arXiv subjects

Jan Timmermans

Publications and source records attributed to Jan Timmermans.

8 recordsLinked to original sources

arXiv2025

Data Preservation in High Energy Physics

Data preservation significantly increases the scientific output of high-energy physics experiments during and after data acquisition. For new and ongoing experiments, the careful consideration of long-term data preservation in the experimental design contributes to improving computational efficiency and strengthening the scientific activity in HEP through Open Science methodologies. This contribution is based on 15 years of experience of the DPHEP collaboration in the field of data preservation and focuses on aspects relevant for the strategic programming of particle physics in Europe: the preparation of future programs using data sets preserved from previous similar experiments (e.g. HERA for EIC), and the use of LHC data long after the end of the data taking. The lessons learned from past collider experiments and recent developments open the way to a number of recommendations for the full exploitation of the investments made in large HEP experiments.

hep-ex↗

arXiv2022

Double-hit separation and dE/dx resolution of a time projection chamber with GEM readout

A time projection chamber (TPC) with micropattern gaseous detector (MPGD) readout is investigated as main tracking device of the International Large Detector (ILD) concept at the planned International Linear Collider (ILC). A prototype TPC equipped with a triple gas electron multiplier (GEM) readout has been built and operated in an electron test beam. The TPC was placed in a 1 T solenoidal field at the DESY II Test Beam Facility, which provides an electron beam up to 6 GeV/c. The performance of the readout modules, in particular the spatial point resolution, is determined and compared to earlier tests. New studies are presented with first results on the separation of close-by tracks and the capability of the system to measure the specific energy loss dE/dx. This is complemented by a simulation study on the optimization of the readout granularity to improve particle identification by dE/dx.

physics.ins-det↗

arXiv2022

MPGDs for TPCs at future lepton colliders

This submission will focus on advancements and advantages of Micro Pattern Gas Detector (MPGD) technologies and their applications to the construction of a dedicated Time Projection Chamber (TPC) that can serve as an excellent main tracker for any multipurpose detector that can be foreseen to operate at a future lepton collider. The first portion of the report will be the executive summary. It will be followed by sections detailing the applications of MPGDs specifically to the construction of the LCTPC for the ILD at ILC, for a possible upgrade of the Belle II detector at SuperKEKB and for the design of a TPC for a detector at CEPC. MPGD technologies offer synergies with other detector R&D and several application domains; a few examples will be provided in the context of the ongoing Snowmass long range planning exercise in the USA. Links to industrial partnership and work with institutions in the USA will be highlighted when appropriate.

physics.ins-det↗

arXiv2020

Performance of the GridPix detector quad

A gaseous pixel readout module with four GridPix chips, called the quad, has been developed as a building block for a large time projection chamber readout plane. The quad module has dimensions 39.6 mm $\times$ 28.38 mm and an active surface coverage of 68.9%. The GridPix chip consists of a Timepix3 chip with integrated amplification grid and have a high efficiency to detect single ionisation electrons, which enable to make a precise track position measurement. A quad module was installed in a small time projection chamber and measurements of 2.5 GeV electrons were performed at the ELSA accelerator in Bonn, where a silicon telescope was used to provide a reference track. The error on the track position measurement, both in the pixel plane and drift direction, is dominated by diffusion. The quad was designed to have minimum electrical field inhomogeneities and distortions, achieving systematics of better than 13 $μ$m in the pixel plane. The resolution of the setup is 41 $μ$m, where the total systematic error of the quad detector is 24 $μ$m.

physics.ins-det↗

arXiv2016

A Time Projection Chamber with GEM-Based Readout

For the International Large Detector concept at the planned International Linear Collider, the use of time projection chambers (TPC) with micro-pattern gas detector readout as the main tracking detector is investigated. In this paper, results from a prototype TPC, placed in a 1 T solenoidal field and read out with three independent GEM-based readout modules, are reported. The TPC was exposed to a 6 GeV electron beam at the DESY II synchrotron. The efficiency for reconstructing hits, the measurement of the drift velocity, the space point resolution and the control of field inhomogeneities are presented.

physics.ins-det↗

arXiv2012

Beam Test with a GridGEM TPC Prototype Module

The International Large Detector (ILD) --a detector concept for the International Linear Collider (ILC)-- foresees a Time Projection Chamber (TPC) as its main tracking detector. Currently, the R&D efforts for such a TPC focus on studies using a large prototype that can accommodate up to seven read-out modules which are comparable to the ones that would be used in the final ILD TPC. The DESY TPC group has developed such a module using GEMs for the gas amplification, which are mounted on thin ceramic frames. The module design and first results of a test beam campaign are presented.

physics.ins-det↗

arXiv2010

An integrated Micromegas UV-photon detector

Preliminary results of a photon detector combining a Micromegas like multiplier coated with a UV-sensitive CsI photocathode are described. The multiplier is made in a CMOS compatible InGrid technology, which allows to post-process it directly on the surface of an imaging IC. This method is aimed at building light-sensitive imaging detectors where all elements are monolithically integrated. We show that the CsI photocathode deposited in the InGrid mesh does not alter the device performance. Maximum gains of ~6000 were reached in a single-grid element operated in Ar/CH4, with a 2% Ion Back Flow fraction returning to the photocathode.

physics.ins-det↗

arXiv2009

Data Preservation at LEP

The four LEP experiments ALEPH, DELPHI, L3 and OPAL successfully recorded e+e- collision data during the years 1989 to 2000. As part of the ordinary evolution in High Energy Physics, these experiments can not be repeated and their data is therefore unique. This article briefly reviews the data preservation efforts undertaken by the four experiments beyond the end of data taking. The current status of the preserved data and associated tools is summarised.

hep-ex↗