collected from 30 volunteers, we show that such authentication is feasible both in terms of classification accuracy and computational load on smartglasses. We achieve a classification accuracy of up to 99% with only 75 training samples using behavioural biometric data from four different types of touch gestures. To show that our system can be generalized, we test its performance on touch data from smartphones and found the accuracy to be similar to smartglasses. Finally, our experiments on the permanence of gestures show that the negative impact of changing user behaviour with time on classification accuracy can be best alleviated by periodically replacing older training samples with new randomly chosen samples.

cs.CR↗

The Web for Under-Powered Mobile Devices: Lessons learned from Google Glass

This paper examines some of the potential challenges associated with enabling a seamless web experience on underpowered mobile devices such as Google Glass from the perspective of web content providers, device, and the network. We conducted experiments to study the impact of webpage complexity, individual web components and different application layer protocols while accessing webpages on the performance of Glass browser, by measuring webpage load time, temperature variation and power consumption and compare it to a smartphone. Our findings suggest that (a) performance of Glass compared to a smartphone in terms of power consumption and webpage load time deteriorates with increasing webpage complexity (b) execution time for popular JavaScript benchmarks is about 3-8 times higher on Glass compared to a smartphone, (c) WebP is more energy efficient image format than JPEG and PNG, and (d) seven out of 50 websites studied are optimized for content delivery to Glass.

cs.HC↗