arXiv subjects

Jason Valentine

Publications and source records attributed to Jason Valentine.

12 recordsLinked to original sources

arXiv2022

Nanoscale optical nonreciprocity with nonlinear metasurfaces

Optical nonreciprocity is manifested as a difference in the transmission of light for the opposite directions of excitation. Nonreciprocal optics is traditionally realized with relatively bulky components such as optical isolators based on the Faraday rotation, hindering the miniaturization and integration of optical systems. Here we demonstrate free-space nonreciprocal transmission through a metasurface comprised of a two-dimensional array of nanoresonators made of silicon hybridized with vanadium dioxide (VO2). This effect arises from the magneto-electric coupling between Mie modes supported by the resonator. Nonreciprocal response of the nanoresonators occurs without the need for external bias; instead, reciprocity is broken by the incident light triggering the VO2 phase transition for only one direction of incidence. Nonreciprocal transmission is broadband covering over 100 nm in the telecommunication range in the vicinity of {\lambda}=1.5 um. Each nanoresonator unit cell occupies only about 0.1 {\lambda}^3 in volume, with the metasurface thickness measuring about half-a-micron. Our self-biased nanoresonators exhibit nonreciprocity down to very low levels of intensity on the order of 150 W/cm^2 or a uW per nanoresonator. We estimate picosecond-scale transmission fall times and sub-microsecond scale transmission rise. Our demonstration brings low-power, broadband and bias-free optical nonreciprocity to the nanoscale.

physics.optics↗

arXiv2022

Meta-optic Accelerators for Object Classifiers

Rapid advances in deep learning have led to paradigm shifts in a number of fields, from medical image analysis to autonomous systems. These advances, however, have resulted in digital neural networks with large computational requirements, resulting in high energy consumption and limitations in real-time decision making when computation resources are limited. Here, we demonstrate a meta-optic based neural network accelerator that can off-load computationally expensive convolution operations into high-speed and low-power optics. In this architecture, metasurfaces enable both spatial multiplexing and additional information channels, such as polarization, in object classification. End-to-end design is used to co-optimize the optical and digital systems resulting in a robust classifier that achieves 95% accurate classification of handwriting digits and 94% accuracy in classifying both the digit and its polarization state. This approach could enable compact, high-speed, and low-power image and information processing systems for a wide range of applications in machine-vision and artificial intelligence.

physics.optics↗

arXiv2021

Incoherent Optoelectronic Differentiation with Optimized Multilayer Films

Fourier-based optical computing operations, such as spatial differentiation, have recently been realized in compact form factors using flat optics. Experimental demonstrations, however, have been limited to coherent light requiring laser illumination and leading to speckle noise and unwanted interference fringes. Here, we demonstrate the use of optimized multilayer films, combined with dual color image subtraction, to realize differentiation with unpolarized incoherent light. Global optimization is achieved by employing neural networks combined with the reconciled level set method to optimize the optical transfer functions of multilayer films at wavelengths of 532 nm and 633 nm. Spatial differentiation is then achieved by subtracting the normalized incoherent images at these two wavelengths. The optimized multilayer films are experimentally demonstrated to achieve incoherent differentiation with a numerical aperture up to 0.8 and a resolution of 6.2 {\mu}m. The use of multilayer films allows for lithography-free fabrication and is easily combined with existing imaging systems opening the door to applications in microscopy, machine vision and other image processing applications.

physics.optics↗

arXiv2021

All-Dielectric Meta-optics for High-Efficiency Independent Amplitude and Phase Manipulation

Metasurfaces, composed of subwavelength scattering elements, have demonstrated remarkable control over the transmitted amplitude, phase, and polarization of light. However, manipulating the amplitude upon transmission has required loss if a single metasurface is used. Here, we describe high-efficiency independent manipulation of the amplitude and phase of a beam using two lossless phase-only metasurfaces separated by a distance. With this configuration, we experimentally demonstrate optical components such as combined beam-forming and splitting devices, as well as those for forming complex-valued, three-dimensional holograms. The compound meta-optic platform provides a promising approach for achieving high performance optical holographic displays and compact optical components, while exhibiting a high overall efficiency.

physics.optics↗

arXiv2019

Image Processing Based on Compound Flat Optics

Image processing has become a critical technology in a variety of science and engineering disciplines. While most image processing is performed digitally, optical analog processing has the advantages of being low-power and high-speed though it requires a large volume. Here, we demonstrate optical analog imaging processing using a flat optic for direct image differentiation allowing one to significantly shrink the required optical system size. We first demonstrate how the image differentiator can be combined with traditional imaging systems such as a commercial optical microscope and camera sensor for edge detection. Second, we demonstrate how the entire analog processing system can be realized as a monolithic compound flat optic by integrating the differentiator with a metalens. The compound nanophotonic system manifests the advantage of thin form factor optics as well as the ability to implement complex transfer functions and could open new opportunities in applications such as biological imaging and machine vision.

physics.optics↗

arXiv2016

Metasurface polarization splitter

Polarization beam splitters, devices that separate the two orthogonal polarizations of light into different propagation directions, are one of the most ubiquitous optical elements. However, traditionally polarization splitters rely on bulky optical materials, while emerging optoelectronic and photonic circuits require compact, chip-scale polarization splitters. Here we show that a subwavelength rectangular lattice of cylindrical silicon Mie resonators functions as a polarization splitter, efficiently reflecting one polarization while transmitting the other. We show that the polarization splitting arises from the anisotropic permittivity and permeability of the metasurface due to the two-fold rotational symmetry of the rectangular unit cell. The high polarization efficiency, low loss, and low profile make these metasurface polarization splitters ideally suited for monolithic integration with optoelectronic and photonic circuits.

physics.optics↗

arXiv2016

Localization of Temperature Using Plasmonic Hot Spots in Metal Nanostructures: The Nano-Optical Antenna Approach and Fano Effect

It is challenging to strongly localize temperature in small volumes because heat transfer is a diffusive process. Here we show how to overcome this limitation using electrodynamic hot spots and interference effects in the regime of continuous-wave (CW) excitation. We introduce a set of figures of merit for the localization of temperature and for the efficiency of the plasmonic photo-thermal effect. Our calculations show that the temperature localization in a trimer nanoparticle assembly is a complex function of the geometry and sizes. Large nanoparticles in the trimer play the role of the nano-optical antenna whereas the small nanoparticle in the plasmonic hot spot acts as a nano-heater. Under the peculiar conditions, the temperature increase inside a nanoparticle trimer can be localized in a hot spot region at the small heater nanoparticle and, in this way, a thermal hot spot can be realized. However, the overall power efficiency of temperature generation in this trimer is much smaller than that of a single nanoparticle. We can overcome the latter disadvantage by using a trimer with a nanorod. In the trimer assembly composed of a nanorod and two spherical nanoparticles, we observe a strong plasmonic Fano effect that leads to the concertation of optical energy dissipation in the small heater nanorod. Therefore, the power-absorption efficiency of temperature generation in the nanorod-based assembly greatly increases due to the strong plasmonic Fano effect. The Fano heater incorporating a small nanorod in the hot spot has obviously the best performance compared to both single nanocrystals and a nanoparticle trimer. The principles of heat localization described here can be potentially used for thermal photo-catalysis, energy conversion and bio-related applications.

cond-mat.mes-hall↗

arXiv2014

High Quality Factor Fano-Resonant All-Dielectric Metamaterials

Metasurface analogues of electromagnetically induced transparency (EIT) have been a major focus of the nanophotonics field over the past several years due their ability to produce high quality factor (Q-factor) resonances for applications such as low-loss slow light devices and highly sensitive optical sensors. However, Ohmic loss limits the achievable Q-factors in conventional plasmonic EIT metasurfaces to values less than 10, significantly hampering device performance. Here, we report experimental demonstration of a classical analogue of EIT using all-dielectric silicon-based metasurfaces. Due to extremely low absorption loss and coherent interaction of neighboring meta-atoms, a record-high Q-factor of 483 is experimentally observed, leading to a refractive index sensor with a figure-of-merit (FOM) of 103. Furthermore, we show that the dielectric metasurfaces can be engineered to confine the optical field in either the silicon resonator or the environment, allowing one to tailor light-matter interaction at the nanoscale.

physics.optics↗

arXiv2013

Realization of an all-dielectric zero-index optical metamaterial

Metamaterials offer unprecedented flexibility for manipulating the optical properties of matter, including the ability to access negative index, ultra-high index and chiral optical properties. Recently, metamaterials with near-zero refractive index have drawn much attention. Light inside such materials experiences no spatial phase change and extremely large phase velocity, properties that can be applied for realizing directional emission, tunneling waveguides, large area single mode devices, and electromagnetic cloaks. However, at optical frequencies previously demonstrated zero- or negative-refractive index metamaterials require the use of metallic inclusions, leading to large ohmic loss, a serious impediment to device applications. Here, we experimentally demonstrate an impedance matched zero-index metamaterial at optical frequencies based on purely dielectric constituents. Formed from stacked silicon rod unit cells, the metamaterial possesses a nearly isotropic low-index response leading to angular selectivity of transmission and directive emission from quantum dots placed within the material.

physics.optics↗

arXiv2011

A Carpet Cloak Device for Visible Light

We report an invisibility carpet cloak device, which is capable of making an object undetectable by visible light. The cloak is designed using quasi conformal mapping and is fabricated in a silicon nitride waveguide on a specially developed nano-porous silicon oxide substrate with a very low refractive index. The spatial index variation is realized by etching holes of various sizes in the nitride layer at deep subwavelength scale creating a local effective medium index. The fabricated device demonstrates wideband invisibility throughout the visible spectrum with low loss. This silicon nitride on low index substrate can also be a general scheme for implementation of transformation optical devices at visible frequency.

physics.optics↗

arXiv2011

Plasmonic Luneburg and Eaton Lenses

Plasmonics is an interdisciplinary field focusing on the unique properties of both localized and propagating surface plasmon polaritons (SPPs) - quasiparticles in which photons are coupled to the quasi-free electrons of metals. In particular, it allows for confining light in dimensions smaller than the wavelength of photons in free space, and makes it possible to match the different length scales associated with photonics and electronics in a single nanoscale device. Broad applications of plasmonics have been realized including biological sensing, sub-diffraction-limit imaging, focusing and lithography, and nano optical circuitry. Plasmonics-based optical elements such as waveguides, lenses, beam splitters and reflectors have been implemented by structuring metal surfaces or placing dielectric structures on metals, aiming to manipulate the two-dimensional surface plasmon waves. However, the abrupt discontinuities in the material properties or geometries of these elements lead to increased scattering of SPPs, which significantly reduces the efficiency of these components. Transformation optics provides an unprecedented approach to route light at will by spatially varying the optical properties of a material. Here, motivated by this approach, we use grey-scale lithography to adiabatically tailor the topology of a dielectric layer adjacent to a metal surface to demonstrate a plasmonic Luneburg lens that can focus SPPs. We also realize a plasmonic Eaton lens that can bend SPPs. Since the optical properties are changed gradually rather than abruptly in these lenses, losses due to scattering can be significantly reduced in comparison with previously reported plasmonic elements.

physics.optics↗

arXiv2009

Dielectric Optical Cloak

Invisibility or cloaking has captured human's imagination for many years. With the recent advancement of metamaterials, several theoretical proposals show cloaking of objects is possible, however, so far there is a lack of an experimental demonstration at optical frequencies. Here, we report the first experimental realization of a dielectric optical cloak. The cloak is designed using quasi-conformal mapping to conceal an object that is placed under a curved reflecting surface which imitates the reflection of a flat surface. Our cloak consists only of isotropic dielectric materials which enables broadband and low-loss invisibility at a wavelength range of 1400-1800 nm.

physics.optics↗