Searcharxiv⌕ Search

arXiv subjects

Jay C. LeFebvre

Publications and source records attributed to Jay C. LeFebvre.

4 recordsLinked to original sources

High Characteristic Voltage YBCO Josephson Junctions Written With a Focused Helium Ion Beam

We report in-plane Josephson junctions written directly into YBa$_2$Cu$_3$O$_{7-δ}$ (YBCO) thin films with a focused helium ion beam (He FIB). The characteristic voltage $I_{\mathrm{C}}R$ of these junctions, where $I_{\mathrm{C}}$ is the Josephson critical current and $R$ is the junction resistance, sets the operating frequency and the sensitivity of the circuits built from them. A single line irradiation with a dose of \SI{500}{ions/nm} across a \SI{4}{\micro\metre} wide electrode produced a junction with $I_{\mathrm{C}}R$ of 929 \si{\micro\volt} at \SI{1.6}{K}, which is `higher than the 200 to 400 \si{\micro\volt} typical of junctions fabricated previously in our laboratory. Temperature dependent resistance, current-voltage characteristics, magnetic field modulation of the critical current, and Shapiro steps under 20.5~GHz microwave irradiation show Josephson behavior with an excess current below 5 percent of the critical current. The critical current falls steeply with temperature near the junction transition and saturates at low temperature. We attribute this behavior to a barrier at the metal insulator transition, where hopping conduction through localized states is active at finite temperature and freezes out on cooling. We describe the changes in surface preparation, sample selection, beam focusing, and sample storage that accompanied the improvement, although the present data do not separate their individual contributions. Larger characteristic voltages at these dimensions are an encouraging result for rapid single flux quantum and adiabatic quantum flux parametron logic and for superconducting quantum interference devices operating at elevated temperature.

cond-mat.supr-con↗

Local Suppression of Superconductivity in Niobium Films by Focused Silicon Ion Implantation

Magnetic flux trapped in a superconducting circuit shifts the critical currents of nearby Josephson junctions and disturbs the operation of the circuit. The usual remedy is a moat etched through the ground plane to hold the flux away from the logic. We report direct write silicon ion implantation with a focused ion beam as a way to make moats without etching the film, by locally suppressing superconductivity in niobium (Nb). Single implanted lines were written across Nb electrodes in films of three thicknesses over two orders of magnitude in ion fluence, and the transition temperature, resistance, and critical current density of each line were measured. The transition temperature of the line falls with fluence while the surrounding Nb is unchanged, and the critical current density falls by about two orders of magnitude before the line becomes resistive at 4.2 K. The product of the critical current and the resistance of the lines follows a single power law in reduced temperature. This gives an estimate of the critical current of a line at any temperature from its transition temperature and resistance. A time dependent Ginzburg-Landau simulation indicates that an implanted region can capture and hold a vortex. From these results we suggest a starting ion energy and fluence for implanted moats in a 100 nm Nb ground plane at 4.2 K and estimate the equivalent broad beam fluence.

cond-mat.supr-con↗

AC Response Across the Metal Insulator Transition of YBCO Josephson Junctions Fabricated with a Helium Ion Beam

Using focused helium ion beam (FHIB) irradiation, we fabricated in-plane, high-Tc YBCO Josephson junctions. By varying the dose of the irradiation, we tune the junction barriers from metallic (SNS) to insulating (SIS) and investigate how this transition affects microwave-driven dynamics. As the barrier transitions from metallic to insulating, the oscillatory response of the Shapiro steps to the RF power changes dramatically. On either side of the metal-insulator transition, the devices exhibit clean integer Shapiro steps without half-integer features, demonstrating that the current--phase relation is dominated by the first harmonic and that the excess current is minimal. The current-voltage response is well-described by the resistively, capacitively shunted junction model assuming a single-harmonic current--phase relation. This behavior indicates well-controlled junction properties suitable for a wide range of superconducting electronics, including detectors, mixers, and high-density integrated circuits.

cond-mat.supr-con↗

High-Temperature Superconductor Quantum Flux Parametron for Energy-Efficient Logic

As we rapidly advance through the information age, the power consumed by computers, data centers, and networks grows exponentially. This has inspired a race to develop alternative low-power computational technologies. A new adiabatic configuration of a decades-old superconducting digital logic device has darted into the lead called quantum flux parametrons (QFP). QFP operate with dissipation so low that they seemingly violate the laws of thermodynamics. In just a short span of time, they have gone from simple single NOT gates to complex processors containing thousands of gates. They are fabricated from elemental niobium superconductors cooled to just a few degrees above absolute zero. However, their efficiency is so great that for large high-performance computers with several gates, the energy savings are immense. For smaller computational platforms QFPs from high-temperature superconductors (high-Tc) are highly desirable. In this work, we take the first steps towards this goal with the demonstration of a high-T C QFP shift register. Our device is fabricated using focused helium ion beam lithography where the material is modified with an ion beam at the nanoscale to directly pattern these circuits into a high-T C thin film. We validate the correct logical operation at 25 K, over 6 times higher than niobium devices with an estimated bit energy of 0.1 attoJoule at 10 GHz.

physics.app-ph↗