arXiv subjects

Jameson Graef Rollins

Publications and source records attributed to Jameson Graef Rollins.

4 recordsLinked to original sources

arXiv2026

DC response of an interferometer topology with an L-shaped cavity: a tabletop study

A new interferometer topology for kilohertz gravitational-wave detection was recently proposed in [Zhang et al. Phys. Rev. X 13, 021019 (2023)]. The design is based on an L-shaped optical cavity pumped through a Sagnac-like vortex. We report a tabletop experiment that characterizes the interferometer's optical response near DC. When the laser frequency is locked to the resonance of the L-shaped cavity, we observe that the cavity input coupler becomes effectively transparent, yielding a simple Michelson-like response. Moreover, the Sagnac vortex separates into upper and lower paths, which behave as two independent pumping paths driving the cavity. These observations are in agreement with theoretical predictions. Our results provide an intuitive physical picture of this interferometer topology and offer insight into its lock acquisition strategy.

physics.ins-det↗

arXiv2021

Gravitational-wave physics with Cosmic Explorer: limits to low-frequency sensitivity

Cosmic Explorer (CE) is a next-generation ground-based gravitational-wave observatory concept, envisioned to begin operation in the 2030s, and expected to be capable of observing binary neutron star and black hole mergers back to the time of the first stars. Cosmic Explorer's sensitive band will extend below 10 Hz, where the design is predominantly limited by geophysical, thermal, and quantum noises. In this work, thermal, seismic, gravity-gradient, quantum, residual gas, scattered-light, and servo-control noises are analyzed in order to motivate facility and vacuum system design requirements, potential test mass suspensions, Newtonian noise reduction strategies, improved inertial sensors, and cryogenic control requirements. Our analysis shows that with improved technologies, Cosmic Explorer can deliver a strain sensitivity better than $10^{-23}/\mathrm{Hz}^{1/2}$ down to 5 Hz. Our work refines and extends previous analysis of the Cosmic Explorer concept and outlines the key research areas needed to make this observatory a reality.

gr-qc↗

arXiv2020

Tuning Advanced LIGO to kilohertz signals from neutron-star collisions

Gravitational waves produced at kilohertz frequencies in the aftermath of a neutron star collision can shed light on the behavior of matter at extreme temperatures and densities that are inaccessible to laboratory experiments. Gravitational-wave interferometers are limited by quantum noise at these frequencies but can be tuned via their optical configuration to maximize the probability of post-merger signal detection. We compare two such tuning strategies to turn Advanced LIGO into a post-merger-focused instrument: first, a wideband tuning that enhances the instrument's signal-to-noise ratio 40--80\% broadly above \SI{1}{\kHz} relative to the baseline, with a modest sensitivity penalty at lower frequencies; second, a "detuned" configuration that provides even more enhancement than the wideband tuning, but over only a narrow frequency band and at the expense of substantially worse quantum noise performance elsewhere. With an optimistic accounting for instrument loss and uncertainty in post-merger parameters, the detuned instrument has a ${\lesssim}40\%$ sensitivity improvement compared to the wideband instrument.

astro-ph.IM↗

arXiv2016

Distributed State Machine Supervision for Long-baseline Gravitational-wave Detectors

The Laser Interferometer Gravitational-wave Observatory (LIGO) consists of two identical yet independent, widely-separated, long-baseline gravitational-wave detectors. Each Advanced LIGO detector consists of complex optical-mechanical systems isolated from the ground by multiple layers of active seismic isolation, all controlled by hundreds of fast, digital, feedback control systems. This article describes a novel state machine-based automation platform developed to handle the automation and supervisory control challenges of these detectors. The platform, called \textit{Guardian}, consists of distributed, independent, state machine automaton nodes organized hierarchically for full detector control. User code is written in standard Python and the platform is designed to facilitate the fast-paced development process associated with commissioning the complicated Advanced LIGO instruments. While developed specifically for the Advanced LIGO detectors, Guardian is a generic state machine automation platform that is useful for experimental control at all levels, from simple table-top setups to large-scale multi-million dollar facilities.

astro-ph.IM↗